Bricklin SV-1 Performance and Racing Products
Top Bricklin SV-1 Performance and Racing Products Categories
We carry over 19 Performance and Racing Products in inventory for the Bricklin SV-1. If you’re looking for aftermarket Performance and Racing Products for your Bricklin SV-1, check out all these categories:
Essential Bricklin SV-1 Performance and Racing Products
Edelbrock – Performer Carburetor #9906 600 CFM With Electric Choke, Satin Finish (Non-EGR) (Part No.9906)
from
$397.99
Burnished aluminum. GM/MAC- style throttle linkage. Electric choke installed from factory. Easy tuning with 2 piece design. Smooth secondary transition. Both timed for full vacuum ports. Includes PCV outlet.
See More
Edelbrock – CARBURETOR (Part No.1812)
from
$443.99
New qwik-tune adjustable secondary air valve. Optional single or dual fuel inlet. Distinctive black accented hardware. No gaskets below fuel level to prevent leakage. Metering rod and step up springs can be changed easily. GM and AMC style throttle linkag
Product Features:
See More
Product Features:
- New Qwik-Tune Adjustable Secondary Air Valve
- Optional Single Or Dual Fuel Inlet
- Distinctive Black Accented Hardware
- No Gaskets Below Fuel Level to Prevent Leakage
- Metering Rod/Step Up Springs Can Be Changed Easily
- GM/AMC-Style Throttle Linkage
- Exclusive 12 Month Complete Satisfaction Warranty
Edelbrock – Performer-Plus camshaft for Small-Block Ford 351W V-8 applications (Part No.2182)
from
$339.99Product Features:
- Designed for Optimum Torque and Acceleration
- Maximum Performance From Idle through Mid-Range
- Matched to Edelbrock Performer Intakes
- Includes Hydraulic Lifters and Assembly Lube
- Major Improvement in Throttle Response and Torque
- Use For Daily Drivers/Trucks/Vans/RVs/4x4s
- Take The Guesswork Out Of Camshaft Selection
FEL-PRO Performance – Lower Intake Manifold Gasket Set: 7 Piece Set (Part No.1240)
from
$39.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Fel-Pro performance intake manifold gaskets have been tested with virtually all aftermarket cylinder head and intake manifold combinations.
- Performance intake manifold gaskets designed without a metal core, to allow engine builders to trim the gasket for exact fit on modified ports.
- 1970-82; w/2 Bbl. Cylinder heads
- Printoseal elastomeric sealing beads to provide extra sealing strength around the intake port.
- Not intended for use in emission controlled vehicles.
Mr. Gasket – Enhancement Products (Part No.8830)
from
$70.99
Replace your stock black engine pulleys with a pair of chrome plated steel pulleys from Mr. Gasket. The pulleys are highly polished then chrome plated for lasting beauty.
Product Features:
See More
Product Features:
- Highly polished for lasting beauty
Edelbrock – Performer 351-W Intake Manifold for S/B Ford 351 Windsor, Black Finish (Part No.21813)
from
$597.99
Edelbrock part #21813 Performer 351W intake manifold is designed for street 351 c.i.d. Ford Windsor V8’s. Will not fit Boss 351. Aftermarket 4-bbl carbs are not compatible with Ford Auto Overdrive Transmission (AOD) unless used with Lokar bracket SRK-4000
Product Features:
See More
Product Features:
- Idle-5500 RPM Range
- Dual Plane Type-4150 Style Flange
- 3.4 in. Front Height, 4.07 in. Center Height, 4.75 in. Rear Height
- Black Powder Coated Finish
- Made In The USA
Edelbrock – RPM Air-Gap Small Block Ford Polished Intake Manifold (Part No.75811)
from
$772.99
Based on performer RPM-series with unique air gap. Air gap cooler and denser mixture for more power. Designed for 1500 to 6500 RPM. Improve performance on the street or race track. Larger cross-sectional area and taller card flange. Compatibility with lar
Product Features:
See More
Product Features:
- Based on Performer RPM-Series with Unique Air Gap
- Air Gap Cooler and Denser Mixture for More Power
- Designed For 1500 To 6500 RPM
- Designed For Street And High Performance
- Larger Cross Sectional Area
- Taller Carb Flange
- Compatibility w/Large Displacement 351W Based Eng.
Edelbrock – RPM Air-Gap Small Block Ford 351W Intake Manifold (Part No.7581)
from
$468.99
Based on performer RPM-series with unique air gap. Air gap cooler and denser mixture for more power. Designed for 1500 to 6500 RPM. Improve performance on the street or race track. Larger cross-sectional area and taller card flange. Compatibility with large displacement 351W based engines. For 4 bbl carbs. Available in cast, polished and endurashine finish.
Product Features:
See More
Product Features:
- Based on Performer RPM-Series with Unique Air Gap
- Air Gap Cooler and Denser Mixture for More Power
- Designed For 1500 To 6500 RPM
- Designed For Street And High Performance
- Larger Cross Sectional Area
- Taller Carb Flange
- Compatibility w/Large Displacement 351W Based Eng.
Edelbrock – RPM Air-Gap AMC 304/360/401 Intake Manifold (Part No.7531)
from
$504.99
Edelbrock part #7531 RPM Air-Gap AMC intake manifold is designed for 1970-91 304-401 c.i.d. V8 applications. The RPM Air-Gap intake manifold incorporate the same race-winning technology as our Victor Series competition intakes. The air-gap design features
Product Features:
See More
Product Features:
- Based on Performer RPM-Series with Unique Air Gap
- Air Gap Cooler and Denser Mixture for More Power
- Designed for 1500 to 6500 RPM Street-Driven Power
- Dual-Plane High-Rise Intake w/180 deg Firing Order
- Produces Incredible Top-End Horsepower
- Retains Good Throttle Response and Acceleration
- Includes Std Oil Fill ; PCV ; A/C Accy Bosses
- Not for Exhaust-Heat Chokes – No Exhaust Crossover
FEL-PRO Performance – PERFORMANCE OIL PAN GASKET SET (Part No.1811)
from
$30.49
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Felcoid/Plus gaskets have a fiber sheet core and a latex rubber coating to eliminate potential leakage paths. The core material resists crushing and splitting, while providing excellent blowout resistance.
- With steel core to provide ultimate excellent blowout resistance.
- Not intended for use in emission controlled vehicles.
Edelbrock – Sure Seat Valve Springs for Ford 351W V8 (Part No.5882)
from
$52.99
Product Features:
See More
- Non-Rotator Type
- 1.384 in. Outer Diameter
- 1.020 in. Inner Diameter
- 1.020 in. Coil Blind
- Set of 16
FEL-PRO Performance – Exhaust Manifold Gasket Set (Part No.1430)
from
$26.49
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Performance exhaust header gasket consisting of a high-density fiber facing material attached to both sides of a perforated steel core.
- Resists blowout and burnout from high-temperature exhaust and is far stronger than basic paper gaskets.
- Anti-stick coating permits motion without damaging the gasket and makes it easier to remove the gasket for future engine service.
- Slotted bolt holes allow for easier header installation.
- Not intended for use in emission controlled vehicles.
FEL-PRO Performance – Cylinder Head Gasket: Steel Core Composite, Without Head Bolts (Part No.1013)
from
$58.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- PROPRIETARY COATING – Nonstick anti-friction coating seals small surface imperfections
- NO RETORQUE DESIGN – Steel core helps eliminate the need for retorquing head bolts
- SUPERIOR SEAL – Precise embossed Printoseal sealing beads at all vital areas to eliminate leak paths
- STRONG AND DURABLE – Features graphite or reinforced fiber facing material and steel armor for strength and durability
- DESIGNED FOR IMPERFECT SEALING SURFACES – Engineered and manufactured specifically for the repair environment to help seal imperfect sealing surfaces
Bricklin SV-1 Performance and Racing Products Categories
Helping You Find the Right Performance and Racing Products for Your Bricklin SV-1
You love your SV-1. So we’ve made it easier than ever to help you find Bricklin SV-1 Performance and Racing Products in our online catalog. Our inventory holds 19 aftermarket and OEM Performance and Racing Products for your Bricklin SV-1, ranging from $26.49 to $772.99.
We offer parts from 3 brands trusted to make quality Performance and Racing Products for your Bricklin SV-1. Before you buy, take some time to read through customer reviews. We currently have 74 reviews of Bricklin SV-1 Performance and Racing Products from previous customers. Some of the top rated parts include Thunder AVS Carburetor #1825 650 CFM With Manual Choke, Satin Finish (Non-EGR) with 4.5 stars.
Find your SV-1 Performance and Racing Products here, order online, and have your order shipped directly to your home. Prefer to have an in-person look at your Bricklin SV-1 part to confirm it’s just right? You can find your nearest Advance Auto Parts store and confirm they have the part in stock before heading over.
Top Performance and Racing Products Brands for Your Bricklin SV-1
Our inventory holds Performance and Racing Products for your Bricklin SV-1 from 3 trusted brands. You’ll find OEM and aftermarket parts from brands like Edelbrock, FEL-PRO Performance, and Mr. Gasket, all of which can keep that Bricklin happy.
We have FEL-PRO Performance parts available for your Bricklin SV-1 in categories like Performance Exhaust Products. Some of the top-rated FEL-PRO Performance parts in these categories are:
Top-Rated Edelbrock Performance and Racing Products
Leading Edelbrock Performance and Racing Products
We carry Edelbrock brand parts for your Bricklin SV-1 across several catalog categories, including Performance Fuel Systems. Some of our most reviewed Edelbrock parts include:
from
$428.99
(55)
Performer 1406 Carburetor: 600 CFM, 4 Barrel, Square Bore, Electric Choke Inlet
Performance Carburetors
from
$394.99
(10)
Performer 1405 Carburetor: 600 CFM, 4 Barrel, Square Bore, Manual Choke Inlet
Performance Carburetors
from
$397.99
(5)
Performer Carburetor #9906 600 CFM With Electric Choke, Satin Finish (Non-EGR)
Performance Carburetors
FAQs for Bricklin SV-1 Performance and Racing Products
What are the most purchased Performance and Racing Products for the Bricklin SV-1?
Out of 19 Performance and Racing Products for the Bricklin SV-1, the most popular in our inventory are:
from
$30.49
This product is not rated
PERFORMANCE OIL PAN GASKET SET
Performance Engine Oil Pan Gaskets
from
$39.99
This product is not rated
Lower Intake Manifold Gasket Set: 7 Piece Set
Performance Engine Intake Manifold Gaskets
from
$58.99
This product is not rated
Cylinder Head Gasket: Steel Core Composite, Without Head Bolts
Performance Engine Cylinder Head Gaskets
What are the top-rated Bricklin SV-1 Performance and Racing Products?
Top-rated Performance and Racing Products for your Bricklin SV-1 based on customer reviews/ratings are:
from
$427.99
(2)
Thunder AVS Carburetor #1825 650 CFM With Manual Choke, Satin Finish (Non-EGR)
“Put carb on rock crawler. Climb lots of hills and the carb works great. No loss of fuel when climbing steep grade. Does what I bought it to do.”
