Easily separates hard-to-reach spot welded or bonded panels. Sharpened on three edges, the sharp end allows for penetration between the panels and both side edges allow for side impact to drive the panels apart without damage. 90 degrees end for use in hard-to-reach pinch weld areas. Made from a super tough alloy steel and has a cushioned handle that absorbs the shock . Will save the technician up to 15 minutes per panel replacement Right Angle Seam Buster has added a 90 angle along with a third sharpened edge to our popular Seam Buster which allows the body shop technician to gain easy access to the hard to reach pinch welds. The Right Angled Seam Buster with three sharpened edges is designed to allow bi-directional hammer use on quarter panels, rockers and any other pinch weld. The sharp end allows for penetration between the panels and the two lower edges allows for side impact to drive the panels apart. The chisel tip can be used for starting seam separation.