from

$28.49

Specifically designed to perform under higher torque loads associated with engines having closely spaced bolt patterns (typically import vehicles). This product is blowout resistant, allowing leakproof gaskets to be made and put into service in just one minute. Sensor-safe, The Right Stuff GREY seals instantly, forming a reliable, long lasting elastomeric rubber gasket that outperforms pre-molded gaskets. Specified by major import OEMs, this material is resistant to powertrain fluids (oil, coolant and ATF) and operates in environments to 450°F (232°C) continuous; 500°F (260°C) intermittent.

Product Features:

Ideal for rigid cast aluminum parts
Meets OEM Specifications
Sensor safe & non-corrosive
Performs under higher torque loads associated with engines having closely spaced bolt patterns (typical of import vehicles)
Blowout resistant, allowing leakproof gaskets to be made in just one minute
Seals instantly, forming a reliable, long lasting elastomeric rubber gasket
Superior resistance to powertrain fluids including engine oil, transmission fluid, gear lube and coolants
Temperature range -60°C to 260°C (-75°F to 500°F) intermittent
Applications: Automotive, industrial and marine gaskets, valve covers, gearbox covers, pumps, compressors, oil pans, thermostat housings, water pumps, etc.

from

$39.13

Dorman’s Engine Coolant Recovery Tank is designed for enduring use. It resists the expansion and cracking that extreme temperature fluctuations can cause. Plus, the durable plastic construction prevents coolant fluid loss.

Product Features:

Comes with reservoir cap
Level sensor included (where applicable)
Direct replacement for a proper fit every time
Quality tested to ensure trouble-free installation and performance

from

$42.99

GM Genuine Parts A/C Clutch Cycle Switches are designed, engineered, and tested to rigorous standards, and are backed by General Motors. These A/C clutch cycle switches are component sensors that monitor the evaporator temperature and pressure. The switch turns the compressor clutch field coil off and on. When the pressure and temperature are too low, the compressor is switched off. GM Genuine Parts are the true OE parts installed during the production of or validated by General Motors for GM vehicles. Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE).

Product Features:

Restores A/C compressor clutch function
Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE)
GM Engineers design and validate OE parts specifically for your Chevrolet, Buick, GMC, or Cadillac vehicle
Original equipment parts are designed to work with your GM vehicle safety systems — aftermarket replacement parts may not meet the same OE safety regulations, depending on the part type
GM regularly updates production and service part designs to integrate new materials and technologies

from

$28.49

Carquest premium direct replacement resistors are designed to match the operation and performance of the original equipment to restore the proper heating and cooling functionality.

Product Features:

Restores Functionality- Manufactured to original equipment specifications to restore full HVAC operation
Original equipment quality – Carquest blower motor resistors meet the high quality material standards and tolerances as the original equipment
Complete kit – Each kit includes the resistor, connector, and splice connectors to complete the job
Direct replacement – Carquest blower motor resistor kits are a direct replacement to the original equipment resistor

from

$85.99

CARQUEST premium engine management products provide the right products for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions.

Product Features:

Premium quality materials for longer service life
Sealed connections (where applicable) to prevent environmental corrosion and performance issues
Global coverage for import and/or domestic applications
OE specified wire gauge to ensure a reliable electrical connection
Designed to meet or exceed OE specifications in form, fit and function

from

$19.99

Carquest premium engine management products provide the right products for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions.

from

$28.49

The Premium CarQuest Vehicle Solutions line of vehicle electronics are designed for OE form, fit and function for both import and domestic vehicles. The A/C Pressure Switch monitors system pressures, aiding in proper and efficient control of the compressor, fans and system levels. An improperly functioning A/C Pressure Switch will provide erratic or inaccurate actuation and operation, severely affecting system performance and function. Without reliable and accurate actuation from a properly functioning A/C Pressure Switch, critical components and the system as a whole are left unregulated and unprotected which can lead to excessive wear and tear on critical components and costly system damage.

Product Features:

Designed and manufactured with high quality materials, industry leading electronic components and strict quality controls. Engineered to meet or exceed OE performance and to meet the uncompromising demands of service professionals.
Direct fit replacement matches proper OE fit, form, and function and ensures trouble free installation of your A/C Pressure Switch.
All units are tested using advanced end-of-line equipment that pressurize the A/C Pressure Switch, confirm proper calibration and functionality, and check for leaks to ensure each A/C Pressure Switch meets manufacturing specifications before packaging.

from

$59.99

ACDelco GM Original Equipment Pigtail Connectors are connectors ready to be spliced into vehicle harnesses, and are GM-recommended replacements for your vehicle’s original components. These original equipment pigtail connectors have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.

Product Features:

Protective outer coverings help provide long-lasting durability
Color-coded wires allow for easy installation
GM-recommended replacement part for your GM vehicle’s original factory component
Offering the quality, reliability, and durability of GM OE
Manufactured to GM OE specification for fit, form, and function

from

$17.49

Kit includes thermostat, housing, and all necessary seals/gaskets to do the complete job. These individual parts are manufactured with OEM quality materials and safety standards by an OE Supplier. This thermostat and housing will meet and exceed the expectations of the OE thermostat to insure the best product for your cooling system. Stands up to even the most demanding automotive cooling systems. Manufactured with OEM specifications and processes. Copper case and wax compound assures rapid response to temperature changes in the coolant. Offset design, air relief valve, and OEM style seals included where applicable.

Product Features:

High grade stainless steel and copper construction
Meets or exceeds OEM standards
Consistent and precise response to cooling system needs
Original equipment design for worry-free direct fit replacement
100% tested and calibrated

from

$16.99

This engine coolant bleeder screw has been manufactured from durable material to prevent cooling system leaks. Matches the original screw for fit and function.

Product Features:

Ideal replacement – this engine coolant bleeder screw matches fit and function of the original equipment screw
Durable materials – designed to withstand high cooling system temperatures and pressures
Cost-effective solution – this bleeder screw offers original equipment quality at a competitive price
Quality tested – this part has undergone try-on and material testing to ensure a quality fit and long service life

from

$19.49

Carquest premium engine management products provide the right products for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions.

from

$14.29

Tester adapter for the MT-300 cooling system pressure testers. Professional grade test equipment to ensure an automotive cooling system is operating at the correct pressure. Made from high quality materials to ensure durability. Designed to test automotive coolant caps.

Product Features:

Machined metal construction
Works with MT-300 pressure tester
Tests coolant caps
Professional quality

from

$9.99

Carquest Premium Thermostats are manufactured with OEM quality materials and safety standards by an OE Supplier. This thermostat will meet and exceed the expectations of the OE thermostat to insure the best product for your cooling system. Stands up to even the most demanding automotive cooling systems. Manufactured with OEM specifications and processes. Copper case and wax compound assures rapid response to temperature changes in the coolant. Offset design, air relief valve, and OEM style seals included where applicable.

Product Features:

High grade stainless steel and copper construction
Meets or exceeds OEM standards
Consistent and precise response to cooling system needs
Original equipment design for worry-free direct fit replacement
100% tested and calibrated

from

$8.99

GM Genuine Parts Wiring Relays are designed, engineered, and tested to rigorous standards, and are backed by General Motors. These relays help connect or disconnect power to a vehicle accessory when it receives a low voltage signal from a switch. GM Genuine Parts are the true OE parts installed during the production of or validated by General Motors for GM vehicles. Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE).

Product Features:

Helps connect or disconnect power to vehicle accessories
Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE)
GM Genuine Parts are designed, engineered and tested to rigorous standards, and are backed by General Motors
GM Engineers design and validate OE parts specifically for your Chevrolet, Buick, GMC, or Cadillac vehicle
GM regularly updates production and service part designs to integrate new materials and technologies

from

$47.49

Product Features:

Designed, tested, and built by application
OE performance, fit, and appearance
Precision machined
Out of box installation

from

$34.99

This A/C compressor clutch connector is designed to match the appearance and function of the original hardware on specified applications. Made of quality materials, it is engineered for reliable performance and durability.

Product Features:

Direct replacement – this A/C compressor clutch connector matches the appearance and function of the factory hardware on specified applications
Ideal solution – this connector is a reliable replacement for an original part that is missing or has failed due to fatigue
Durable construction – this part is made from quality materials to ensure reliable performance and long service life
Trustworthy quality – backed by team of product experts in the United States and more than a century of automotive experience

from

$26.31

ACDelco GM Original Equipment Engine Coolant Water Outlets are housings that connect the radiator hoses to the engine, typically housing the engine coolant thermostat. For certain applications, the water outlet contains threaded holes or ports for sensors and switches. These original equipment engine coolant water outlets are GM-recommended replacements for your vehicle’s original components and have been manufactured to fit your specific GM vehicle, providing the same performance, durability, and service life you expect from General Motors.

Product Features:

GM-recommended replacement part for your GM vehicle’s original factory component
Offering the quality, reliability, and durability of GM OE
Manufactured to GM OE specification for fit, form, and function

from

$67.99

GM Genuine Parts A/C Compressor Relief Valves are designed, engineered, and tested to rigorous standards, and are backed by General Motors. GM Genuine Parts are the true OE parts installed during the production of or validated by General Motors for GM vehicles. Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE).

Product Features:

Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE)
GM Engineers design and validate OE parts specifically for your Chevrolet, Buick, GMC, or Cadillac vehicle
Original equipment parts are designed to work with your GM vehicle safety systems — aftermarket replacement parts may not meet the same OE safety regulations, depending on the part type
GM regularly updates production and service part designs to integrate new materials and technologies

from

$7.49

Fel-Pro gaskets offer 100% vehicle sealing with application-specific materials to give you sealing solutions with the performance and durability professionals trust

Product Features:

Meets or exceeds all original equipment specifications
Application specific design
Manufactured for the sealing repair environment
Validated for fit, form, and function
Quality that you can trust

from

$111.99

High quality OE replacement part with all components needed to complete the job

Product Features:

All mounting hardware included
All pulleys and hubs are machined and trued to ensure an even surface
Twelve point hub weld
Coated to prevent corrosion

from

$15.99

High quality OE replacement part with all components needed to complete the job

Product Features:

All the seals needed to complete the job
Compatible with both R12 and R134a refrigerants
Application specific
SUV and rear air applications

from

$1.99

Made from HNBR material; Compatible with R12 And R134A; High quality construction; Universal applications

from

$17.99

CARQUEST premium engine management products provide the right products for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions.

Product Features:

Premium quality materials for longer service life
Sealed connections (where applicable) to prevent environmental corrosion and performance issues
Global coverage for import and/or domestic applications
OE specified wire gauge to ensure a reliable electrical connection
Designed to meet or exceed OE specifications in form, fit and function

from

$17.49

We are proud to offer this CARQUEST product line: CARQUEST Water Outlets. Our products are engineered and tested to provide years of trouble free operation and designed to be hassle free OE replacement part that meets and/or exceeds OE standards. Backed by over 50 years of mobile temperature control experience, fix it once and fix it right with CARQUST Water Outlets and Thermostat Housings.

Product Features:

Meets and/or exceeds OEM standard
Includes quality gasket or O-ring to ensure proper seal (where applicable)
100% leak tested
Direct-fit replacement for ease of installation

from

$55.99

Replace your damaged cooling fan blade with this direct replacement. This vehicle-specific application is engineered for a perfect fit and is made from quality materials to ensure durability and restore proper cooling system operation.

Product Features:

Direct replacement – this engine cooling fan blade fits and functions like the original equipment fan blade
Quality construction – manufactured from premium materials for a long service life
Excellent value – original equipment quality at a lower price
Quality tested – has undergone testing to ensure proper fit and performance

from

$17.79

CARQUEST premium engine management products provide the right products for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions.

Product Features:

Premium quality materials for longer service life
Sealed connections (where applicable) to prevent environmental corrosion and performance issues
Global coverage for import and/or domestic applications
OE specified wire gauge to ensure a reliable electrical connection
Designed to meet or exceed OE specifications in form, fit and function

from

$17.29

High-quality products that meet OE appearance and performance to provide professional technicians and DIYers with a cost-effective solution.

Product Features:

High-quality products that meet OE appearance and performance to

from

$59.99

Carquest Hose Assemblies are designed to carry refrigerant in an air conditioning system. They are manufactured to meet or exceed original equipment specifications and are designed to easily fit into the engine compartment.

Product Features:

100% of hose assemblies use Goodyear hoses that meet original equipment specifications for wall thickness and permeation.
Tubes and mufflers are designed to meet original equipment specifications for wall thickness.
Fittings are designed to couple and seal to eliminate leaks. Trivalent plating is used on steel fittings to enhance corrosion resistance. The fittings conform to original equipment specifications to allow for the proper fit with related air conditioning
Welds and crimps meet and exceed original equipment tension specifications.
Manufactured to allow flexibility in the hose to conform to engine compartments.
O-Rings necessary for installation are included.