1987 Toyota Pickup Differentials

Name: Toyota 8" & V6 Pinion Nut Washer
Brand: Yukon Gear
SKU: 33168
Price: 16.99 USD

Find your specific 1987 Toyota Pickup original or aftermarket Differentials below. Order your parts online and have delivered to your home or pick up in-store at Advance Auto.

Essential 1987 Toyota Pickup Differentials

from

$16.99

Toyota 8″ & V6 pinion nut washer.

Product Features:

Pinion nut for Toyota 8″ and V6

from

$4.99

Product Features:

Brand may vary by location

from

$9.49

Value-priced seal meets all cataloged application requirements.

Product Features:

Brand may vary by location

from

$44.99

3 Qt. Penzoil 80W90 conventional gear Oil.

Product Features:

Includes three quarts of conventional oil

from

$289.99

8″ Toyota dropout case, all new, includes adjusters.

Product Features:

Fits Toyota 8″ with 4 cylinder engine

from

$10.99

V6 standard Open pinion gear Thrust washer.

Product Features:

Pinion gear thrust washer
Fits Toyota V6

from

$9.99

Product Features:

Roll pin
Fits Toyota 8″ with 4 cylinder engine

from

$49.99

7.5″ Toyota Spartan locker cross pin.

Product Features:

USA Standard Gear heavy-duty short cross pin shaft
Fits Toyota 7.5″
Works with Spartan Locker or standard open spider gears

from

$234.99

Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings & races can be reused. This kit uses high quality bearings and races along with a high quality pinion seal and small parts. Included in this kit are the pinion bearings and races, pilot bearing (if applicable), crush sleeve (if applicable), complete pinion shim kit, pinion nut, thread locker, and marking compound with brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your pinion gear.

Product Features:

Fits Toyota 8″ and 4 cylinder engine, 1985 and down or 1986 and up with aftermarket ring and pinion set
Included are pinion bearings and races, pinion seal, crush sleeve , complete pinion shim kit, and marking compound with brush.

from

$6.99

Ring Gear bolt for Toyota 7.5″, 8″, V6, Landcruiser reverse front & T100/Tacoma w/ factory locker. 11mm x 1.0.

Product Features:

Ring gear bolt for Toyota 7.5″, 8″, 8″ V6, Landrcuiser reverse rotation front and T100 and Tacoma rear with factory locking differential
11mm x 1.0

from

$258.99

Yukon standard open spider gear kit for Toyota 8″ 4-cylinder with 30 spline axles. Yukon uses higher quality materials and better techniques than OEM to ensure a longer lasting spider gear set. All components come with a one year warranty against manufacturing defects.

Product Features:

Spider gear kit
Fits Toytoa 8″ 4 cylinder open differential
Includes two side gears, two pinion gears, cross pin shaft, roll pin spider gear thrust washers.

from

$78.99

Bearing race driver for Toyota 7.5″, 8″ rear. (TOY32307). No return.

Product Features:

Bearing race driver
Fits 32307 race
All steel construction

from

$249.99

Product Features:

Installation kit
Includes o-ring for bulkhead fitting, bulkhead fitting, outer fitting, switch, front and rear switch cover, solenoid, zip ties and 20′ air line

from

$8.79

Fel-Pro gaskets offer 100% vehicle sealing with application-specific materials to give you sealing solutions with the performance and durability professionals trust

Product Features:

Meets or exceeds all original equipment specifications
Application specific design to ensure a perfect fit
Unsurpassed quality you can trust
Validated for fit, form and function
Each Fel-Pro gasket, no matter how small, is engineered to exacting standards with proprietary design, engineering and manufacturing processes

from

$11.99

Toyota 8″ & V6 gasket.

Product Features:

Dropout gasket
Fits Toyota 8″ and V6

from

$315.99

Axle shaft damaged or bearings worn out? This axle shaft directly replaces the original equipment on certain vehicles, complete with all necessary application-specific installation components.

Product Features:

Direct replacement – this axle shaft replaces the original equipment on specific vehicle years, makes and models
Complete kit – each shaft includes critical installation hardware and components needed for specific vehicle applications
Durable construction – designed to rigorous standards and tested to ensure performance
Trustworthy solution – backed by team of engineers and quality control specialists in the United States

from

$26.99

Spartan spring & pin kit, fits smaller designs.

Product Features:

Replacement spring and pin kit for Spartan Locker
Fits Dana 30, Dana 44, AMC Model 20, AMC Model 35, and Toyota designs
Includes 4 springs and 4 alignment pins

from

$13.49

Product Features:

KIT SHIM TOYO TRK 79-92 REAR/89-92 FRONT

from

$204.99

Product Features:

Spider gear kit
Fits Toyota 8″ with 4 cylinder engine
Includes two side gears, two pinion gears, cross pin shaft, roll pin spider gear thrust washers.

from

$73.99

Differential Parts K

from

$8.99

Product Features:

Side adjuster lock
Fits Toyota V6

from

$549.99

The Spartan Locker, by USA Standard Gear, provides reliable traction at a low cost. Give your vehicle great traction and save some cash. Choose a Spartan Locker for better traction. The Spartan locker by USA standard gear is a mechanical locker that replaces the spiders in a standard case. The Spartan locker’s design does not use the thrust washers and has a revolutionary spring and pin design that makes installation a snap! The couplers and drivers are made from 9310 steel, for added strength. Each Spartan locker carries a one year warranty against defect.

Product Features:

Fits Toyota 8″ and V6
Made from 9310 steel for added strength
Works with stock side gears in standard carrier case

from

$210.99

Motive Gear Differential Bearing Kits Include Front & Rear Pinion Bearing, Pinion Seal, Carrier Bearings, Pilot Bearing Where Applicable, Gear Marking Compound, Crush Sleeve, Pinion Nut, Brush, Thread Locking Compound And Cover Gasket Or Rtv

Product Features:

TOYOTA 8″ V6 MASTER KIT

from

$62.99

National Oil Seals & Bearings offer a full line of premium oil seals and bearings.

Product Features:

Premium bearing design matches OEM specifications
Precision manufactured using premium-grade steel for outstanding durability and performance
Crowned raceways and rollers to ensure even load distribution for maximum life
Industry leading coverage
Professional technicians know they can depend on National

from

$23.99

V6 side gear Thrust washer.

Product Features:

Side gear thrust washer
Fits Toyota V6

from

$349.99

Ring and Pinion Kit

from

$189.99

8″ standard Open case, bare.

Product Features:

Standard open carrier case
Fits Toyota 8″ with 4 cylinder engine

from

$10.99

Outer oil slinger for Toyota 7.5″, 8″, V6 & Landcruiser.

Product Features:

Outer oil slinger for Toyota 7.5″, 8″, V6 and Landcruiser

Popular 1987 Toyota Pickup Differentials Categories

Differential Oil

Differential Open Unit and Components

Differential Pinion Shaft Lock Bolts

Differential Bearings

Differential Axle Shafts

Differential Carriers

Differential Bearing Kits

Front Differential Pinion Bearings

Differential Spider Gear Kits

Differential Rebuild Kits

Differential Carrier Shim Kits

Differential Pinion Seals

Differential Ring and Pinions

Differential Cases

Differential End Yokes

Differential Lock Assemblies

Differential Air System Seal Housings

Differential Spools

Differential Carrier Bearing Adjusters

Automatic Transmission Differential Cover Gaskets

Front Differential Cover Gaskets

Differential Pinion Bearing Kits

Differential Seals

Complete Differentials

Differential Ring Gear Bolts

Bearing Race Drivers

Differential Crush Sleeves

Differential Side Bearing Spacers

Differential Pinion Shims

Differential Pinion Shaft Nuts

Differential Gear Install Kits

Differential Cross Pins

Automatic Transmission Differential Carrier Gaskets

Differential Side Gear Thrust Washers

Differential Pinion Gear Thrust Washers

Differential Drive Pinion Oil Deflectors

Differential Pinion Gear Washers

Differential Ring and Pinion Kits

Limited Slip Differential Assemblies

Maybe you’re in the middle of a full rebuild of that 1987 Toyota Pickup. Maybe you just need a couple of Differentials. Either way, Advance Auto Parts has 197 different Differentials in our inventory ranging from $4.99 to $1,356.99. That means you can find the exact parts or products you need to keep that 1987 Toyota Pickup running smoothly.

Differentials are only as good as their brand. We stock 9 different brands to make sure you have plenty of trusted parts to choose from for your 1987 Toyota Pickup. Valvoline, Yukon Gear, and National are just some of the brands we stock. Search for brands you know or compare prices and reviews to help you decide!

We know you’ll find the perfect Differentials for your 1987 Toyota Pickup, but don’t take our word for it – read our customer ratings and reviews and buy with confidence. Out of the 3,213 reviews in this category, some of the top rated parts include Bearings with 5.0 stars and Multi Purpose Seal with 1.5 stars.

So if you’re in the market for aftermarket Differentials to keep your 1987 Toyota Pickup rolling for years to come, look no further. Shop online and have your products shipped direct to your door, or pick up at the nearest Advance Auto Parts location today!

Differentials Brands To Make Your 1987 Toyota Pickup Last

Simple repair, complete replacement, or a full rebuild. No matter the job, your 1987 Toyota Pickup demands trusted brand parts and products to keep it running. Many trusted brands of Differentials make up Advance Auto Parts’ inventory, and all are ready to help make your Pickup the best it can be. Be sure to browse some of our top Differentials brands and parts.

Popular Felpro Differentials

We carry Felpro parts in our stock across Automatic Transmission Differential Cover Gaskets categories, plus more. For a 1987 Toyota Pickup, our most popular Felpro Differentials include:

from $8.79

(1)

Differential Carrier Gasket

Automatic Transmission Differential Cover Gaskets

Top 1987 Toyota Pickup Differentials from Valvoline

Valvoline products are another trusted brand when it comes to Differentials for your 1987 Toyota Pickup. Popular Valvoline parts include:

from $12.79

(446)

MaxLife Multi-Vehicle (ATF) Full Synthetic Automatic Transmission Fluid, 1 Quart

Differential Oil

FAQs for 1987 Toyota Pickup Differentials

What are the most purchased Differentials for the 1987 Toyota Pickup?

Out of 197 Differentials for the 1987 Toyota Pickup, the most popular in our inventory are:

from $44.99

This product is not rated

3 Qt – Penzoil 80W90 Conventional Gear Oil

Differential Oil

from $6.99

(6)

Bearings

Differential Bearings

from $8.49

This product is not rated

Tapered Cup Wheel Bearing Assembly

Differential Bearings

What are the top-rated 1987 Toyota Pickup Differentials?

Top-rated Differentials for your 1987 Toyota Pickup based on customer reviews/ratings are:

from $89.99

(2)

Bearings

“Exactly what came out”

from $8.29

(2)

Multi Purpose Seal

“This seal was difficult to install due to the snug fit of the steel outer ring (compared to rubber coated on the OEM). Additionally, the rubber defle”

from $53.99

(1)

Bearings

“made the front wheels ride smooth and quiet again like new.”

1987 Toyota Pickup Differentials

More 1987 Toyota Pickup Differentials

Essential 1987 Toyota Pickup Differentials

Yukon Gear – Toyota 8" & V6 Pinion Nut Washer (Part No.33168)

Driveworks – Differential Seal (Part No.S-710419)

Driveworks – Oil Seal (Part No.S-1177)

Yukon Gear – 3 Qt – Penzoil 80W90 Conventional Gear Oil (Part No.15002)

Yukon Gear – 8" Toyota Dropout Case, All New, Includes Adjusters (Part No.32096)

Yukon Gear – V6 Standard Open Pinion Gear Thrust Washer (Part No.33393)

Yukon Gear – 8" Roll Pin, Solid (Part No.33412)

USA Standard Gear – 7.5" Toyota Spartan Locker Cross Pin (Part No.17030)

Yukon Gear – Pinion Install Kit For Early Toyota 8" Differential (Part No.13088)

Yukon Gear – Ring Gear Bolt (Part No.33060)

Yukon Gear – Standard Open Spider Gear Kit For Toyota 8" 4 Cylinder With 30 Spline Axles (Part No.16062)

Yukon Gear – Bearing Race Driver (Part No.56007)

Yukon Gear – Zip Locker Install Kit (Part No.34026)

Felpro – Differential Carrier Gasket (Part No.RDS 55431)

Yukon Gear – Toyota 8" & V6 Gasket (Part No.23028)

Dorman – Rear axle shaft kit for Toyota pickup (Part No.630-334)

USA Standard Gear – Spartan Spring & Pin Kit, Fits Smaller Designs (Part No.17011)

Motive Gear – Differential Pinion Shim Kit (Part No.1109)

USA Standard Gear – Standard Spider Gear Set For Toyota 8", 4 Cylinder (Part No.39031)

Yukon Gear – Differential Parts K (Part No.12087)

Yukon Gear – V6 Side Bearing Adjuster Lock (Without Bolt) (Part No.33364)

USA Standard Gear – Spartan Locker For Toyota V6 With 30 Spline Axles (Part No.17034)

Motive Gear – Differential Bearing Kit – Timken (Part No.R11RV6T)

National – Bearings (Part No.KC-11445-Y)

Yukon Gear – V6 Side Gear Thrust Washer (Part No.33391)

USA Standard Gear – Ring and Pinion Kit (Part No.36331)

Yukon Gear – Standard Open Carrier Case, Toyota 8" 4 Cylinder (Part No.20113)

Yukon Gear – Outer Oil Slinger (Part No.33025)

Popular 1987 Toyota Pickup Differentials Categories