from

$11.99

Replacement ring gear bolt for Model 35, Dana 25, 27, 30 & 44. 3/8″ x 24.

Product Features:

Ring gear bolt for Dana Spicer 25, 27, 30, 44 and AMC Model 35
3/8″ x 24 thread

from

$12.99

Dana 30 & Dana 44 roll PIN, 0.235″ DIA, for cross pin shaft.

Product Features:

Roll pin for Dana Spicer 30 and Dana Spicer 44
0.235″ diameter

from

$12.99

Valvoline ATF for MERCON®V Applications is a high-quality transmission fluid meeting and exceeding the requirements of the Ford Mercon V specification which covers most Ford passenger cars and light-duty trucks (except those specifying MERCON®SP, MERCON®LV or Type F fluids), including Lincoln and Mercury, as well as most pre-2006 GM vehicles and many imports. Recommended for use in the following applications: MERCON®V, MERCON®, DEXRON®-III, DEXRON®-II, Caterpillar TO-2, Allison C-4. Other applications include Power steering fluid where a DEXRON® or MERCON® fluid is recommended. Suitable to use in Nissan Matic D, Matic J and Matic K.

Product Features:

Formulated with premium base stocks and advanced additive technology to meet the challenging demands of automatic transmissions
Enhanced anti-shudder protection for smooth shifting and maximum power transfer
Developed with anti-wear technology to help improve transmission durability
Engineered with a proprietary blend of base oils and advanced additives to provide better oil flow at low temperatures and greater film protection at higher temperatures

from

$265.99

Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings & races can be reused. This kit uses Timken bearings and races along with a high quality pinion seal and small parts. Included in this kit are the pinion bearings and races, pilot bearing (if applicable), crush sleeve (if applicable), complete pinion shim kit, pinion nut, thread locker, and marking compound with brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your pinion gear.

Product Features:

Fits reverse rotation Dana Spicer 44 JK Rubicon
Included are pinion bearings and races, pinion seal, crush sleeve , complete pinion shim kit, and marking compound with brush.

from

$259.99

This kit uses Koyo bearings and races along with all high quality small parts. kit includes carrier bearings and races, pinion bearings and races, pinion seal, crush sleeve (if applicable), oil baffles and slingers (if applicable), marking compound and brush. USA Standard Gear does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your ring & pinion set.

Product Features:

Fits Jeep JK non-Rubicon front
Uses Koyo bearings and races
Included are carrier bearings and races, pinion bearings and races, pinion seal, pinion nut, crush sleeve, marking compound and brush.

from

$3.99

Replacement pinion nut washer for Dana 25, 27, 30, 36, 44 & 53.

Product Features:

Pinion nut washer for Dana Spicer 25, 27, 30, 44 and 50

from

$6.79

Fel-Pro gaskets offer 100% vehicle sealing with application-specific materials to give you sealing solutions with the performance and durability professionals trust

Product Features:

Meets or exceeds all original equipment specifications
Application specific design to ensure a perfect fit
Unsurpassed quality you can trust
Validated for fit, form and function
Each Fel-Pro gasket, no matter how small, is engineered to exacting standards with proprietary design, engineering and manufacturing processes

from

$10.99

Product Features:

Pinion gear thrust washer
Fits AMC Model 35
0.685″ I.D.
With step

from

$30.99

Product Features:

Carrier shim kit for Dana Spicer 30 and Dana Spicer 44 with 19 spline axles

from

$11.29

This engine oil drain plug is designed to match the fit and function of an original equipment plug on specified vehicles. It is engineered to replace a missing or damaged plug and help ensure a secure seal.

Product Features:

Direct replacement – this engine oil drain plug is designed to match the fit and function of an original equipment plug on specified vehicles
Ideal solution – engineered to replace a missing or damaged plug and help ensure a secure seal
Durable construction – designed and manufactured to strict specifications for reliable performance
Trustworthy quality – backed by a team of product experts in the United States and more than a century of automotive experience

from

$273.99

Universal Joint

from

$659.99

The Spartan Locker, by USA Standard Gear, provides reliable traction at a low cost. Give your vehicle great traction and save some cash. Choose a Spartan Locker for better traction. The Spartan locker by USA standard gear is a mechanical locker that replaces the spiders in a standard case. The Spartan locker’s design does not use the thrust washers and has a revolutionary spring and pin design that makes installation a snap! The couplers and drivers are made from 9310 steel, for added strength. Each Spartan locker carries a one year warranty against defect.

Product Features:

Fits AMC Model 35 with 27 spline axles and 1.560″ side gear bore
Made from 9310 steel for added strength
Replaces the spiders in a standard carrier case

from

$12.99

Product Features:

Cover gasket
Fits Dana Spicer 30

from

$9.99

Replacement crush sleeve for Dana 30 short (Jeep TJ), APROX 1.375″, TJ.

Product Features:

Crush sleeve for standard rotation Dana Spicer 30 with short pinion
1.375″ tall

from

$119.99

JK Dana 44 Rubonc rear PINION KIT .

Product Features:

Fits Jeep JK Rubicon rear
Uses Koyo bearings and races
Included are pinion bearings and races, pinion seal, pinion nut, crush sleeve, marking compound and brush.

from

$25.49

National Oil Seals & Bearings offer a full line of premium oil seals and bearings.

Product Features:

Premium bearing design matches OEM specifications
Precision manufactured using premium-grade steel for outstanding durability and performance
Controlled heat treating process for lasting performance and extended bearing life
Industry leading coverage
Professional technicians know they can depend on National

from

$78.99

Crown Automotive continues to be the leader in quality replacement parts for Jeep(R) vehicles. Crown has the largest stock of replacement parts for Jeep(R) vehicles, including factory discontinued parts. In fact, many of the older Jeeps are still on (and off) the road thanks to Crown parts. The Crown line consists of axle, body, brake, clutch, cooling, driveline, electrical, engine, exhaust, fuel, steering, suspension, transmission And transfer case components. Crown Automotive also offers an exclusive line of component kits And accessory products.

Product Features:

Leading Manufacturer Of Quality Replacement Parts For Jeep
Meets Standards For Quality
Crown Automotive Has Consistently Maintained Its Commitment To Offering Only Quality Parts And Exceptional Service
Improve The Performance
Easy Installation

from

$52.99

Air line repair kit, ZIP locker.

Product Features:

Air line repair kit
Includes 20′ air line and two repair fittings

from

$203.99

Product Features:

Spider gear kit
Fit Dana Spicer 44 open differential with 30 spline axles
Includes two side gears, two pinion gears, cross pin shaft, cross pin bolt and spider gear thrust washers.

from

$83.99

Product Features:

Seal housing for Dana Spicer 44
Includes o-rings

from

$27.99

8.25″ IFS, 8.5″, 12P, 7.5″ F, 8.8″ F, 8.25″ Chrysler pinion shim kit.

Product Features:

Pinion depth shims for GM 8.25″ IFS, 8.5″, 8.6″, 12 bolt passenger car, Ford 7.5″ and 8.8″, Chrysler 8.25″

from

$255.99

USA Standard ring & pinion sets are the right choice to add confidence to your install. USA Standard Gear offers a full line of ring & pinion sets for a variety of common & hard to find applications. USA standard gear offers a standard one year warranty against defects on their ring & pinion sets.

Product Features:

Fits standard rotation AMC Model 35
7.562″ ring gear diameter
26 spline pinion
8 ring gear bolts
5.13 ratio

from

$998.99

The Yukon Grizzly Locker is the ultimate in locking differentials for street, off-road, & drag racing. Grizzly Lockers provide 100% power to both tires, while still allowing for disengagement while negotiating turns. The Yukon Grizzly locker is a mechanical locking differential. It features a forged case and 8620 internals for maximum strength. It’s patented design reduces common locker failures. All units assembled in the USA! All Grizzly Lockers are backed by the best warranty in the business! Yukon covers the replacement unit and covers any collaterally damaged parts and associated labor, up to $2,000!

Product Features:

Fits Dana Spicer 44 with 30 spline axles
3.92 and up ratio only
Patented internal design reduces common locker failures
8620 internals for added strength
Assembled in the USA

from

$15.99

Product Features:

Carrier shim kit for Dana Spicer 30 with 30 spline axles

from

$6.49

Fel-Pro gaskets offer 100% vehicle sealing with application-specific materials to give you sealing solutions with the performance and durability professionals trust

Product Features:

Meets or exceeds all original equipment specifications
Application specific design to ensure a perfect fit
Unsurpassed quality you can trust
Validated for fit, form and function
Each Fel-Pro gasket, no matter how small, is engineered to exacting standards with proprietary design, engineering and manufacturing processes

from

$172.99

USA Standard Gear standard spider gear set for AMC Model 35 with 1.560″ side gear bore. (used in ’94 and newer models).

Product Features:

Fits AMC Model 35 with open differential and 1.560″ side gear bore
Includes two side gears, two pinion gears, cross pin shaft, cross pin bolt and spider gear thrust washers.

from

$11.79

Is your Jeep differential cover leaking? Do you need to seal it up after some work? Omix-ADA has the OE quality differential gaskets you need.

Product Features:

Rubber
Sold Individually
OE Style
Direct Fit
Limited 5 Year Warranty

from

$5.49

Is your Jeep differential cover leaking? Do you need to seal it up after some work? Omix-ADA has the OE quality differential gaskets you need.

Product Features:

Rubber
Sold Individually
OE Style
Direct Fit
Limited 5 Year Warranty

2013 Jeep Wrangler Differentials

More 2013 Jeep Wrangler Differentials

Essential 2013 Jeep Wrangler Differentials

Yukon Gear – Replacement Ring Gear Bolt For Model 35, Dana 25, 27, 30 & 44 – 3/8" X 24 (Part No.33038)

Yukon Gear – Dana 30 / 44 Roll Pin Replacement (Part No.33312)

Valvoline – ATF for Mercon®V Applications Conventional, 1 Quart (Part No.822345)

Yukon Gear – Pinion Install Kit For Dana 44 JK Rubicon Front Differential (Part No.13098)

USA Standard Gear – Bearing Kit For Dana 30 JK Front (Part No.58034)

Yukon Gear – Dana 25 / 27 / 30 / 36 / 44 / 53 Pinion Nut Washer Replacement (Part No.33163)

Felpro – Axle Housing Cover Gasket (Part No.RDS 55019)

Yukon Gear – Model 35 Standard Open Pinion Gear Thrust Washer (Part No.33291)

Yukon Gear – Replacement Carrier Shim Kit For Dana 30 & 44 With 19 Spline Axles (Part No.55018)

Needa Parts – Standard Engine Oil Drain Plug: 7/8 " -16 Thread, 1-1/8 " Head, 1 Pack (Part No.090-018)

Yukon Gear – Universal Joint (Part No.41220)

USA Standard Gear – Spartan Locker For Model 35 With 27 Spline Axles And A 1560" Carrier, Includes Heavy-Duty Cross Pin (Part No.17007)

Yukon Gear – Replacement Cover Gasket For Dana 30 (Part No.23003)

Yukon Gear – Replacement Crush Sleeve For Dana 30 Short (Jeep TJ) (Part No.33090)

USA Standard Gear – Pinion Installation Kit For Rubicon JK 44 Rear (Part No.60007)

National – Bearings (Part No.206)

Crown Auto Jeep Replacmnt – For Use With Rubicon Dana 44 Tru-Lok Differential (Part No.68003569AA)

Yukon Gear – Air Line Repair Kit, Zip Locker (Part No.34003)

USA Standard Gear – Open Spider Gear Set For Dana Spicer 44, 30 Spline (Part No.39006)

Yukon Gear – Seal Housing For Dana 44, Zip Locker, With O-Rings (Part No.34013)

Yukon Gear – Pinion Depth Shims For GM 8.25" IFS, 8.5", 12 Bolt Car, Ford 8.8" & Chrysler 8.25" (Part No.55009)

USA Standard Gear – Ring & Pinion Gear Set For Model 35 In A 5.13 Ratio (Part No.36301)

Yukon Gear – Dana 44 Grizzly Locker Replacement (Part No.28001)

Yukon Gear – Replacement Carrier Shim Kit For Dana Spicer 44, 30 Spline Axles (Part No.55010)

Felpro – Axle Housing Cover Gasket (Part No.RDS 6629)

USA Standard Gear – Standard Spider Gear Set For Amc Model 35 With 1.560" Side Gear Bore (Part No.39030)

Omix – Differential Cover Gasket (Part No.16502.05)

Omix – Differential Cover Gasket (Part No.16502.02)

Popular 2013 Jeep Wrangler Differentials Categories

2013 Jeep Wrangler Differentials

Differentials Brands To Make Your 2013 Jeep Wrangler Last

Popular Felpro Differentials

FAQs for 2013 Jeep Wrangler Differentials

What are the most purchased Differentials for the 2013 Jeep Wrangler?

What are the top-rated 2013 Jeep Wrangler Differentials?

More Popular Parts for All Makes