from

$71.24

Thermostat Assembly

from

$92.86

Expansion Tank

from

$28.49

Specifically designed to perform under higher torque loads associated with engines having closely spaced bolt patterns (typically import vehicles). This product is blowout resistant, allowing leakproof gaskets to be made and put into service in just one minute. Sensor-safe, The Right Stuff GREY seals instantly, forming a reliable, long lasting elastomeric rubber gasket that outperforms pre-molded gaskets. Specified by major import OEMs, this material is resistant to powertrain fluids (oil, coolant and ATF) and operates in environments to 450°F (232°C) continuous; 500°F (260°C) intermittent.

Product Features:

Ideal for rigid cast aluminum parts
Meets OEM Specifications
Sensor safe & non-corrosive
Performs under higher torque loads associated with engines having closely spaced bolt patterns (typical of import vehicles)
Blowout resistant, allowing leakproof gaskets to be made in just one minute
Seals instantly, forming a reliable, long lasting elastomeric rubber gasket
Superior resistance to powertrain fluids including engine oil, transmission fluid, gear lube and coolants
Temperature range -60°C to 260°C (-75°F to 500°F) intermittent
Applications: Automotive, industrial and marine gaskets, valve covers, gearbox covers, pumps, compressors, oil pans, thermostat housings, water pumps, etc.

from

$40.99

Tester adapter for the MT-300 cooling system pressure testers. Professional grade test equipment to ensure an automotive cooling system is operating at the correct pressure. Made from high quality materials to ensure durability. Designed to test automotive coolant caps.

Product Features:

Machined metal construction
Works with MT-300 pressure tester
Tests coolant caps
Professional quality

from

$3.39

Level Sensor Grommet

from

$57.99

The Engine Coolant Temperature Sensor determines the exact temperature of the engine coolant by sending an analog signal to the ECM to censure proper air/fuel ratio along with proper operation of the cooling fan(s) and temperature gauge. The Engine Coolant Temperature Sensor may be located on the cylinder head, engine block, thermostat housing or intake manifold. Reasons for replacement include: check engine light illumination, erratic or no temperature gauge operation, erratic or no cooling fan operation, and engine overheating.

Product Features:

OE MATCHED: Wires and probe length match OE. Mounting clip(s) included where applicable
FASTER RESPONSE TIME: Thermal conductive grease inside brass housing increases sensor response time
THE NTK DIFFERENCE: Thread sealant/o-ring installed where applicable. Thermistor placement within the housing matches OE to ensure proper output. Proper thermal conductive grease to provide accurate temperature transfer to the thermistor

from

$53.99

We are proud to offer this CARQUEST product line: CARQUEST Water Outlets. Our products are engineered and tested to provide years of trouble free operation and designed to be hassle free OE replacement part that meets and/or exceeds OE standards. Backed by over 50 years of mobile temperature control experience, fix it once and fix it right with CARQUST Water Outlets and Thermostat Housings.

Product Features:

Meets and/or exceeds OEM standard
Includes quality gasket or O-ring to ensure proper seal (where applicable)
100% virgin resin material to insure durability
100% leak tested
Direct-fit replacement for ease of installation

from

$17.49

Manufactured to meet all OEM specifications. Designed to be easy to install and remove. Manufactured from high quality components with proper relief and vacuum valves. Quality tested to stand up to even the most demanding automotive cooling systems.

Product Features:

Maintains proper cooling system pressure
Easy installation and removal
100% tested to ensure proper pressure and longevity
Meets all OEM specifications

from

$24.32

Water Pipe

from

$35.26

Eurospare offers a full line of thermostats to replace your original equipment thermostat. This includes a wide variety of temperature ranges all designed to operate within OEM specifications.

Product Features:

Strict quality control, and functional testing
Self-cleaning and self-aligning thermostat valve
Original equipment design provides exact fit and performance
Precise sealing edges reduce leakage and premature cooling
Temperature sensitive heat motor provides consistent valve response for smooth performance and precise engine cooling
Stainless steel assembly and springs are engineered for long life

from

$19.99

Permatex’s The Right Stuff 1 Minute Series offers the fastest return to service in just 1 minute! This leak-proof, elastomeric “Formed-in-place” material is more reliable and longer lasting than pre-cut gaskets. It is blowout resistant and protects against leaks and seepage caused by vibration and thermal expansion. The Right Stuff 1 Minute Grey is specified for high torque and high vibration applications and is formulated to meet or exceed performance standards for long-term sealability, durability and handling.

Product Features:

Designed to perform under higher torque loads associated with engines having closely spaced bolt patterns
Sensor-safe, non-corrosive, RTV silicone
Protects against leaks caused by vibration and thermal expansion
Meets performance specs of OE silicone gaskets
Quickly returns vehicle to service in just 1 minute

from

$6.99

Permatex Ultra Grey is specified for high torque and high vibration applications. Ultra Grey offers a sensor-safe, low odor, non-corrosive formula and is OEM specified to fit dealership warranty requirements. This high performance gasket maker meets performance specs of OE silicone gaskets and can be used on high torque and vibration applications such as valve covers, water pump, intake manifold end seals ad thermostat housings.

Product Features:

High torque and rigidity
Sensor-safe, non-corrosive formula
OEM specified
Low-odor, non-corrosive formula
Ideal for closed spaced bolt patterns

from

$6.00

Water Outlet O-Ring

from

$29.65

Motorcraft Water temperature sensors are designed for durability and electrical performance. Motorcraft digital Water temperature sensors are designed to work with Ford and Lincoln transmissions and engine control computers.

Product Features:

Sensors are tested according to Ford Motor Company noise, vibration and harshness (NVH) engineering standards
Recommended by Ford Motor Company

from

$260.97

Built to meet the latest OE manufacturer-specified designs, Rein Auxiliary Water Pumps are the best way to make sure you have the proper heat protection for the engine in your vehicle. Eliminating the mechanical commutation system leaves the durability of the rotor bearings as practically the only limiting factor for service life. In addition to that, the lower number of moving parts results in significantly reduced noise.

Product Features:

OE Quality, reliability and service life
Leak-proof sealing of the drive
Fuel savings and reduced emissions
Cooling even without operation of the engine
CO²-reduction by optimized efficiency, speed control and reduced weight
Coverage of a wide hydraulic performance range
Reduced noise level

from

$285.99

This engine auxiliary water pump is designed to match the fit and function of the original pump on specified applications, and is engineered for reliable performance and durability.

Product Features:

Direct replacement – this engine auxiliary water pump is designed to match the fit and function of the original pump on specified applications
Restores functionality – reliable replacement for an original pump that has failed to provide sufficient water flow
Durable construction – this part is made from quality materials to ensure reliable performance and long service life
Trustworthy quality – backed by team of product experts in the United States and more than a century of automotive experience

from

$77.52

Coolant Outlet Flang

from

$26.99

Permatex Ultra Grey is specified for high torque and high vibration applications. Ultra Grey offers a sensor-safe, low odor, non-corrosive formula and is OEM specified to fit dealership warranty requirements. This high performance gasket maker meets performance specs of OE silicone gaskets and can be used on high torque and vibration applications such as valve covers, water pump, intake manifold end seals ad thermostat housings.

Product Features:

High torque and rigidity
Sensor-safe, non-corrosive formula
OEM specified
Low-odor, non-corrosive formula
Ideal for closed spaced bolt patterns

from

$5.22

The Eurospare Engine Coolant Thermostat O-Ring is an ideal high quality aftermarket replacement that is manufactured to meet or exceed OE specifications for fit, form, and function.

Product Features:

Seals the thermostat housing and helps prevent coolant from leaking from the engine for proper engine temperature
Premium aftermarket replacement
Provides performance and dependability
Manufactured to meet OE specifications

from

$724.01

Radiator

from

$199.99

Carquest Premium radiators are designed and engineered for maximum performance, using the highest-grade materials to ensure all radiators meet or exceed original equipment (O.E.) fit, form and function. Carquest Premium radiators are built by manufacturers that meet IATF 16949 certified framework, an internationally recognized proof of quality in the automotive industry. Most modern vehicles use radiators with plastic tanks and our parts are engineered with integrated ribbing to prevent damage during thermal cycling. Carquest Premium radiators are also 100% tested to ensure a durable, leak-free cooling system repair.

Product Features:

Thermal tested under real-life temperature simulations
High tensile strength aluminum for maximum crimp strength
Plastic tanks are engineered with integrated ribbing for added strength to withstand cracks, bowing and distortion during thermal cycles
Thermal expansion slots extend core life and reduce failure rates by allowing improved core expansion and contraction during systematic heat cycles
Oil cooler designs meet or exceed OE standards, keeping the vehicle’s engine and transmission performing at optimal conditions
OEM grade, premium fittings for transmission or engine oil coolers (where applicable)

from

$491.75

Plastic Tank / Aluminum Core Radiator The Nissens Radiator flat tube and double folded fin design offers a significantly better cooling capacity and provides a stronger exterior resisting impacts from stones. This advanced design helps to prevent damage which would negatively affect the cooling capacity and engine performance.

Product Features:

OE-Equivalent.
Direct fit for easy installation.
OE Style mounting brackets and hose connections.
Integrated transmission oil cooler when applicable.
Compact and lightweight.

from

$138.99

Carquest Premium drive motor inverter cooler water pumps are 100% new, high-quality parts that meet or exceed original equipment (O.E.) specifications. All components, including the housing, impeller, controller, gaskets, and seals are designed for long-lasting service life. These electric water pumps are supplied with the gaskets or seals necessary for installation. Our Carquest Premium auxiliary water pumps undergo stringent testing to ensure superior performance that we stand behind with an industry-leading warranty.

Product Features: