1998 Dodge Ram 3500 Differentials

Product Features:

• Side gear thrust washer for Dana Spicer 60, 70, 70U, 70HD and 80
• Fits standard open differentials only

Royal Purple HMX SAE 5W-30 High-Mileage Synthetic Motor Oil, 1 quart is specifically designed to minimize wear and restore lost performance in engines with more than 75,000 miles. Formulated with robust zinc/phosphorus anti-wear compounds combined with Royal Purple’s proprietary additive technology Synerlec, HMX is chemically enhanced to revitalize hardened seals, reducing oil consumption common in high-mileage engines. In addition, HMX is fortified with stout detergents to remove engine build-up and deposits, maintain cleanliness and promote engine longevity.

Product Features:

• Specifically designed to minimize wear and restore lost performance in engines with more than 75,000 miles
• Formulated with robust zinc/phosphorus anti-wear compounds combined with royal purple’s proprietary additive technology
• Hmx is chemically enhanced to revitalize hardened seals, reducing oil consumption common in high-mileage engines
• Reduces friction and metal-to-metal contact for peak engine performance
• Also provides outstanding oxidation resistance to safely extend oil drain intervals, and an ionic attraction to metal surfaces, providing protection and minimizing wear at start-up
• High-Mileage Formula: Specifically designed for engines with more than 75,000 miles, this full synthetic engine oil helps minimize wear and restore lost performance.

Product Features:

• Brand may vary by location

aFe Power’s new rear differential cover brings performance engineering to the protection of your axle’s differential. This differential cover is constructed out of durable cast aluminum with reinforced ribs for maximum strength. This cover comes with all necessary hardware for easy installation. Pro Series differential covers include an oil level sight glass and magnetic deep reach fill plug. This cover is finished with black powder-coating and machined fins for a distinctive look._x000d__x000d_Increased Oil Capacity: This cover has an increased oil capacity over stock for better performance over a longer duration._x000d__x000d_Built-in Internal/External Fins: Built-in internal and external fins transfer heat from the oil to the outside air for maximum cooling._x000d__x000d_Magnetic Plugs: This system incorporates a magnetic drain and deep reach fill plug to capture loose particles for maximum protection._x000d__x000d_Calibration Plug: Calibration plug set to the factory oil level to eliminate overfilling._x000d__x000d_Oil Level Sight Glass: A pre-installed oil level sight glass allows quick and easy oil inspection._x000d__x000d_When it comes to engineering for power, performance, protection and value, aFe Power is the only choice.

Product Features:

• Constructed out of durable cast aluminum
• Wrinkle-black powder-coating with machined fins
• Dual neodymium magnetic plugs are used for maximum gear protection
• Large oil level sight glass with calibration plug set to the factory oil level to eliminate overfilling

Motive Gear offers some of the toughest drive train components on the market today. If you are looking for the largest line of performance ring and pinion gear options available with gear sets in a wide range of ratios for nearly every application, both on and off-road, check out Motive Gear. Motive Gear products can be found in the winner’s circle at racing events worldwide. The superior quality of Motive Gear components is the result of years of racing development, outstanding design and state-of-the-art manufacturing methods. Extensive testing is performed on all products by our in-house engineers.

Product Features:

• CRUSH SLEEVE 9.5 GM 14BLT MIN ORDER 1000

USA Standard ring & pinion sets are the right choice to add confidence to your install. USA Standard Gear offers a full line of ring & pinion sets for a variety of common & hard to find applications. USA standard gear offers a standard one year warranty against defects on their ring & pinion sets.

Product Features:

• Fits standard rotation Dana Spicer 60
• 9.75″ ring gear diameter
• 29 spline pinion
• 12 ring gear bolts
• 3.54 ratio

Product Features:

• Pinion nut washer for Chrysler 7.25″, 8.25″, 8.75″ with 29 spline pinion, Jeep JK rear, Dana Spicer 60, 70, 70U and 70HD and 2007-2010 Ford 10.5″

Product Features:

• Clutch guide for Chrysler 9.25″, Dana Spicer 44 and Dana Spicer 60
• For Trac Loc positraction applications only

Dana 60 pinion gear Thrust washer, standard Open & TracLoc (also 8.75″ Chrysler STD) Dana 70 2PC.

Product Features:

• Pinion gear thrust washer for Dana Spicer 60
• Fits standard open and Trac Loc applications

Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings & races can be reused. This kit uses Timken bearings and races along with a high quality pinion seal and small parts. Included in this kit are the pinion bearings and races, pilot bearing (if applicable), crush sleeve (if applicable), complete pinion shim kit, pinion nut, thread locker, and marking compound with brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your pinion gear.

Product Features:

• Fits 2010 and down GM and Chrysler 11.5″
• Included are pinion bearings and races, pinion seal, crush sleeve, complete pinion shim kit, and marking compound with brush.

Product Features:

• Pinion depth shim kit
• Fits Dana Spicer 80 4.125″ design

Dana 80 TracLoc clutch set round design (remove 4 plates 4 V-Type).

Product Features:

• Clutch kit
• Fit Dana Spicer 80 Trac Loc positraction

Dana 50 Dana 60 Dana 70 & Dana 80 roll PIN, 0.225″ DIA, for X/P shaft, 1.87″ LNG.

Product Features:

• Roll pin for Dana Spicer 50, 60, 70, 70U, 70HD and 80
• 0.225″ diameter
• 1.870″ long

Differential

Yukon Master Overhaul kits give you all the high quality parts you need to start & finish every differential job. Yukon offers more tailor-made kits than any other manufacturer in the industry to meet your specific installation needs. This kit uses Timken bearings and races along with high quality seals and small parts. Included in this kit are carrier bearings and races, pinion bearings and races, pinion seal, complete shim kit, pinion nut, crush sleeve (if applicable), oil baffles and slingers (if applicable), Thread locking compound, and marking compound with brush. Yukon’s Master Overhaul kits are the most comprehensive and complete kits on the market. They do extensive research to ensure that every kit is specially tailored to your application.

Product Features:

• Fits Dana Spicer 80 with 4.125″ O.D. pinion bearing
• Included are Timken bearings and races, pinion bearings and races, pinion seal, complete shim kit, ring gear bolts, pinion nut, oil baffles and slingers , thread locker, marking compound with brush, and silicone.

Product Features:

• Outer oil slinger for Dana Spicer 60, 70, 70U and 70HD

Zip Locker soleniod valve.

Product Features:

• Solenoid valve

Demand genuine Spicer. Dana design, engineering, testing and manufacturing processes all work in conjunction with one another to ensure unparalleled performance that non genuine parts simply cannot deliver.

Extra large clamshells for use with Dana 70HD, Dana 80, AAM 11.5″, Ford 9.75″, Ford 10.25″ & Ford 10.5″.

Product Features:

• Extra Large clamshell
• Fits carrier bearing puller

National Oil Seals & Bearings offer a full line of premium oil seals and bearings.

Product Features:

• Premium bearing design matches OEM specifications
• Precision manufactured using premium-grade steel for outstanding durability and performance
• Crowned raceways and rollers to ensure even load distribution for maximum life
• Industry leading coverage
• Professional technicians know they can depend on National

Product Features:

• USA Standard Gear heavy-duty cross pin shaft
• Fits Dana Spicer 60
• Works with Spartan Locker or standard open spider gears

Bearing race driver. No return.

Product Features:

• Bearing race driver
• Fits M802011 race
• All steel construction

Yukon Carrier installation kits are great, low cost kit for carrier changes such as Positraction or locker upgrades. Carrier installation kit for Dana 60 differential. This kit contains carrier bearings, races and shims.

Product Features:

• Fits Dana Spicer 60
• Includes carrier bearings and races and carrier shim kit

Motive Gear offers some of the toughest drive train components on the market today. If you are looking for the largest line of performance ring and pinion gear options available with gear sets in a wide range of ratios for nearly every application, both on and off-road, check out Motive Gear. Motive Gear products can be found in the winner’s circle at racing events worldwide. The superior quality of Motive Gear components is the result of years of racing development, outstanding design and state-of-the-art manufacturing methods. Extensive testing is performed on all products by our in-house engineers.

Product Features:

• FULL SPOOL DANA 60 35 SPLINE 4.56 & UP

Product Features:

• Carrier shims for Dana Spicer 60 and 70U