from

$1.24

SEAL RING – COPPER

from

$364.99

New Platinum Pro Radiator Fan Assembly, 323/325/328/330I/Xi/Ci

Product Features:

323/325/328/330I/Xi/Ci, Made Of Plastic
Meets All Federal Motor Safety Standards
No Drilling Needed For Installation
No Modifications Needed For Installation
Direct Fit Replacement For Your Vehicle
Same Form Fit And Function As OE
Check Out The Large Selection Of Parts Available For Your Vehicle

from

$29.99

The Engine Coolant Temperature Sensor determines the exact temperature of the engine coolant by sending an analog signal to the ECM to censure proper air/fuel ratio along with proper operation of the cooling fan(s) and temperature gauge. The Engine Coolant Temperature Sensor may be located on the cylinder head, engine block, thermostat housing or intake manifold. Reasons for replacement include: check engine light illumination, erratic or no temperature gauge operation, erratic or no cooling fan operation, and engine overheating.

Product Features:

OE MATCHED: Wires and probe length match OE. Mounting clip(s) included where applicable
FASTER RESPONSE TIME: Thermal conductive grease inside brass housing increases sensor response time
THE NTK DIFFERENCE: Thread sealant/o-ring installed where applicable. Thermistor placement within the housing matches OE to ensure proper output. Proper thermal conductive grease to provide accurate temperature transfer to the thermistor

from

$17.73

Screw

from

$25.60

Coolant Level Sensor

from

$305.84

A/C Condenser Fan As

from

$151.99

US Motor Works Professional Series Water Pump with Fan Clutch are designed to replace the mechanical components of a cooling system. A proper water pump replacement should include a new fan clutch as the two are connected to the same shaft and work together to move the air and cooling fluid. Replacing one without the other can damage the new part and cause repeat work or engine trouble. This matched set will allow your vehicle continued operation in the demanding environment of today’s engine. All components are brand new and QA inspected for perfect fit and function. Restore your cooling power by installing a US Motor Works Professional Series Water Pump with Fan Clutch.

Product Features:

Fan clutch mounts to the water pump and should be replaced at the same time.
Matched set for proper water pump or fan clutch replacement
Includes mounting hardware, gaskets and accessories as required.
Complete mechanical cooling parts replacement
Factory tested and 100% new product
Meets or exceeds OEM quality

from

$64.99

This engine coolant reservoir mounting plate is designed to match the fit and function of the original plate on specified applications, and is engineered for reliable performance and durability.

Product Features:

Direct replacement – this engine coolant reservoir mounting plate is designed to match the fit and function of the original plate on specified applications
Restores functionality – reliable replacement for an original part that has failed due to cracking, gasket failure or collision damage
Durable construction – this part is made from quality materials to ensure reliable performance and long service life
Trustworthy quality – backed by team of product experts in the United States and more than a century of automotive experience

from

$47.99

Carquest Hose Assemblies are designed to carry refrigerant in an air conditioning system. They are manufactured to meet or exceed original equipment specifications and are designed to easily fit into the engine compartment.

Product Features:

100% of hose assemblies use Goodyear hoses that meet original equipment specifications for wall thickness and permeation.
Tubes and mufflers are designed to meet original equipment specifications for wall thickness.
Fittings are designed to couple and seal to eliminate leaks. Trivalent plating is used on steel fittings to enhance corrosion resistance. The fittings conform to original equipment specifications to allow for the proper fit with related air conditioning
Welds and crimps meet and exceed original equipment tension specifications.
Manufactured to allow flexibility in the hose to conform to engine compartments.
O-Rings necessary for installation are included.

from

$169.15

Behr manufactures a direct fit Heater Core that guarantees OEM quality, fit and performance.

Product Features:

OEM Quality Direct fit Application
Meets or exceeds OEM specifications.
Utilizes the factory style mounts, connectors and fittings.
Provides exceptional reliability.

from

$261.04

Behr manufactures an OEM quality replacement Blower Motor that guarantees the same performance, fitment and durability as that of the original unit it replaces. Behr’s advanced blower design provides boosted airflow performance, are highly efficient, and quiet-running, which provides excellent acoustic comfort from the climate control system.

Product Features:

OEM Quality.
Direct Fit Replacement.
Highly efficient
Quiet-running
Meets or exceeds OE design and performance.

from

$34.47

ACM is a supplier of Original Equipment quality climate control products. Heater / Evaporator Temperature Sensor

from

$678.99

Climate controls stopped working? Seamlessly restore operation by easily swapping the malfunctioning original module with this fully tested replacement unit.

Product Features:

Direct replacement – this HVAC control module matches the appearance and function of the original unit on specific vehicles
Functionality-tested – module has been tested to ensure the same operation as the stock module
Simple installation – no advanced vehicle knowledge is required for proper installation and setup
Trustworthy quality – backed by team of engineers and inspectors in the United States

from

$29.54

A/C Pressure Switch

from

$56.99

Damaged your engine water pump pulley? This pulley is a direct replacement for the original manufacturer’s part on specific vehicle years, makes and models, restoring proper performance.

Product Features:

Direct replacement – this engine water pump pulley matches the fit and function of the original part on specific vehicles
Durable design – built to withstand the elements and road debris
Thoroughly tested – must pass strict standards to ensure reliable longevity
Trustworthy quality – backed by team of engineers and inspectors in United States

from

$85.99

The Premium CarQuest Vehicle Solutions line of vehicle electronics are designed for OE form, fit and function for both import and domestic vehicles. The A/C Pressure Sensor reports system pressures to the on-board computer, in turn allowing the computer to properly and efficiently control the compressor, fans and system levels. An improperly functioning A/C Pressure Sensor will provide erratic or inaccurate readings to on-board computers severely affecting system performance and function. Without reliable and accurate data from a properly functioning A/C Pressure Sensor, on-board computers are unable to protect the safety of critical components and the system as a whole which can lead to excessive wear and tear on critical components and costly system damage.

Product Features:

Designed and manufactured with high quality materials, industry leading electronic components and strict quality controls. Engineered to exceed OE performance and to meet the uncompromising demands of service professionals.
Direct fit replacement matches proper OE fit, form, and function and ensures trouble free installation of your A/C Pressure Sensor.
All units are helium leak tested on fully automated mass spectrometer equipment before end-of-line testing.
All units are tested using automated end-of-line testing equipment that pressurizes the A/C Pressure Sensor and checks full-spectrum functionality and electrical output to ensure each A/C Pressure Sensor meets manufacturing specifications before packaging

from

$45.99

Carquest Accumulators and Receiver Driers are designed to store, filter and dry the air conditioning refrigerant to provide proper performance and durability for the air conditioning system. They are manufactured to meet or exceed original equipment specifications.

Product Features:

All parts meet or exceed original equipment standards for moisture absorption, pressure and temperature resistance, air tightness, vibration resistance, corrosiveness, and pulse pressure.
Desiccant is 100% tested and assembled in a controlled environment to ensure performance meets or exceeds original equipment standards.
All accumulators and receiver driers are helium leak tested prior to packaging.
O-Rings necessary for installation are included.

from

$181.99

Application specific design

from

$34.68

The Original Equipment Engine Cooling Thermo-Fan Switch is an ideal high quality Original Equipment replacement that is manufactured to meet or exceed OE specifications for fit, form, and function.

Product Features:

Premium Original Equipment replacement
Provides performance and dependability
Manufactured to meet OE specifications

from

$156.99

Carquest Premium Blower Motors are engineered and tested to provide years of trouble free operation. Backed by over 50 years of mobile A/C experience, fix it once and fix it right with Carquest Premium Blower Motors. Meets or exceeds OE design. Magnetic size and properties compare or exceed OEM. Windings meet or exceed OEM Specifications. Motor RPM equivalent to or exceeds OEM motor.

Product Features:

Meets or exceeds OE design and performance
Magnetic size and properties compare or exceed OEM
Windings meet or exceed OEM specifications
Motor RPM equivalent to or exceeds OEM motor

from

$371.99

Carquest New Compressors are designed, manufactured and tested to meet or exceed strict original equipment specifications for superior quality and performance. Each new compressor is tested to provide durable life to the vehicle’s air conditioning system. All new compressor components are assembled using state of the art equipment and techniques to ensure smooth operation. Each part is equipped with a clutch and connector that matches the original equipment part and provides an exact replacement to your vehicle’s part. All compressors are supplied with the necessary gaskets and o-rings for installation.

Product Features:

Each new compressor design undergoes rigorous life cycle testing at high RPMs and pressures to ensure that they can withstand years in the harshest conditions.
New compressors are designed with utmost precision using 3D coordinate measuring machines to ensure a perfect fit.
The production process contains automated controls at every stage that alerts and halts production in case of an error, assuring that the finished product will always be flawless.
All new compressors must pass a helium leak test and pump up function test prior to packaging.
O-Rings and gaskets necessary for installation are included.
O-Rings and gaskets necessary for installation are included.

from

$12.29

With Victor Reinz gaskets, you can be sure you are getting sealing solutions that deliver OE quality gasket technology and engineering. That is because Victor Reinz is an original equipment supplier and the trusted choice of manufacturers the world over, offering broad coverage for foreign and domestic cars and trucks. In Victor Reinz gasket sets, you get the right combination of components needed for fast, long-lasting repairs.

Product Features:

Choosing Victor Reinz assures getting OE quality parts in gaskets sets that have the coverage, contents, packaging and electronic cataloging to best meet the needs of the aftermarket.

from

$5.69

Radiator Drain Plug

from

$7.56

Choosing from the comprehensive VIEROL product range means opting for outstanding quality. This is confirmed by the Q+ quality seal for parts in OEM quality MADE IN GERMANY. VIEROL AG is a leading automotive parts distributor located in Oldenburg, Germany. With the trademarks VAICO and VEMO are the service market leaders in more than 125 countries worldwide. As an internationally present automotive supplier, VIEROL AG specializes in electronic and electrical components for German and European vehicles. VIEROL AG quality brands VEMO and VAICO combine innovation and experience, technical expertise and practiced corporate values, commitment to precision and a passion for technology: the invisible, but unquestionable, optimal prerequisites for guaranteed product quality and globally recognized service. Choosing from the comprehensive VIEROL product range means opting for outstanding quality.

from

$49.99

CARQUEST premium engine management products provide the right products for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions.