TVR Tuscan Performance and Racing Products
Top TVR Tuscan Performance and Racing Products Categories
We carry over 28 Performance and Racing Products in inventory for the TVR Tuscan. If you’re looking for aftermarket Performance and Racing Products for your TVR Tuscan, check out all these categories:
Essential TVR Tuscan Performance and Racing Products
FEL-PRO Performance – Engine Valve Cover Gasket Set (Part No.1614)
from
$25.49
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Die cut silicone rubber gaskets conform to out-of-flat covers
- Great for on-again/off-again situations
- Not intended for use in emission controlled vehicles.
FEL-PRO Performance – Engine Valve Cover Gasket Set (Part No.1613)
from
$29.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Blue Stripe performance cork-rubber gaskets use cork particles evenly distributed throughout a rubber binder resulting in a compressible gasket without leak paths.
- Not intended for use in emission controlled vehicles.
Holley – Prem Street Carbs (Avengers) (Part No.0-80570)
from
$699.99
Square flange bolt pattern. Performance calibrated. The ultimate vacuum secondary street performance upgrade.
Product Features:
See More
Product Features:
- Vibratory Polished For Good Looks
- Optimized Street Calibration That Works Out Of The Box
- Factory Preset Electric Choke For Easy Startups
- Quick Change Vacuum Housing Cap To Tune For Performance/Fuel Econ
- No Unnecessary Trips Back To The Parts Store
- Limited Lifetime Warranty
- 100% Wet-Flow Tested To Assure It Arrives Ready To Run
- Street Ready; Out Of The Box
Holley – Street Carburetor: 670 CFM, Electric Choke, 4 Barrel, Square Bore, Dual Inlet, Shiny (Part No.0-80670)
from
$682.99
Square flange bolt pattern. Performance calibrated. The ultimate vacuum secondary street performance upgrade.
Product Features:
See More
Product Features:
- Vibratory Polished For Good Looks
- Optimized Street Calibration That Works Out Of The Box
- Factory Preset Electric Choke For Easy Startups
- Quick Change Vacuum Housing Cap To Tune For Performance/Fuel Econ
- No Unnecessary Trips Back To The Parts Store
- Limited Lifetime Warranty
- 100% Wet Flow Tested By Holley Technicians
- Arrives Ready To Run
Edelbrock – RPM Air-Gap #7521 Intake Manifold for Small-Block Ford 302-331-347 V8 (Part No.7521)
from
$454.99
Edelbrock Part #7521 RPM Air-Gap intake manifold is designed for the small-block 302 CID Ford V8 or 331-347 stroker applications. The RPM Air-Gap incorporates the same race-winning technology that?s been used on our Victor Series competition intakes and i
Product Features:
See More
Product Features:
- RPM Air-Gap for 302-331-347 Small-Block Ford V8
- Air-Gap design features an open air space under the plenum
- Separates fuel and air from engine heat
- Larger runners over standard 7121 manifold
- Includes nitrous bosses
Edelbrock – Performer 289 Intake Manifold for Small-Block Ford (Part No.2121)
from
$314.99Product Features:
- For Idle to 5500 RPM Street-Driven Performance
- Dual-Plane Low-Rise Intake w/180 deg. Firing Order
- Patented Runner Design Ensures Broad Torque Curve
- Excellent Throttle Response and Mid-Range Power
- 50-State Street Legal
- Available in Multiple Finishes
FEL-PRO Performance – Cylinder Head Gasket: Steel Core Composite, Without Head Bolts (Part No.1011-1)
from
$52.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- PROPRIETARY COATING – Nonstick anti-friction coating seals small surface imperfections
- NO RETORQUE DESIGN – Steel core helps eliminate the need for retorquing head bolts
- SUPERIOR SEAL – Precise embossed Printoseal sealing beads at all vital areas to eliminate leak paths
- STRONG AND DURABLE – Features graphite or reinforced fiber facing material and steel armor for strength and durability
- DESIGNED FOR IMPERFECT SEALING SURFACES – Engineered and manufactured specifically for the repair environment to help seal imperfect sealing surfaces
FEL-PRO Performance – Lower Intake Manifold Gasket Set: 11 Piece Set (Part No.1250)
from
$35.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- DESIGNED FOR IMPERFECT SEALING SURFACES — Engineered and manufactured specifically for the repair environment to help seal imperfect sealing surfaces
- SEALING TECHNOLOGIES — Exclusive sealing innovations and technologies with proprietary materials and unique design features to ensure a superior seal for your repair
- ENGINEERING EXPERTISE — Parts are designed, reviewed, validated and approved by Fel-Pro engineers through rigorous research and development
- REAL-WORLD TESTED — Parts are tested on-vehicle and validated to ensure optimal performance on the road
- EVERY PART FOR THE REPAIR — Fel-Pro gasket sets include every part needed for the repair unless otherwise noted
FEL-PRO Performance – Exhaust Manifold Gasket Set (Part No.1468)
from
$45.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Performance exhaust header gasket consisting of a high-density fiber facing material attached to both sides of a perforated steel core.
- Resists blowout and burnout from high-temperature exhaust and is far stronger than basic paper gaskets.
- Anti-stick coating permits motion without damaging the gasket and makes it easier to remove the gasket for future engine service.
- Slotted bolt holes allow for easier header installation.
- Not intended for use in emission controlled vehicles.
FEL-PRO Performance – Exhaust Manifold Gasket Set (Part No.1467)
from
$45.99
Product Features:
See More
- Performance exhaust header gasket consisting of a high-density fiber facing material attached to both sides of a perforated steel core.
- Resists blowout and burnout from high-temperature exhaust and is far stronger than basic paper gaskets.
- Anti-stick coating permits motion without damaging the gasket and makes it easier to remove the gasket for future engine service.
- Slotted bolt holes allow for easier header installation.
- Not intended for use in emission controlled vehicles.
FEL-PRO Performance – Exhaust Manifold Gasket Set (Part No.1416)
from
$39.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Performance exhaust header gasket consisting of a high-density fiber facing material attached to both sides of a perforated steel core.
- Resists blowout and burnout from high-temperature exhaust and is far stronger than basic paper gaskets.
- Anti-stick coating permits motion without damaging the gasket and makes it easier to remove the gasket for future engine service.
- Slotted bolt holes allow for easier header installation.
- Not intended for use in emission controlled vehicles.
Edelbrock – Performer-Plus Camshaft Kit for Small-Block Ford 289-302 V8 (Part No.2122)
from
$338.99Product Features:
- Designed for Optimum Torque and Acceleration
- Maximum Performance From Idle through Mid-Range
- Matched to Edelbrock Performer Intakes
- Includes Hydraulic Lifters and Assembly Lube
- Major Improvement in Throttle Response and Torque
- Use For Daily Drivers/Trucks/Vans/RVs/4x4s
- Take The Guesswork Out Of Camshaft Selection
Competition Cams – Magnum Roller 1.6 Ratio Rocker Arm Set (Part No.1431-16)
from
$350.99
These Magnum Roller Rocker Arms for Ford V8 289-351W (Rail Type) 1968-89 applications are the ultimate street rocker. With a 3/8″ stud diameter and 1.6 ratio, they are designed for serious performance enthusiasts. All Magnum Roller Rocker Arms are constructed from 8620 chromemoly steel, which is a superior material that will not flex and assures maximum lift. Their roller tip reduces friction, while stiff design and superior ratio accuracy yield more effective valve lift. With a 15 to 30 horsepower increase over other rocker arms, Magnum Roller Rockers are perfect for performance applications with less than 350 lbs. open spring pressure. Don’t accept inferior products or cheap knock-offs, look for the COMP Cams logo stamped into the underside of every Magnum Rocker.
Product Features:
See More
Product Features:
- Ultimate street rocker designed for serious performance enthusiasts
- Constructed from 8620 chromemoly steel, a superior material that will not flex and assures maximum lift
- Roller tip reduces friction while stiff design and superior ratio accuracy yields more effective valve lift
- 15 to 30 horsepower increase over stock rocker arms
- Use in any applications with less than 350 lbs. open spring pressure
Mr. Gasket – Alternator Bracket (Part No.5185)
from
$44.99
These brackets are made from heavy gauge steel, polished to a high luster, then chrome plated for lasting beauty. Similar in design to original equipment units.
Product Features:
See More
Product Features:
- Fits Small Block Ford 1965-’69 – OEM Style
- Polished To High Luster
- Chrome Plated For Lasting Beauty
Hays – Flywheels (Part No.12-535)
from
$499.99
Hays aluminum flywheels are manufactured from certified billet material that will not break up under the stress of high RPM and severe punishment of racing. Features replaceable steel surface insert. Precision balanced to either neutral (internal) or Detroit (external) specifications. Meets SFI specification 1.1 for racing.
Product Features:
See More
Product Features:
- Certified Billet Material
- Borg and Beck Clutch Pattern
- Long-Style Clutch Pattern
- Ring Gear Securely Mounted To Prevent Spinning
TVR Tuscan Performance and Racing Products Categories
Helping You Find the Right Performance and Racing Products for Your TVR Tuscan
You love your Tuscan. So we’ve made it easier than ever to help you find TVR Tuscan Performance and Racing Products in our online catalog. Our inventory holds 28 aftermarket and OEM Performance and Racing Products for your TVR Tuscan, ranging from $8.99 to $699.99.
We offer parts from 6 brands trusted to make quality Performance and Racing Products for your TVR Tuscan. Before you buy, take some time to read through customer reviews. We currently have 134 reviews of TVR Tuscan Performance and Racing Products from previous customers.
Find your Tuscan Performance and Racing Products here, order online, and have your order shipped directly to your home. Prefer to have an in-person look at your TVR Tuscan part to confirm it’s just right? You can find your nearest Advance Auto Parts store and confirm they have the part in stock before heading over.
Top Performance and Racing Products Brands for Your TVR Tuscan
Our inventory holds Performance and Racing Products for your TVR Tuscan from 6 trusted brands. You’ll find OEM and aftermarket parts from brands like FEL-PRO Performance, Holley, and Edelbrock, all of which can keep that TVR happy.
We have Competition Cams parts available for your TVR Tuscan in categories like Performance Engines. Some of the top-rated Competition Cams parts in these categories are:
Top-Rated Holley Performance and Racing Products
Leading Holley Performance and Racing Products
We carry Holley brand parts for your TVR Tuscan across several catalog categories, including Performance Fuel Systems. Some of our most reviewed Holley parts include:
from
$499.99
(45)
Street Carburetor: 600 CFM, Electric Choke, 4 Barrel, Square Bore, Single Inlet, Shiny
Performance Carburetors
from
$682.99
(6)
Street Carburetor: 670 CFM, Electric Choke, 4 Barrel, Square Bore, Dual Inlet, Shiny
Performance Carburetors
FAQs for TVR Tuscan Performance and Racing Products
What are the most purchased Performance and Racing Products for the TVR Tuscan?
Out of 28 Performance and Racing Products for the TVR Tuscan, the most popular in our inventory are:
from
$35.99
(4)
Lower Intake Manifold Gasket Set: 11 Piece Set
Performance Engine Intake Manifold Gaskets
from
$52.99
(2)
Cylinder Head Gasket: Steel Core Composite, Without Head Bolts
Performance Engine Cylinder Head Gaskets
