2019 BMW X3 Drivetrains
More 2019 BMW X3 Drivetrains Categories
If you’re looking for an original Drivetrains replacement for a 2019 BMW X3, you can search through our selection below. You’ll also find aftermarket and OEM Drivetrains to meet your needs.
Essential 2019 BMW X3 Drivetrains
Valvoline – Import Multi-Vehicle Automatic Transmission Fluid, 1 Gallon (Part No.820681)
from
$36.99
Valvoline Import Multi-Vehicle Automatic Transmission Fluid is specifically formulated for use in most Toyota, Nissan, Honda and other imported vehicles. It is formulated with all synthetic base stocks and a proprietary additive system to ensure optimal transmission performance in a wide variety of vehicles. Valvoline Import Multi-Vehicle ATF can also be used in many domestic vehicles. It meets requirements of General Motors and Ford vehicles. Recommended for use in the following applications: Ford MERCON®, GM DEXRON®-II and DEXRON®-III, BMW LT 71141 and ETL-7045E, Nissan/Infiniti Nissan ATF, Matic-D, Matic-K and Matic-J, Mitsubishi Diamond SP-II and SP-III, Subaru ATF-HP, Hyundai/ KIA SP-II and SP-III , Toyota/Lexus Type T, T-III and T-IV , Honda/Acura ATF-Z1 (except in CVTs) , Mercedes Benz NAG1 , Volvo passenger car (except AW-1), and Volkswagen/Audi TL52162. For CVT applications Valvoline recommends Valvoline Full Synthetic CVT Fluid.
Product Features:
See More
Product Features:
- Formulated with full-synthetic base stocks and advanced additive technology to meet the challenging demands of automatic transmissions.
- Enhanced anti-shudder protection for smooth shifting and maximum power transfer
- Developed with anti-wear technology to help improve transmission durability
- Engineered with a proprietary blend of base oils and advanced additives to provide better oil flow at low temperatures and greater film protection at higher temperatures
Valvoline – MaxLife Multi-Vehicle (ATF) Full Synthetic Automatic Transmission Fluid, 1 Quart (Part No.VV324)
from
$12.79
Product Features:
See More
- High-performance seal conditioners maintain and preserve the elasticity of seals to help prevent leaks
- Long-life friction modifiers and premium base oils help improve smooth shifting, eliminate slippage and shudder, prevent clutch wear and improve drivability longer than conventional fluids
- Enhanced cleaning additives help reduce varnish formation and keep the transmission running properly longer
- Engineered with a unique blend of viscosity modifiers and base oils to provide better oil flow at low temperatures and greater film protection at higher temperatures
Corteco – Differential Side Cover Seal, 90 x 44 x 10 (Part No.J7041238121CFW)
from
$20.42
Differential Side Cover Seal, 90 x 44 x 10
Cardone – Rear Drive Shaft: Greasable, Direct Replacement (Part No.65-7046)
from
$847.99
CARDONE Remanufactured Prop Shafts are engineered using the most stringent quality processes to deliver smooth, consistent performance in any driving condition. Original designs are scrutinized for potential improvement, and where applicable, design upgrades are implemented to produce a more durable part than the original. All critical components are tested to ensure proper function. Additionally, all CARDONE Prop Shafts are 100% dynamically balanced, resulting in vibration-free performance at all speeds.
Product Features:
See More
Product Features:
- Built to match O.E. form, fit and function.
- 100% NEW universal joints are installed to ensure proper fit and optimal performance.
- All slip yokes are lubricated to prevent premature wear.
- Units are 100% dynamically balanced at 3200 RPMs for vibration-free operation and increased joint life.
Cardone – Rear Drive Shaft: Not Greasable, Direct Replacement (Part No.65-7045)
from
$882.99
CARDONE Remanufactured Prop Shafts are engineered using the most stringent quality processes to deliver smooth, consistent performance in any driving condition. Original designs are scrutinized for potential improvement, and where applicable, design upgrades are implemented to produce a more durable part than the original. All critical components are tested to ensure proper function. Additionally, all CARDONE Prop Shafts are 100% dynamically balanced, resulting in vibration-free performance at all speeds.
Product Features:
See More
Product Features:
- Built to match O.E. form, fit and function.
- 100% NEW universal joints are installed to ensure proper fit and optimal performance.
- All slip yokes are lubricated to prevent premature wear.
- Units are 100% dynamically balanced at 3200 RPMs for vibration-free operation and increased joint life.
Dorman – Rear Drive Shaft (Part No.986-505)
from
$1016.99
Replacing a drive shaft doesn’t have to be complicated. This complete drive shaft assembly is pre-balanced and ready to install with 100% new yokes, tubes, constant velocity (CV) joints and universal joints.
Product Features:
See More
Product Features:
- Direct replacement – this drive shaft is made to the original equipment dimensions for dependable fit and performance
- 100% new – this drive shaft is made from all new components so there’s no core charge or return hassle
- Ready to install – this drive shaft arrives pre-balanced to make installation quick and simple
- Serviceable construction – non-staked universal joints are designed for future serviceability
Cardone – Front Drive Shaft: Not Greasable, Direct Replacement (Part No.65-7004)
from
$409.99
CARDONE Remanufactured Prop Shafts are engineered using the most stringent quality processes to deliver smooth, consistent performance in any driving condition. Original designs are scrutinized for potential improvement, and where applicable, design upgrades are implemented to produce a more durable part than the original. All critical components are tested to ensure proper function. Additionally, all CARDONE Prop Shafts are 100% dynamically balanced, resulting in vibration-free performance at all speeds.
Product Features:
See More
Product Features:
- Built to match O.E. form, fit and function.
- 100% NEW universal joints are installed to ensure proper fit and optimal performance.
- All slip yokes are lubricated to prevent premature wear.
- Units are 100% dynamically balanced at 3200 RPMs for vibration-free operation and increased joint life.
Anchor – Center Support Bearing Motor Mount: Center, 1 Piece (Part No.6124)
from
$76.99
Center support bearings or Carrier Support Bearings are used when the driveshaft is split into two sections. It serves as a junction on the drive shaft between the transmission and the differential allowing the driveshaft to flex, relieving stress on other drive line components. Each part is engineered and designed to OE Standards. Applicable to BMW 06-17;. Please verify your application.
Product Features:
See More
Product Features:
- MAXIMUM VIBRATION DAMPENING: Rubber cushion is made of high grade rubber that ensures maximum dampening of vibration and the ability to absorb over loads.
- HEAVY GAUGE STEEL FRAME: The housing frame is made from heavy gauge steel with durability that extends the service life.
- READY TO INSTALL: Most center supports include a sealed bearing and dust shield and are ready to install.
- For Years: 2006-2017
- Weight approx: 1 Lbs
- BEARING ID / BORE: 1.1811 INCH / 30 MM
- CENTERLINE: 0.10 INCH / 3 MM
- MOUNT WIDTH: 6.35 INCH / 161 MM
- STYLE: ROUND FRAME
- WITH WINGS
Rein – Drive Shaft-Ctr Support Bearng (Part No.BEM0039P)
from
$13.99
Drive Shaft-Ctr Support Bearng
Dorman – Driveshaft Center Support Bearing (Part No.934-021)
from
$95.99
This drive shaft center bearing is designed to match the fit and function of the original bearing on specified vehicles, and is engineered for durability and reliable performance.
Product Features:
See More
Product Features:
- Direct replacement – this drive shaft center bearing is designed to match the fit and function of the original bearing on specified vehicles
- Restores functionality – this bearing is made to fit and fully restore part functionality after the original bearing fails
- Durable construction – this part is made from quality materials to ensure reliable performance and long service life
- Trustworthy quality – backed by team of product experts in the United States and more than a century of automotive experience
SKF – Drive Shaft Support Bearing (Part No.K1040100111SKF)
from
$43.52
Rugged SKF drive shaft support bearings are built to meet or exceed OE specifications. The Support Bearings are also built on the years of experience that SKF has earned designing and supplying bearings to the world’s largest OE manufacturers. Engineered and manufactured to specific application requirements that deliver precise drive shaft alignment and support. Center support bearings are pre-lubricated and sealed with metal reinforced seals to prevent contamination. Rubber support cushions are manufactured from durable rubber compounds that provide maximum support while isolating the driveline shaft from damaging vibration. Drive shaft support frames are constructed from high quality steel or aluminum that provides additional strength and long life in harsh environments.
Product Features:
See More
Product Features:
- Original equipment design and quality
- Utilizes OE equivalent or better materials
- Pre-Lubricated and reinforced seals
- Rubber support cushions are manufactured from durable rubber compounds
- Support frames are constructed from high quality steel or aluminum
Corteco – Pinion Seal (Part No.J7010426125CFW)
from
$16.40
Pinion Seal
Rein – Differential Plug (Part No.HWP0065)
from
$7.99
Rein Automotive OE quality oil drain plugs are made with premium materials and designed and manufactured to be direct-fit replacements. Rein oil drain plugs are designed to tight tolerances to ensure proper sealing.
Product Features:
See More
Product Features:
- Designed to tight tolerances to ensure proper sealing.
- Rein Oil Drain Plugs are coated for high corrosion resistance.
- Designed and constructed to strict engineering quality standards.
- Includes copper sealing gasket.
Original Equipment – Transfer Case Oil Dr (Part No.J7127687305OEA)
from
$9.60
Transfer Case Oil Dr
Febi – Driveshaft Flex Join (Part No.K1020119041FEB)
from
$111.58
Driveshaft Flex Join
Popular 2019 BMW X3 Drivetrains Categories
2019 BMW X3 Drivetrains
You count on your 2019 BMW X3 to run right. That means taking care of it with regular maintenance, necessary repairs, and the right parts. Advance Auto Parts can help with all of that thanks to our extensive inventory of trusted Drivetrains. With 8 Drivetrains ranging in price from $5.00 to $394.99, you’re sure to find everything you need for your 2019 BMW X3.
Brands matter. If you want to shop a specific Drivetrains brand, we stock 6 different brands like Valvoline, Rein, and Cardone. 2019 BMW X3 Drivetrains start as low as $5.00!
One of the best ways to find top quality OEM or aftermarket Drivetrains is by asking professionals. Short of that, you can shop with confidence thanks to our 446 extensive product reviews on 2019 BMW X3 Drivetrains.
Did we mention you can order your Drivetrains from our online catalog and have them shipped right to your garage? Or, if you feel like seeing the parts first-hand, search for your nearest Advance Auto Parts location above and pick up in-store when you’re ready. Browse our full Drivetrains inventory for your 2019 BMW X3 below to get started!
Top-Rated Drivetrains Brands For Your 2019 BMW X3
Trusted Drivetrains OEM and aftermarket product brands are what Advance Auto Parts specializes in. The brands we work with are sure to keep that 2019 BMW X3 running right for years to come. In our inventory you’ll find brands like Valvoline, Rein, Cardone, and even more.
Popular Valvoline Drivetrains
You’ll find popular Valvoline brand products across Differentials. All are waiting to get your 2019 BMW X3 back on the road. Some of the top-rated Valvoline products in these categories are:
from
$12.79
(446)
MaxLife Multi-Vehicle (ATF) Full Synthetic Automatic Transmission Fluid, 1 Quart
Differential Oil
FAQs for 2019 BMW X3 Drivetrains
What are the most purchased Drivetrains for the 2019 BMW X3?
Out of 8 Drivetrains for the 2019 BMW X3, the most popular in our inventory are:
