from

$69.99

New Standard Replacement Radiator Support Upper Tie Bar

Product Features:

Made Of Steel
Meets All Federal Motor Safety Standards
No Drilling Needed For Installation
No Modifications Needed For Installation
Direct Fit Replacement For Your Vehicle
Same Form Fit And Function As OE
Check Out The Large Selection Of Parts Available For Your Vehicle

from

$57.99

CARQUEST premium engine management products provide the right products for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions.

from

$9.49

GM Genuine Parts A/C Orifice Tubes are designed, engineered, and tested to rigorous standards, and are backed by General Motors. These tubes, which separate the high and low pressure sides of the air conditioning system, control the flow of low pressure liquid refrigerant into the evaporator. The orifice tube is essentially a calibrated restriction located at the inlet to the evaporator. This causes the necessary pressure drop to allow the liquid refrigerant to evaporate within the evaporator and absorb heat. Since the orifice tube is fixed, the system is regulated by either cycling the compressor clutch or by a variable displacement compressor. GM Genuine Parts are the true OE parts installed during the production of or validated by General Motors for GM vehicles. Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE).

Product Features:

Restores A/C performance due to restricted orifice tubes
Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE)
GM Engineers design and validate OE parts specifically for your Chevrolet, Buick, GMC, or Cadillac vehicle
Original equipment parts are designed to work with your GM vehicle safety systems — aftermarket replacement parts may not meet the same OE safety regulations, depending on the part type
GM regularly updates production and service part designs to integrate new materials and technologies

from

$60.32

Thermostat Housing

from

$8.72

An ACDelco GM Original Equipment Engine Coolant Water Inlet Seal is a GM-recommended replacement for your vehicle’s original component. It seals and helps prevent coolant from leaking out of cooling system components. This original equipment engine coolant water inlet seal has been manufactured to fit your specific GM vehicle, providing the same performance, durability, and service life you expect from General Motors.

Product Features:

Seals and helps prevent coolant from leaking out of cooling system components to maintain the proper engine temperature
GM-recommended replacement part for your GM vehicle’s original factory component
Offering the quality, reliability, and durability of GM OE
Manufactured to GM OE specification for fit, form, and function

from

$29.99

ARP timing cover bolts are available in both polished stainless steel or black oxide finish chrome moly. You also can choose between standard hex head bolts or compact 12 point fasteners. Also available as part of ARP complete engine and accessory kits. Studs are preferred by many pro engine builders because they eliminate the chance of pinching gaskets and contribute to easier engine assembly. You will note that ARP studs feature a special bullet nose to guide the nut accurately into place. Available in black oxide finish 8740 chrome moly or polished stainless steel with hex or 12 point nuts. Alternators that come loose are a pain, so That is why ARP came up with these super tough bolts (your choice of chrome moly steel or polished stainless (ARP 300) both rated 170,000 PSI). The stainless has the added advantage of being rust and corrosion resistant. It is the fastener of choice.

Product Features:

Made From Black Oxide Finished 8740 Chrome Moly Or Corrosion Resistant Stainless Steel
Nominally Rated At 170,000 PSI Tensile Strength
Professional Quality Fasteners
Made In USA
Hex Head
Sold As A Kit

from

$34.49

CARQUEST premium engine management products provide the right products for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions.

from

$19.99

Air Conditioning Pressure Switch

from

$22.99

Approved materials for increased durability in even the most extreme temperatures. All MotoRad Coolant Temperature Sensors are designed to meet or exceed OEM specifications at our ISO TS16949 manufacturing facilities.

Product Features:

100% factory resistance calibrated to ensure precision tolerances, resulting in extremely accurate temperature for optimal performance
Thread Sealant and/or O-ring pre-installed on applicable sensors to ensure leak free performance
Brass sensor housing precision machined to meet or exceed OE thermal conductivity
OE precision matched thermistor position for correct output parameters
Extensive product testing includes salt spray, high/low temperature impact, thermal vibration, durability, static electricity, and micro tension, among other tests, to ensure all sensors meet or exceed OEM specifications.

from

$2.99

Fel-Pro gaskets offer 100% vehicle sealing with application-specific materials to give you sealing solutions with the performance and durability professionals trust

Product Features:

Meets or exceeds all original equipment specifications
Application specific design
Manufactured for the sealing repair environment
Validated for fit, form, and function
Quality that you can trust

from

$69.99

New Standard Replacement Driver Side Radiator Support Baffle

Product Features:

Made Of Plastic
Meets All Federal Motor Safety Standards
No Drilling Needed For Installation
No Modifications Needed For Installation
Direct Fit Replacement For Your Vehicle
Same Form Fit And Function As OE
Check Out The Large Selection Of Parts Available For Your Vehicle

from

$4.49

These bolts are manufactured using durable materials and corrosion-tested to ensure required strength and longevity.

Product Features:

Durable materials – manufactured to specific thread tolerance standards
Corrosion tested – hardware undergoes salt spray testing to ensure corrosion resistance
Multipurpose usefulness – can be used in a variety of applications, from auto to home
Trustworthy quality – backed by team of professional engineers and quality control specialists in the United States

from

$131.99

Carquest Hose Assemblies are designed to carry refrigerant in an air conditioning system. They are manufactured to meet or exceed original equipment specifications and are designed to easily fit into the engine compartment.

Product Features:

100% of hose assemblies use Goodyear hoses that meet original equipment specifications for wall thickness and permeation.
Tubes and mufflers are designed to meet original equipment specifications for wall thickness.
Fittings are designed to couple and seal to eliminate leaks. Trivalent plating is used on steel fittings to enhance corrosion resistance. The fittings conform to original equipment specifications to allow for the proper fit with related air conditioning
Welds and crimps meet and exceed original equipment tension specifications.
Manufactured to allow flexibility in the hose to conform to engine compartments.
O-Rings necessary for installation are included.
O-Rings necessary for installation are included.

from

$61.99

CARQUEST premium engine management products provide the right products for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions.

Product Features:

Premium quality materials for longer service life
Sealed connections (where applicable) to prevent environmental corrosion and performance issues
Global coverage for import and/or domestic applications
OE specified wire gauge to ensure a reliable electrical connection
Designed to meet or exceed OE specifications in form, fit and function

from

$8.99

GM Genuine Parts Wiring Relays are designed, engineered, and tested to rigorous standards, and are backed by General Motors. These relays help connect or disconnect power to a vehicle accessory when it receives a low voltage signal from a switch. GM Genuine Parts are the true OE parts installed during the production of or validated by General Motors for GM vehicles. Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE).

Product Features:

Helps connect or disconnect power to vehicle accessories
Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE)
GM Genuine Parts are designed, engineered and tested to rigorous standards, and are backed by General Motors
GM Engineers design and validate OE parts specifically for your Chevrolet, Buick, GMC, or Cadillac vehicle
GM regularly updates production and service part designs to integrate new materials and technologies

from

$14.99

This engine water pump stud kit is designed to match the original hardware required to repair the water pump on specified vehicles. Made of quality components, this kit is engineered for reliable performance and durability.

Product Features:

Direct replacement – this engine water pump stud kit is designed to match the original hardware required to repair the water pump on specified vehicles
Ideal solution – this kit is a reliable replacement for original hardware that is missing or damaged
Durable construction – this kit is made from quality components to ensure reliable performance and a long service life
Trustworthy quality – backed by team of product experts in the United States and more than a century of automotive experience

from

$15.99

High quality OE replacement part with all components needed to complete the job

Product Features:

All the seals needed to complete the job
Compatible with both R12 and R134a refrigerants
Application specific
SUV and rear air applications

from

$21.99

Advance Auto Parts is committed to providing high-quality ABS sensors. The entire manufacturing process is closely managed to deliver high quality products.

Product Features:

High grade materials that are equal to or better than OE provide durability and long service life
All ABS sensors are tested for proper fit, form, and function
Wire diameter and sheathing same or larger than OE to ensure product quality
Glass filled reinforced plastic for superior resistance to automotive fluids, dirt, salt and road debris
Includes all necessary brackets and hardware

from

$5.29

Fel-Pro gaskets offer 100% vehicle sealing with application-specific materials to give you sealing solutions with the performance and durability professionals trust

Product Features:

Meets or exceeds all original equipment specifications
Application specific design
Manufactured for the sealing repair environment
Validated for fit, form, and function
Quality that you can trust

from

$36.99

ACDelco GM Original Equipment Pigtail Connectors are connectors ready to be spliced into vehicle harnesses, and are GM-recommended replacements for your vehicle’s original components. These original equipment pigtail connectors have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.

Product Features:

Protective outer coverings help provide long-lasting durability
Color-coded wires allow for easy installation
GM-recommended replacement part for your GM vehicle’s original factory component
Offering the quality, reliability, and durability of GM OE
Manufactured to GM OE specification for fit, form, and function

from

$247.99

Motors built And tested to OE specifications; OE fit And design; Out of box installation; Quality construction And assembly

from

$17.99

ACDelco GM Original Equipment Engine Coolant Water Outlets are housings that connect the radiator hoses to the engine, typically housing the engine coolant thermostat. For certain applications, the water outlet contains threaded holes or ports for sensors and switches. These original equipment engine coolant water outlets are GM-recommended replacements for your vehicle’s original components and have been manufactured to fit your specific GM vehicle, providing the same performance, durability, and service life you expect from General Motors.

Product Features:

GM-recommended replacement part for your GM vehicle’s original factory component
Offering the quality, reliability, and durability of GM OE
Manufactured to GM OE specification for fit, form, and function

from

$47.99

New Standard Replacement A/C Refrigerant Suction Hose

Product Features:

Meets All Federal Motor Safety Standards
No Drilling Needed For Installation
No Modifications Needed For Installation
Direct Fit Replacement For Your Vehicle
Same Form Fit And Function As OE
Check Out The Large Selection Of Parts Available For Your Vehicle

from

$19.99

Permatex’s The Right Stuff 1 Minute Series offers the fastest return to service in just 1 minute! This leak-proof, elastomeric “Formed-in-place” material is more reliable and longer lasting than pre-cut gaskets. It is blowout resistant and protects against leaks and seepage caused by vibration and thermal expansion. The Right Stuff 1 Minute Grey is specified for high torque and high vibration applications and is formulated to meet or exceed performance standards for long-term sealability, durability and handling.

Product Features:

Designed to perform under higher torque loads associated with engines having closely spaced bolt patterns
Sensor-safe, non-corrosive, RTV silicone
Protects against leaks caused by vibration and thermal expansion
Meets performance specs of OE silicone gaskets
Quickly returns vehicle to service in just 1 minute

from

$19.99

Carquest premium engine management products provide the right products for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions.

from

$268.47

ACDelco Professional Water Pumps are the best way to make sure you have the proper heat protection for the engine in your car, truck or SUV. Built to meet the latest manufacturer-specified designs, ACDelco Water pumps, in both cast-iron and aluminum, are thoroughly pressure-tested to prevent leaks, and feature uniform wall sections and smooth coolant-flow cavities for efficient operation and superior engine protection. High-quality bearings, heat-treated impellers and coated seals mean long life and trouble-free ownership.

Product Features: