Name: Ambient Air Temperature Sensor
Brand: Carquest Premium
SKU: WTA1251
Price: 19.99 USD

from

$19.99

CARQUEST premium engine management products provide the right products for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions.

from

$32.00

Ambient Temp Sensor

from

$30.99

The Engine Coolant Temperature Sensor determines the exact temperature of the engine coolant by sending an analog signal to the ECM to censure proper air/fuel ratio along with proper operation of the cooling fan(s) and temperature gauge. The Engine Coolant Temperature Sensor may be located on the cylinder head, engine block, thermostat housing or intake manifold. Reasons for replacement include: check engine light illumination, erratic or no temperature gauge operation, erratic or no cooling fan operation, and engine overheating.

Product Features:

OE MATCHED: Wires and probe length match OE. Mounting clip(s) included where applicable
FASTER RESPONSE TIME: Thermal conductive grease inside brass housing increases sensor response time
THE NTK DIFFERENCE: Thread sealant/o-ring installed where applicable. Thermistor placement within the housing matches OE to ensure proper output. Proper thermal conductive grease to provide accurate temperature transfer to the thermistor

from

$12.49

To perform a complete fuel pump replacement, clean the tank every time. Order the Delphi Fuel Tank Cleaning Kit (Part FC01). Remember, the original pump went into a clean fuel tank, to ensure the same level of performance, the new pump should too. 100 ye

Product Features:

Helps avoid premature fuel pump failure
Lint free towel included
Low suds formulation
Removes harmful contaminants from the fuel tank

from

$297.99

Silver Bullet throttle body spacers create turbulence in the air flow at the point just prior entry into the engine increasing horsepower, torque and improving throttle response and fuel efficiency. Silver Bullet throttle body spacers are constructed out of durable T-6061 billet aluminum and using a unique serrated/helix entry to create turbulence at the manifold while eliminating the annoying whistle found in other helix only throttle spacers.

Product Features:

Reduces Throttle Response Time
Improves Acceleration
Easy To Install
Does Not Affect The Vehicles Electronic System

from

$53.99

The EGR system is an emission control device designed to recirculate exhaust gas into the engines air intake system and back to the combustion chamber to control nitrogen oxides or NOx. The chemical NOx is created when oxygen and nitrogen are heated above 2,800-degree F. Exhaust gas, or gas that is displaced from the combustion chamber, contains little to no oxygen molecules. By recirculating this gas back into the combustion chamber fewer oxygen molecules are available for the combustion event which will therefore create a cooler combustion event. The EGR valve can be actuated by engine vacuum or electronically by the engine control module.

Product Features:

Product constructed to meet all design and operating characteristics as intended by the vehicle manufacturer.
Our EGR valves are designed to match the vehicle specific exhaust gas flow rate as designed by the engine manufacturer to provide clean tail pipe emissions.
Feedback EGR valves and pressure sensors contain a robust circuit board design which increases durability due to heat, shock, and random electro-magnetic pulses (EMP) and power spikes.
100% thermo-shock and vibration tested to ensure superior performance in extreme conditions.
Where applicable stainless-steel sleeves used over cold rolled sleeves providing smooth EGR pintle operation under all operating conditions.

from

$99.99

The EGR system is an emission control device designed to recirculate exhaust gas into the engines air intake system and back to the combustion chamber to control nitrogen oxides or NOx. The chemical NOx is created when oxygen and nitrogen are heated above 2,800-degree F. Exhaust gas, or gas that is displaced from the combustion chamber, contains little to no oxygen molecules. By recirculating this gas back into the combustion chamber fewer oxygen molecules are available for the combustion event which will therefore create a cooler combustion event. The EGR valve can be actuated by engine vacuum or electronically by the engine control module.

Product Features:

Product constructed to meet all design and operating characteristics as intended by the vehicle manufacturer.
Our EGR valves are designed to match the vehicle specific exhaust gas flow rate as designed by the engine manufacturer to provide clean tail pipe emissions.
Feedback EGR valves and pressure sensors contain a robust circuit board design which increases durability due to heat, shock, and random electro-magnetic pulses (EMP) and power spikes.
100% thermo-shock and vibration tested to ensure superior performance in extreme conditions.
Where applicable stainless-steel sleeves used over cold rolled sleeves providing smooth EGR pintle operation under all operating conditions.

from

$130.63

EGR Valve