1959 Chevrolet 3A Performance and Racing Products
More 1959 Chevrolet 3A Performance and Racing Products Categories
If you’re looking for an original Performance and Racing Products replacement for a 1959 Chevrolet 3A, you can search through our selection below. You’ll also find aftermarket and OEM Performance and Racing Products to meet your needs.
Essential 1959 Chevrolet 3A Performance and Racing Products
Mr. Gasket – Chrome Plated Engine Oil Pan (Part No.9781)
from
$89.99
Beautifully chrome plated. Complete with drain plug, washer & bolts (stock depth). Chrome-plated dipsticks with tubes sold separately.
Product Features:
See More
Product Features:
- Chrome plated
- Includes drain plug/washer/bolts
Mallory – Distributor Wiring Harness (Part No.29349)
Mallory – Unilite Breakerless Ignition Conversion Kit (Part No.501)
from
$113.99
Put an end to high maintenance point ignition systems by installing a proven Mallory Unilite ignition conversion kit. Features at a glance, improves performance and fuel efficiency, easy to install with simple hand tools, reduced maintenance and is available for all popular 12-volt negative ground domestic cars and trucks.
Product Features:
See More
Product Features:
- Easy Installation
- Improved Fuel Economy
- Reduced Maintenance
- Accurate Timing
- Improved Performance
- Provides A Simple Conversion
- No Moving Parts To Wear Out
FEL-PRO Performance – Exhaust Manifold Gasket Set (Part No.1444)
from
$31.49
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Performance exhaust header gasket consisting of a high-density fiber facing material attached to both sides of a perforated steel core.
- Resists blowout and burnout from high-temperature exhaust and is far stronger than basic paper gaskets.
- Anti-stick coating permits motion without damaging the gasket and makes it easier to remove the gasket for future engine service.
- Slotted bolt holes allow for easier header installation.
- Not intended for use in emission controlled vehicles.
FEL-PRO Performance – Engine Valve Cover Gasket Set (Part No.1603)
from
$23.49
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Blue Stripe performance cork-rubber gaskets use cork particles evenly distributed throughout a rubber binder resulting in a compressible gasket without leak paths.
- Not intended for use in emission controlled vehicles.
FEL-PRO Performance – PERFORMANCE VALVE COVER GASKET SET (Part No.1602)
from
$23.49
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Die cut silicone rubber gaskets conform to out-of-flat covers
- Great for on-again/off-again situations
- Not intended for use in emission controlled vehicles.
Hurst – Installation Kit, Competition Plus Shifter (Part No.3733163)
from
$267.99
Installation kit for Hurst Competition Plus shifter. Includes all linkage pieces needed to complete the installation of your Hurst shifter.
Product Features:
See More
Product Features:
- Competition Plus Shifter Installation Kit
- Includes Hardware
- Durable
- Sold as a Kit
- Hurst Quality
Hurst – Installation Kit, Competition Plus (Part No.3734734)
from
$267.99
Installation Kit for Hurst Competition plus shifter. Includes all linkage pieces needed to complete the installation of your Hurst Shifter.
Product Features:
See More
Product Features:
- Competition Plus Shifter Installation Kit
- Includes Hardware
- Durable
- Sold as a Kit
- Hurst Quality
FEL-PRO Performance – Engine Crankshaft Seal Kit (Part No.2900)
from
$21.49
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Meets or exceeds all original equipment specifications
- Application specific design to ensure a perfect fit
- Engineered and manufactured specifically for repair applications
- Unsurpassed quality you can trust
- Validated for fit, form, and function
FEL-PRO Performance – PERFORMANCE REAR MAIN SEAL SET (Part No.2912)
from
$36.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Fluoroelastomer compound combines optimum resistance to heat, oils and abrasion for longivity.
- Optimizes performance under high crankcase vacuum conditions, elevated temperatures and high RPM levels.
- Not intended for use in emission controlled vehicles.
- Not intended for use in emission controlled vehicles.
FEL-PRO Performance – Cylinder Head Gasket: Multi-Layered Steel, Without Head Bolts (Part No.1003)
from
$39.49
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- PROPRIETARY COATING – Nonstick anti-friction coating seals small surface imperfections
- NO RETORQUE DESIGN – Steel core helps eliminate the need for retorquing head bolts
- SUPERIOR SEAL – Precise embossed Printoseal sealing beads at all vital areas to eliminate leak paths
- STRONG AND DURABLE – Features graphite or reinforced fiber facing material and steel armor for strength and durability
- DESIGNED FOR IMPERFECT SEALING SURFACES – Engineered and manufactured specifically for the repair environment to help seal imperfect sealing surfaces
FEL-PRO Performance – Cylinder Head Gasket: Steel Core Composite, Without Head Bolts (Part No.1010)
from
$39.49
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- PROPRIETARY COATING – Nonstick anti-friction coating seals small surface imperfections
- NO RETORQUE DESIGN – Steel core helps eliminate the need for retorquing head bolts
- SUPERIOR SEAL – Precise embossed Printoseal sealing beads at all vital areas to eliminate leak paths
- STRONG AND DURABLE – Features graphite or reinforced fiber facing material and steel armor for strength and durability
- DESIGNED FOR IMPERFECT SEALING SURFACES – Engineered and manufactured specifically for the repair environment to help seal imperfect sealing surfaces
FEL-PRO Performance – Engine Timing Cover Gasket (Part No.2335)
from
$20.29
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Steel core gasket construction
- Exclusive design permits significantly faster gasket installation while eliminating potential sealing leak paths.
- Not intended for use in emission controlled vehicles.
Mr. Gasket – Intake Bolt Kit (Part No.5003)
from
$67.99
Finish your custom engine job with these show quality grade 5 chromed bolts, includes AN washers which have no exposed shoulder for a professional appearance.
Product Features:
See More
Product Features:
- Intake bolt kit
- Chrome plated
- Includes an type washers
- Ideal for street rods/machines
Weiand – Team G; Intake Manifold (Part No.7531)
from
$1259.99Product Features:
- Designed For Today’s Larger Cubic Inch Big Block
- Perfect For Hard Core Drag Racers
- Permanent Mold Casting Process
- For Lighter And More Consistent Castings
- Dyno Proven To Make 17hp More Than Competitors
Mr. Gasket – Throttle Cable Bracket (Part No.9885)
from
$14.99
The throttle cable bracket is designed for small block Chevy engines thru 1979 and is to be used in conjunction with the kick down cable Pn9886 for the Turbo 350 transmission. The throttle cable bracket mounts on the intake manifold and will hold cables with round or square mounts. It has a 2 inch adjustable range and is finished off in a beautiful chrome plating.
Product Features:
See More
Product Features:
- 2 in. adjustable range
- Includes necessary hardware
- Chrome plated
- Individually packaged
Edelbrock – Sure Seat Valve Springs for Chevy 262-400 V8 1957-95 (Part No.5802)
from
$60.99
Springs made of highest quality spring wire. Springs precision wound to close tolerances. Non-Rotator style: Dyno tested and street proven. Great match to Edelbrock camshaft kit.
Product Features:
See More
Product Features:
- For Use With Cast Iron Heads
- Springs Made of Highest Quality Spring Wire
- Springs Precision Wound To Close Tolerances
- Use with Original Equipment Heads Only
Mr. Gasket – Thermocap Radiator Cap (Part No.2470S)
from
$54.99
Knowing your coolant temperature can help to prevent burn injuries. Thermo Cap, with its built-in calibrated thermometer, indicates the coolant temperature. This is useful information prior to cap removal. Never attempt to remove Thermo Cap when the coolant temperature is very hot. The escaping hot coolant and steam may burn you. Check the Thermo Cap temperature indicator to determine if the coolant is cool enough to make removing Thermo Cap safe. If the coolant is very hot, then thoroughly rinse the radiator with cool water, until the coolant temperature drops into a cooler safe zone Thermo Cap’s integrated coolant reclamation valve works great with your coolant recovery system. Your radiator can reclaim coolant from your overflow bottle. Wide 30 degree to 270 degree Fahrenheit temperature range. Calibrated in centigrade and Fahrenheit. Color-coded temperature ranges. Chromed crown with a colored trim ring. Indicates coolant temperature, Helps to prevent coolant injuries, integrated coolant reclamation valve, Improves under hood appearance, Fits most domestic or import vehicles and various valve pressures available.
Product Features:
See More
Product Features:
- Indicates coolant temperature
- Helps to prevent coolant injuries
- Integrated coolant reclamation valve
- Improves under hood appearance
- Fits most domestic vehicles
- Built in calibrated thermometer
Mr. Gasket – Aluminum Valve Cover (Part No.6854)
from
$159.99
Mr. Gasket’s aluminum valve covers are precision die cast for light weight and a perfect fit. Beautifully polished to a high luster, they are sure to enhance the appearance of any engine compartment. They feature an extended sealing lip to positively locate and secure the gasket and stop it from moving to eliminate oil leaks. Available with plain or ball- milled tops and include a 1 1/4 inch diameter breather hole, except where noted. Packaged two per set.
Product Features:
See More
Product Features:
- 0.125 in. Thick
- Lightweight
- Precision Die Cast
- Extended Sealing Lip
- Stops Gasket From Moving
- A Perfect Fit
- Beautifully Polished To A High Luster
FEL-PRO Performance – PERFORMANCE OIL PAN GASKET SET (Part No.1885)
from
$46.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Rigid core, molded silicone rubber gaskets utilize the one-piece molded rubber technology for a perfect fit, ease of installation and include compression limiters to prevent overtightening.
- Not intended for use in emission controlled vehicles.
FEL-PRO Performance – Oil Pan Gasket Set: High-Temperature Rubber-Coated Fiber, 5 Piece Set (Part No.1802)
from
$25.49
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Felcoid/Plus gaskets have a fiber sheet core and a latex rubber coating to eliminate potential leakage paths. The core material resists crushing and splitting, while providing excellent blowout resistance.
- With steel core to provide ultimate excellent blowout resistance.
- Not intended for use in emission controlled vehicles.
Popular 1959 Chevrolet 3A Performance and Racing Products Categories
1959 Chevrolet 3A Performance and Racing Products
You count on your 1959 Chevrolet 3A to run right. That means taking care of it with regular maintenance, necessary repairs, and the right parts. Advance Auto Parts can help with all of that thanks to our extensive inventory of trusted Performance and Racing Products. With 36 Performance and Racing Products ranging in price from $14.99 to $1,259.99, you’re sure to find everything you need for your 1959 Chevrolet 3A.
Brands matter. If you want to shop a specific Performance and Racing Products brand, we stock 7 different brands like FEL-PRO Performance, Mr. Gasket, and Edelbrock. 1959 Chevrolet 3A Performance and Racing Products start as low as $14.99!
One of the best ways to find top quality OEM or aftermarket Performance and Racing Products is by asking professionals. Short of that, you can shop with confidence thanks to our 20 extensive product reviews on 1959 Chevrolet 3A Performance and Racing Products. Some of the top-rated Performance and Racing Products products we carry are Intake Manifold Bolts with 4.6 stars and Automatic Shifter, Unimatic Shifter with 4.3 stars.
Did we mention you can order your Performance and Racing Products from our online catalog and have them shipped right to your garage? Or, if you feel like seeing the parts first-hand, search for your nearest Advance Auto Parts location above and pick up in-store when you’re ready. Browse our full Performance and Racing Products inventory for your 1959 Chevrolet 3A below to get started!
Top-Rated Performance and Racing Products Brands For Your 1959 Chevrolet 3A
Trusted Performance and Racing Products OEM and aftermarket product brands are what Advance Auto Parts specializes in. The brands we work with are sure to keep that 1959 Chevrolet 3A running right for years to come. In our inventory you’ll find brands like FEL-PRO Performance, Mr. Gasket, Edelbrock, and even more.
Popular Edelbrock Performance and Racing Products
You’ll find popular Edelbrock brand products across Performance Engines. All are waiting to get your 1959 Chevrolet 3A back on the road. Some of the top-rated Edelbrock products in these categories are:
from
$60.99
(2)
Sure Seat Valve Springs for Chevy 262-400 V8 1957-95
Performance Engine Valve Springs
Top-Rated FEL-PRO Performance Performance and Racing Products
If FEL-PRO Performance are what you’re looking for, our inventory holds plenty. We stock FEL-PRO Performance brand Performance and Racing Products for your 1959 Chevrolet 3A, and some of our most reviewed FEL-PRO Performance parts include:
from
$52.99
(1)
Cylinder Head Gasket: Steel Core Composite, Without Head Bolts
Performance Engine Cylinder Head Gaskets
FAQs for 1959 Chevrolet 3A Performance and Racing Products
What are the most purchased Performance and Racing Products for the 1959 Chevrolet 3A?
Out of 36 Performance and Racing Products for the 1959 Chevrolet 3A, the most popular in our inventory are:
from
$39.49
(1)
Cylinder Head Gasket: Multi-Layered Steel, Without Head Bolts
Performance Engine Cylinder Head Gaskets
What are the top-rated 1959 Chevrolet 3A Performance and Racing Products?
Top-rated Performance and Racing Products for your 1959 Chevrolet 3A based on customer reviews/ratings are:
from
$461.99
(1)
Automatic Shifter, Megashifter
“its was pretty easy to install if u have any type of knowlegde of cars it should not be difficult at all and the shifting is awesome just be careful w”
