2010 Freightliner Sprinter 2500 Ignition and Tune-Up Products
More 2010 Freightliner Sprinter 2500 Ignition and Tune-Up Products Categories
If you’re looking for an original Ignition and Tune-Up Products replacement for a 2010 Freightliner Sprinter 2500, you can search through our selection below. You’ll also find aftermarket and OEM Ignition and Tune-Up Products to meet your needs.
Essential 2010 Freightliner Sprinter 2500 Ignition and Tune-Up Products
Beru – Electronic Glow Plug Control Unit (Part No.F11051154451BER)
from
$227.86
The Beru Electronic Glow Plug Control Unit is an OE-recommended replacement and will provide the same performance, durability, and service life as your factory original equipment.
Product Features:
See More
Product Features:
- Extremely short heating up time (up to 1,100C in 2 seconds!)
- Safe start even at temperatures of -25C
- Electronically controlled pre-heating, intermediate and post-heating
- Immediate stable idling and clean load assumption
- Minimized emission of pollutants and fuel consumption in the warm-up phase
- Specially designed for diesel engines with direct injection
- On board diagnosis compatible
- Meets the latest requirements of the strict EURO pollution standard
NGK – Ceramic Glow Plugs (Part No.F1100464957NGK)
from
$42.55
The new ceramic high-temperature glow plug (NHTC glow plug, New High Temperature Ceramic) has a fully ceramic heating element. It reaches an operating temperature of 1000C in two seconds and can afterglow for up to ten minutes at temperatures up to 1350C. That means: It glows in push phases or during the regeneration phase of the particle filter and thereby minimizes the particle emissions during this time. The NHTC ceramic glow plug was specially developed by NGK to enable automobile manufacturers to comply with the Euro 4 and Euro 5 emissions standards. One of the goals of these standards is to reduce the compression ratio in diesel engines. NHTC glow plugs reach a temperature of 1,000C in less than two seconds and can after-glow for more than ten minutes at temperatures of up to 1,350C. Optimal combustion is assured even with low compression ratios. In addition, the NHTC glow plug can glow intermediately to prevent cooling of the particle filter in deceleration phases. Ceramic glow plugs from NGK guarantee a long service life and ensure a reliable and fast ignition, even at the lowest outside temperatures. At the same time, they reduce harmful emissions.
See More
Bosch – Glow Plug (Part No.F11001902364BOS)
from
$20.16
Bosch Duraterm Glow Plug Technology With a long history of diesel fuel injection expertise and innovation, Bosch leads the way in glow plug technology with its patented Duraterm dual-control coil design. This technology utilizes a self-regulating system that reduces glow wait time by more than 50%. The patented dual control regulating and heating coil system effectively directs current draw, enabling the glow plug to reach higher temperatures more quickly for faster engine start-up. For vehicles with a post-glow control system, this advanced technology results in a post-glow heating phase which allows for more efficient overall engine performance.
Product Features:
See More
Product Features:
- Glow plug reaches higher temperatures more quickly for fast engine start-up
- Regulating coil controls current draw for rapid heat-up of heating coil
- Heating coil provides rapid heat-up of the glow tube and quick start-up
- Glow tube material resists corrosion and vibration for long service life
- Fine-grained ceramic insulating powder provides superior electrical insulation and high thermal conductivity
- Twin Viton seals protect coils from exhaust gas damage for long life
- Connectors designed to OE specifications precise fit and easy installation
NGK – Ceramic Glow Plugs (Part No.F110088273NGK)
from
$62.69
The new ceramic high-temperature glow plug (NHTC glow plug, New High Temperature Ceramic) has a fully ceramic heating element. It reaches an operating temperature of 1000C in two seconds and can afterglow for up to ten minutes at temperatures up to 1350C. That means: It glows in push phases or during the regeneration phase of the particle filter and thereby minimizes the particle emissions during this time. The NHTC ceramic glow plug was specially developed by NGK to enable automobile manufacturers to comply with the Euro 4 and Euro 5 emissions standards. One of the goals of these standards is to reduce the compression ratio in diesel engines. NHTC glow plugs reach a temperature of 1,000C in less than two seconds and can after-glow for more than ten minutes at temperatures of up to 1,350C. Optimal combustion is assured even with low compression ratios. In addition, the NHTC glow plug can glow intermediately to prevent cooling of the particle filter in deceleration phases. Ceramic glow plugs from NGK guarantee a long service life and ensure a reliable and fast ignition, even at the lowest outside temperatures. At the same time, they reduce harmful emissions.
See More
NGK – Metal Glow Plug: Self-Regulating Metal Type, Y-745U (Part No.4705)
from
$26.99
NGK metal glow plugs are trusted by OEM diesel engine manufacturers around the world to perform under the harshest conditions. NGK metal glow plugs are equipped with a heating coil in a glow rod made of heat-resistant magnesium oxide between the heating and regulating coils. Magnesium oxide is an outstanding thermal conductor (quickly dissipating heat), while protecting the heating coils from vibration and shock. NGK metal glow plugs feature excellent gas-tight sealing qualities that deliver superior electrical insulation and protection against combustion gas. NGKs metal composition helps reduce carbon accumulation to prevent short circuits, while the unique shell design provides excellent heat transfer.
Product Features:
See More
Product Features:
- ACTUAL OE or EQUIVALENT DESIGN: OEM quality construction metal glow plug
- SUPERIOR DURABILITY: Metal glow plugs are designed to withstand thermal shock due to quick changes in temperature
- FAST HEATING PERFORMANCE: Fast heat up enables smooth engine starts even in extreme weather conditions
- CLEAN PERFORMANCE: Constant afterglow temperature minimize noxious pollutants
- RECOMMENDED USAGE: Best for diesel engines with OE metal glow plugs
Autolite – Diesel Engine Glow Plug: High Intensity Concentrated Heat, Reliable Starts (Part No.1118)
from
$16.99
Starting a diesel engine? Check out Autolite glow plugs. They’re dependable and long-lasting, the perfect plug for a variety of diesel applications.
Product Features:
See More
Product Features:
- Diesel engines depend on high heat in the combustion chamber to ignite the fuel. When you cold start a diesel engine, there isn’t enough heat to ignite. Glow plug warms the combustion chamber to start the fuel ignition.
- These glow plugs fit a variety of diesel applications. If you’re experiencing problems starting your diesel engine, it may have burnt out glow plugs.
- Reaches temperatures hot enough to start in 30 seconds or less
- For dependability and long-lasting performance, use Autolite glow plugs
Beru – High Tech Type GE & GN Glow Plugs (Part No.F1100453540BER)
from
$19.54
High-tech glow plugs, pre-start and post-glowing (type GE, type GN) Diesel starting is now quicker, more reliable and more environmentally friendly. BERU is one of the leading manufacturers of glow plugs in the world – and inventor of numerous innovations in Diesel cold start technology The latest diesel car engines are equipped with the innovative three-phase glow technology (pre-heating – heating during starting – post-heating). This means: the glow plug not only heats prior to and during the starting phase, but also up to 180 seconds after starting. This protects the environment and the engine. BERU offers 3-phase glow plugs of the GE and GN type. GE and GN glow plugs in 2-coil technology have not only a heating coil to maintain the optimal heating temperature, but also have a regulator coil that effectively protects the glow plug from overheating. In this way BERU glow plugs are extremely reliable and durable. The GE glow plug is a performance-optimized, controlled glow plug used in engines of the latest generations. The fast heating of the glow plug and the controlled operation are provided by a programmable micro-controller in the glow time control unit.
Product Features:
See More
Product Features:
- Super quick start glow plugs in new, slim shape
- Extremely short pre-heating time: from 2 seconds
- Reliable starting (even at -30C)
- Can be used for post-heating, as a result environmentally friendly: up to 40% less pollutant emissions during the warm up phase
- No more cold start knocking
- Quieter engine running
- Protects the engine during starting
NGK – Ceramic Glow Plug: New Ceramic High Temperature Type, CZ303 (Part No.9970)
from
$44.99
NGK’s patented NHTC (New High Temperature Ceramic) glow plugs were developed for OEM diesel engine manufacturers to comply with ever-stricter emissions standards. Compared to metal glow plugs, NHTC glow plugs have a more robust, fully ceramic heating element which is encased in a ceramic insulator. NGK NHTC glow plugs reach operating temp of 1,000 degrees C in less than 2 seconds and can after-glow for more than 10 minutes at temps of up to 1,350 degrees C. Silicon nitrate ceramic material, combined with optimized shape and joining process provide superior thermal shock and vibration resistance, ensuring stable engine starts. Fine ceramic heater provides durability in high-temperature conditions, improves combustion and reduces emissions.
Product Features:
See More
Product Features:
- ACTUAL OE or EQUIVALENT DESIGN: OEM quality construction ceramic glow plug
- PATENTED TECHNOLOGY: Exclusive NHTC New Ceramic High Temperature design
- NEAR-INSTANT HEATING: Fully ceramic heating element reaches operating temperature in less than two seconds
- CLEAN PERFORMANCE: Constant afterglow temperature minimize noxious pollutants
- RECOMMENDED USAGE: Best for diesel engines with OE ceramic glow plugs
Popular 2010 Freightliner Sprinter 2500 Ignition and Tune-Up Products Categories
2010 Freightliner Sprinter 2500 Ignition and Tune-Up Products
You count on your 2010 Freightliner Sprinter 2500 to run right. That means taking care of it with regular maintenance, necessary repairs, and the right parts. Advance Auto Parts can help with all of that thanks to our extensive inventory of trusted Ignition and Tune-Up Products. With 2 Ignition and Tune-Up Products ranging in price from $19.54 to $227.86, you’re sure to find everything you need for your 2010 Freightliner Sprinter 2500.
Brands matter. If you want to shop a specific Ignition and Tune-Up Products brand, we stock 1 different brands like Beru. 2010 Freightliner Sprinter 2500 Ignition and Tune-Up Products start as low as $19.54!
One of the best ways to find top quality OEM or aftermarket Ignition and Tune-Up Products is by asking professionals. Short of that, you can shop with confidence thanks to our 1 extensive product reviews on 2010 Freightliner Sprinter 2500 Ignition and Tune-Up Products.
Did we mention you can order your Ignition and Tune-Up Products from our online catalog and have them shipped right to your garage? Or, if you feel like seeing the parts first-hand, search for your nearest Advance Auto Parts location above and pick up in-store when you’re ready. Browse our full Ignition and Tune-Up Products inventory for your 2010 Freightliner Sprinter 2500 below to get started!
Top-Rated Ignition and Tune-Up Products Brands For Your 2010 Freightliner Sprinter 2500
Trusted Ignition and Tune-Up Products OEM and aftermarket product brands are what Advance Auto Parts specializes in. The brands we work with are sure to keep that 2010 Freightliner Sprinter 2500 running right for years to come. In our inventory you’ll find brands like Beru, and even more.
Popular Beru Ignition and Tune-Up Products
You’ll find popular Beru brand products across Glow Plugs. All are waiting to get your 2010 Freightliner Sprinter 2500 back on the road. Some of the top-rated Beru products in these categories are:
