Steering Tie Rod End
Hover over the image to zoom in
Share this:

Driveworks Steering Tie Rod End

Part No. DW-EV351 Warranty Details  
Quantity  Add to Cart

See if this part fits a specific vehicle.

Check Vehicle Fit

Driveworks chassis parts help to eliminate front-end vibration, shimmy and unsafe handling. Driveworks chassis parts meet OE specifications, help ensure improved steering response and reduce tire wear.

Product Features:
  • Forged housing from specific materials provides strength and durability to prevent breakage
  • Coated technology provides a smooth and durable surface to prevent corrosion and rust
  • Premium Polychloroprene rubber boots are fitted with grease relief valves to prevent contamination
  • A slotted nut and cotter pin for a more secure installation
Back To Top
Hardware Included:Yes
Tie Rod End Bar Size:M15*1.5R mm

Do you have questions about this product?


Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.

2 Questions | 2 Answers
Displaying questions 1-2
  • Q:

    Frankly, the last question was a good one because I have the same one. I did not have a washer present on either side so I will not use it. However, I thought that the answer by the company representative seemed a little sarcastic. Perhaps you should keep in mind that we inexperienced "shade tree" mechanics purchasing your parts which pays your salary or hourly rate.
    Asked on 9/14/2014 by Motor

    1 answer



      I'm happy to help, Motor! I apologize if Vincent's response seems sarcastic, I am sure that was not his intention when responding to the question. I did some research on the vehicles that the Driveworks Steering Tie Rod End (Part No. DW-EV351) fits and did not see the washer mentioned in the repair procedures.

      I also looked at the competitors parts as well and did not see the washer included in their kits. I suggest following your repair manual's indications when replacing your inner tie rod end. If you have not already purchased one, it is Haynes Part No. 30021

      Answered on 9/17/2014 by Heath, ASE Parts Specialist from AAP
  • Q:

    which direction does the flat washer go it only fit on the end that screws into the rack there two little ears located at the center hole I am sure it must be keyed but I do not have any slots where they could go. maybe I dont use the washer?

    Asked on 8/30/2013 by Bill from Athens,Al

    1 answer



      With reference to your inquiry on the Driveworks Steering Tie Rod End - part# DW-EV351, the flat washer should be bent over the end of the inner tie rod end to prevent it coming loose. For any further assistance, please feel free to call us at: 1-877-238-2623 or visit the nearest Advance Auto Parts store and one of our Parts Pros will gladly assist you with any questions or concerns you may have.

      Answered on 8/30/2013 by Vincent from AAP
Displaying questions 1-2

Do you have a question about this product? 

Check out the specials in our monthly flyer.
Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.