1995 Ford Mustang Differential Covers

“Replacement outer oil slinger for Ford 7.5″”, 8.8″”, 9″”, 10.25″”, Nissan Titan rear, Dana 44 Rubicon & 44 JK non-Rubicon.”

These Yukon replacement diff covers are a direct bolt-on.

These Yukon replacement diff covers are a direct bolt-on.

These Yukon replacement diff covers take your rig a step beyond the boring factory look. They are the stock OE design finished in chrome.

These Yukon replacement diff covers take your rig a step beyond the boring factory look. They are the stock OE design finished in chrome.

Our engineers designed the line of Hi-Tek differential covers to not only look good but address a number of weaknesses of the factory stamped steel covers. First, they started by constructing the covers of thick A356.0-T6 aluminum, which dissipates heat much faster than the factory steel unit keeping the fluid temperature lower under high-stress loads vs. a steel cover. Then for added durability, we added a reinforced center bar for extra strength along with load bolts to help prevent bearing cap deflection under severe loads. The internal shape of the cover retains the smooth round back internally to help keep the fluid flow going over the ring gear to properly lubricate the gears and bearings. Additional features include a magnetic drain plug for catching ferrous metal particles, MIL-Spec black anodized finish, machined B&M logo, and all necessary hardware and easy to follow detailed instructions for a quick and simple installation you can do at home. Note: Does not include gasket.

This cover has an increased oil capacity over stock for better performance over a longer duration. Built-in internal and external fins transfer heat from the oil to the outside air for maximum cooling. This cover incorporates a magnetic drain and deep reach fill plug to capture loose particles for maximum protection. A calibration plug is set to the factory oil level to prevent overfilling. A pre-installed oil level sight glass allows quick and easy oil inspection.

Our engineers designed the line of Hi-Tek differential covers to not only look good but address a number of weaknesses of the factory stamped steel covers. First, they started by constructing the covers of thick A356.0-T6 aluminum, which dissipates heat much faster than the factory steel unit keeping the fluid temperature lower under high-stress loads vs. a steel cover. Then for added durability, we added a reinforced center bar for extra strength along with load bolts to help prevent bearing cap deflection under severe loads. The internal shape of the cover retains the smooth round back internally to help keep the fluid flow going over the ring gear to properly lubricate the gears and bearings. Additional features include a magnetic drain plug for catching ferrous metal particles, natural finish, machined B&M logo, and all necessary hardware and easy to follow detailed instructions for a quick and simple installation you can do at home. Note: Gasket not included.

This cover has an increased oil capacity over stock for better performance over a longer duration. Built-in internal and external fins transfer heat from the oil to the outside air for maximum cooling. This cover incorporates a magnetic drain plug to capture loose particles for maximum protection. A calibration plug is set to the factory oil level to prevent overfilling. Our optional deep reach magnetic fill plug (PN: 46-00002) and oil level sight glass (PN: 46-00001) are great additions to combine with this cover. When it comes to engineering for power, performance, protection and value, aFe POWER is the only choice.