from

$189.99

8″ standard Open case, bare.

Product Features:

Standard open carrier case
Fits Toyota 8″ with 4 cylinder engine

from

$14.99

T100 & Tacoma w/LOC pinion nut.

Product Features:

Pinion nut
Fits Toyota Tacoma and T100 with factory locking differential

from

$126.99

Bearing race driver front Toyota 7.5″, 8″, Landcruiser, and the Suzuki Samurai. No return. (TOY30306).

Product Features:

Bearing race driver
Fits 30306 race
All steel construction

from

$204.99

Product Features:

Spider gear kit
Fits Toyota 8″ with 4 cylinder engine
Includes two side gears, two pinion gears, cross pin shaft, roll pin spider gear thrust washers.

from

$42.99

Product Features:

MINI-INSTL KT-TOYOTA 7.5″

from

$55.99

Differential Pinion

from

$236.99

USA Standard Master Overhaul kits let you finish your install with confidence. This kit uses Koyo bearings and races. Included are carrier bearings and races, pinion bearings and races, pinion seal, complete shim kit, ring gear bolts, pinion nut, crush sleeve (if applicable), oil baffles and slingers (if applicable), threading locking compound, marking compound with brush and gasket.

Product Features:

Fits Toyota 8″ and 4 cylinder engine, 1985 and down or 1986 and up with aftermarket ring and pinion set
Uses Koyo bearings and races
Included are carrier bearings and races, pinion bearings and races, pinion seal, complete shim kit, ring gear bolts, pinion nut, crush sleeve, thread locker, marking compound with brush and gasket.

from

$14.29

Product Features:

Brand may vary by location

from

$258.99

Yukon standard open spider gear kit for Toyota 8″ 4-cylinder with 30 spline axles. Yukon uses higher quality materials and better techniques than OEM to ensure a longer lasting spider gear set. All components come with a one year warranty against manufacturing defects.

Product Features:

Spider gear kit
Fits Toytoa 8″ 4 cylinder open differential
Includes two side gears, two pinion gears, cross pin shaft, roll pin spider gear thrust washers.

from

$407.99

Yukon Master Overhaul kits give you all the high quality parts you need to start & finish every differential job. Yukon offers more tailor-made kits than any other manufacturer in the industry to meet your specific installation needs. This kit uses premium bearings and races along with high quality seals and small parts. Included in this kit are carrier bearings and races, pinion bearings and races, pinion seal, complete shim kit, ring gear bolts, pinion nut, crush sleeve (if applicable), Thread locking compound, and marking compound with brush. Yukon’s Master Overhaul kits are the most comprehensive and complete kits on the market. They do extensive research to ensure that every kit is specially tailored to your application. Includes side shims and seals.

Product Features:

Fits standard rotation Toyota 7.5″ front with 6 cylinder engine
Included are Timken bearings and races, pinion bearings and races, pinion seal, axle seals, complete shim kit, ring gear bolts, pinion nut, crush sleeve , oil baffles and slingers , thread locker, marking compound with brush, and silicone.

from

$99.99

Zip Locker soleniod valve.

Product Features:

Solenoid valve

from

$276.99

Yukon small hole yoke for ’82 and older Toyota T100 and Tacoma (with locker) with 27 spline pinion. All Yukon yokes come with a one year warranty against manufacturing defects.

Product Features:

Fits Toyota Tacoma and T100 with factory locking differential
27 spline

from

$49.99

7.5″ Toyota Spartan locker cross pin.

Product Features:

USA Standard Gear heavy-duty short cross pin shaft
Fits Toyota 7.5″
Works with Spartan Locker or standard open spider gears

from

$16.99

Toyota 8″ & V6 pinion nut washer.

Product Features:

Pinion nut for Toyota 8″ and V6

from

$224.99

Product Features:

USA Standard spool
Fits Toyota 8″ with 4 cylinder engine
30 spline
All steel construction

from

$26.99

Spartan spring & pin kit, fits smaller designs.

Product Features:

Replacement spring and pin kit for Spartan Locker
Fits Dana 30, Dana 44, AMC Model 20, AMC Model 35, and Toyota designs
Includes 4 springs and 4 alignment pins

from

$8.49

Value-priced bearing meets all cataloged application requirements.

Product Features:

Brand may vary by location

from

$866.99

Replacing a worn wheel bearing usually requires a time-consuming procedure with a shop press. This Dorman OE FIX loaded axle includes all critical components already assembled for a fast, simple, safe install..

Product Features:

Easier installation – this loaded axle assembly includes a new axle shaft, wheel bearing, hub and backing plate pre-assembled and ready to install right out of the box.
Time saver – eliminates frustrating, unpredictable work required to replace bearings without damaging other components
Simpler solution – eliminates the need to use potentially dangerous shop press to perform complete bearing repair
Quality tested – this part has undergone try-on, corrosion and material testing to ensure a quality fit and long service life

from

$404.99

RngPnnKt

from

$10.99

V6 standard Open pinion gear Thrust washer.

Product Features:

Pinion gear thrust washer
Fits Toyota V6

from

$14.49

Formulated to meet the specific requirements of Toyota, Lexus, and Scion vehicles equipped with conventional (non-CVT) transmissions that require the use of Toyota ATF WS. Recommended for service-fill in all Toyota, Lexus, and Scion automatic transmissions where ATF WS is specified. Fuel economy demands and more sophisticated electronic controls have made automatic transmissions not only more complex, but also unique to each vehicle manufacturer. Long gone are the days of having just a couple choices of automatic transmission fluid type. IDEMITSU is the factory fill Automatic Transmission Fluid (ATF) supplier to most Asian imports. IDEMITSU application-specific ATF products match the exact friction materials and performance requirements of each different vehicle model for which they are made.

Product Features:

Precisely engineered frictional characteristics guarantee smooth shifting and outstanding anti-shudder performance
Optimized viscosity and advanced friction reducing additive technology provide exceptional fuel economy performance
Excellent resistance to oxidation and thermal breakdown provide long fluid life and extended protection
Exceptional wear protection of gears and bearings
Provides superior deposit control and protects metal surfaces from rust and corrosion
Excellent seal compatibility and conditioning reduces risk of fluid leaks due to seal shrinkage, hardening and cracking

from

$689.99

The Yukon carrier bearing Puller works with an impact gun to quickly and safely remove carrier bearings without damaging them. This unit comes with a handy bench top stand and works with up to most standard one ton applications. This unit is works with differentials up to one-ton applcations. It is not compatible with Dana 70HD, Dana 80, 10.25″ & 10.5″ Ford, or GM & Chrysler 11.5″ differentials.

Product Features:

Carrier bearing puller
Works with an impact gun to safely and easliy remove carrrier bearings
Not compatible with Dana 70HD, Dana 80, Ford 10.25″ and 10.5″ or Gm and Chrysler 11.5″ applications

from

$78.99

Product Features:

Seal housing for Toyota 8″ and V6
Includes o-rings

from

$529.99

8″ Reverse high-pinion Toyota Drop Out (fits 8″ Housing) .

Product Features:

Fits Toyota Landcruiser reverse rotation front

from

$8.79

Fel-Pro gaskets offer 100% vehicle sealing with application-specific materials to give you sealing solutions with the performance and durability professionals trust

Product Features:

Meets or exceeds all original equipment specifications
Application specific design to ensure a perfect fit
Unsurpassed quality you can trust
Validated for fit, form and function
Each Fel-Pro gasket, no matter how small, is engineered to exacting standards with proprietary design, engineering and manufacturing processes

from

$529.99

Yukon Ring & Pinion sets give you the confidence of knowing you’re running gears designed for the harshest of conditions. Whether it’s on the street, off-road, or at the track; Yukon ring & pinion sets deliver unrivaled performance & quality. Yukon uses the latest designs and manufacturing technologies to provide a quiet running gear that is strong and easy to set up. All Yukon ring & pinion sets come standard with a one-year warranty.

from

$8.29

National has built a reputation as one of the most respected names in the industry. We have offered premium sealing solutions for more than 75 years. Our design team keeps pace with the industry and provides advanced solutions for today’s vehicles.

Product Features: