1973 Porsche 911 Ignition Electronic Parts

It is suggested that ignition coil be replaced when replacing this control unit. Installation Instructions The Model 930 6 pin Perma-Tune is designed to replace the stock ignition box and will bolt up and plug in to the same location as the stock system. The Model 930 6 pin is more than a replacement of the original ignition system; it is a performance upgrade boosting the spark energy by a factor of three. This increase in spark energy improves combustion efficiency resulting in more performance and less unburned fuel in the exhaust. Spark plug gap can be increased to .065″, (except on turbo charged cars with special spark plugs that cannot be re gapped) and solid core, unshielded copper spark plug wire can be used without causing radio noise problems. For Perma-Tune products,customer MUST call Perma-Tune directly @ 631-909-1011 PRIOR to claiming any unit as warranty. Or contact Perma-Tune @ for further information.

CARQUEST Ignition Modules are built by an ignition systems manufacturer with expertise in the entire vehicle spark system.

Product Features:

• CARQUEST Ignition Modules creates and refines the timing of the engine using various sensors and readings throughout the spark system in order to create an efficiently running engine.
• CARQUEST Ignition Modules use current and voltage limiting circuitry in order to prevent the ignition coil from over voltage/current. Over voltages can allow for coils to create excessive heat which can damage to the ignition module resulting in check eng
• CARQUEST Ignition Modules are 100% individually tested for all product functionalities including over voltage, timing and dwell.

It is suggested that ignition coil be replaced when replacing this control unit. Installation Instructions By design, Perma-Tune ignitions make very little heat of their own. Wiring problems external of the unit will cause your Perma-Tune to get hotter to the touch than the other components under the hood. If this is the case we recommend you read the diagnostic instructions. The Model 911 increases spark energy three times that of the stock ignition system. This is why spark plugs will never foul again, can be set to .065″ spark plug gap and will actually recover from fuel contamination. The Perma-Tune system uses the points only as a sensor so they will generally last the life of the engine. Dwell is not a factor simply set the points to stock gap specifications and then adjust the engine timing using a timing light. The Model 911 Perma-Tune is designed to replace the stock ignition box and will bolt up and plug in to the same location as the stock system. If the connector on the box does not fit the car harness connector, you have the wrong box. If you have a turbo charged car, be certain that the speed relay has not caused the previous ignition box to fail before plugging in the new box. If you are installing a 911SC engine in a 911 body, use the model 911EX Engine Exchange kit. If you need a harness to install this ignition system, exchange it for a Model 911E Perma-Tune. Use the Plasma Drive Perma-Tune for late model Porsche engine management systems, hall effect distributors or after-market engine management computers. Use the Model MP Perma-Tune on magnetic pulse type distributors like the Porsche 917 or any other magnetic sensor. For Perma-Tune products,customer MUST call Perma-Tune directly @ 631-909-1011 PRIOR to claiming any unit as warranty. Or contact Perma-Tune @ for further information.

Carquest premium engine management products provide the right ignition control module for a wide range of domestic and import applications. Delivering the highest performance and durability under demanding conditions. Designed to meet OE quality and performance standards using top-quality components, our sensors are the best choice for your maintenance and repair needs.

Product Features:

• Thicker, more robust wire bonds for lasting reliability
• Proprietary, application-specific integrated chips for proper performance
• Fast-start circuitry for quick starts
• Ultrasonically welded copper heat sinks to ensure heat transfer for long life
• Laser trimming to precise specifications for OE function