Walker Resonator #47639
Verified Buyer - Submitted 12 years ago
Purchased Walker Resonator #47639 to replace "Exhaust Pipe B" on my 1991 Honda 3-dr Hatchback, Standard, 1.5l 4-cyl engine.
The Walker resonator is almost an exact copy of the original Honda part except for the location of the mounting brackets where the rubber hangers go; they are about 6-8" off. This presented a minor problem in aligning all the components during installation. So far, the resonator is performing its job without any exhaust leakage at the joints. However, I will be keeping a close eye on the rubber mounting hangers to see if the resonator might be slipping off the misplaced mounting brackets due to all the vibrations when driving.
I would recommend this part with reservations to a friend.
Bottom Line Yes, I would recommend to a friend
Poor fit
Verified Buyer - Submitted 12 years ago
A good price for the 1 piece but hold up to old assembly before install, and check of curve is ok. Once bolted it crowds to one side and forces muffler out of place. No evidence of shipping damage, but mine needed a much gentler curve to fit properly and it gets quite close to the gas tank.
Bottom Line No, I would not recommend to a friend