TVR Griffith Performance and Racing Products
Top TVR Griffith Performance and Racing Products Categories
We carry over 26 Performance and Racing Products in inventory for the TVR Griffith. If you’re looking for aftermarket Performance and Racing Products for your TVR Griffith, check out all these categories:
Essential TVR Griffith Performance and Racing Products
FEL-PRO Performance – Exhaust Manifold Gasket Set (Part No.1467)
from
$45.99
Product Features:
See More
- Performance exhaust header gasket consisting of a high-density fiber facing material attached to both sides of a perforated steel core.
- Resists blowout and burnout from high-temperature exhaust and is far stronger than basic paper gaskets.
- Anti-stick coating permits motion without damaging the gasket and makes it easier to remove the gasket for future engine service.
- Slotted bolt holes allow for easier header installation.
- Not intended for use in emission controlled vehicles.
FEL-PRO Performance – Lower Intake Manifold Gasket Set: 11 Piece Set (Part No.1250)
from
$35.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- DESIGNED FOR IMPERFECT SEALING SURFACES — Engineered and manufactured specifically for the repair environment to help seal imperfect sealing surfaces
- SEALING TECHNOLOGIES — Exclusive sealing innovations and technologies with proprietary materials and unique design features to ensure a superior seal for your repair
- ENGINEERING EXPERTISE — Parts are designed, reviewed, validated and approved by Fel-Pro engineers through rigorous research and development
- REAL-WORLD TESTED — Parts are tested on-vehicle and validated to ensure optimal performance on the road
- EVERY PART FOR THE REPAIR — Fel-Pro gasket sets include every part needed for the repair unless otherwise noted
FEL-PRO Performance – Engine Valve Cover Gasket Set (Part No.1614)
from
$24.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Die cut silicone rubber gaskets conform to out-of-flat covers
- Great for on-again/off-again situations
- Not intended for use in emission controlled vehicles.
FEL-PRO Performance – Engine Valve Cover Gasket Set (Part No.1613)
from
$29.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- Blue Stripe performance cork-rubber gaskets use cork particles evenly distributed throughout a rubber binder resulting in a compressible gasket without leak paths.
- Not intended for use in emission controlled vehicles.
Hays – Flywheels (Part No.12-535)
from
$511.99
Hays aluminum flywheels are manufactured from certified billet material that will not break up under the stress of high RPM and severe punishment of racing. Features replaceable steel surface insert. Precision balanced to either neutral (internal) or Detroit (external) specifications. Meets SFI specification 1.1 for racing.
Product Features:
See More
Product Features:
- Certified Billet Material
- Borg and Beck Clutch Pattern
- Long-Style Clutch Pattern
- Ring Gear Securely Mounted To Prevent Spinning
Edelbrock – Performer RPM Ford Small Block 302 Intake Manifold (Part No.7121)
from
$359.99Product Features:
- Best for the Ultimate in Street High-Performance
- Designed for 1500 to 6500 RPM Street-Driven Power
- Dual-Plane High-Rise Intake w/180 deg Firing Order
- Produces Incredible Top-End Horsepower
- Retains Good Throttle Response and Acceleration
- Larger Plenum and Runners Maximizes Other Upgrades
Edelbrock – Performer 289 Intake Manifold for Small-Block Ford, Black Finish (Part No.21213)
from
$465.99
Edelbrock part #21213 Performer 289 intake manifold is designed for street 260-289-302 c.i.d. Ford V8’s without EGR. Will not fit Boss 302 or 255 c.i.d. V8’s. Edelbrock carbs will work with Ford automatic overdrive trans (AOD) when used with Lokar bracket
Product Features:
See More
Product Features:
- Idle-5500 RPM Range
- Dual Plane Type-4150 Style Flange
- 3.5 in. Front Height, 4.12 in. Center Height, 4.75 in. Rear Height
- Black Powder Coated Finish
- Made In The USA
FEL-PRO Performance – Cylinder Head Gasket: Steel Core Composite, Without Head Bolts (Part No.1011-1)
from
$52.99
Fel-Pro Performance Gaskets deliver reliable sealing under grueling racing conditions
Product Features:
See More
Product Features:
- PROPRIETARY COATING – Nonstick anti-friction coating seals small surface imperfections
- NO RETORQUE DESIGN – Steel core helps eliminate the need for retorquing head bolts
- SUPERIOR SEAL – Precise embossed Printoseal sealing beads at all vital areas to eliminate leak paths
- STRONG AND DURABLE – Features graphite or reinforced fiber facing material and steel armor for strength and durability
- DESIGNED FOR IMPERFECT SEALING SURFACES – Engineered and manufactured specifically for the repair environment to help seal imperfect sealing surfaces
Holley – Off Road Carbs (Part No.0-90670)
from
$819.99
The off-road truck avenger is designed specifically for off-road applications. The unique fuel metering block eliminates fuel spillover through the boosters at extreme angles allowing for 40 degree climbing, 30 degree side hill maneuvers and nose-down descents to avoid hesitations, stalling and flooding typically associated with carbs in an off road environment. The 470 CFM off-road truck avenger is the perfect carburetor for 4 cylinder, V-6, and inline 6 cylinder engines. Viton(R) is a registered trademark of DuPont Performance Elastomers.
Product Features:
See More
Product Features:
- Gold Dichromate Finish For Extreme Off Road Environments
- Single Feed Fuel Inlet For Ease Of Installation
- Optimized Off-Road Calibration That Works Out-Of-The-Box
- Factory Preset Electric Choke For Easy Startups
- Quick Change Vacuum Housing Cap To Tune For Performance/Fuel Econ
- One Piece Off-Road Vent Tube Eliminates Fuel Spillover
- Metering Block For Flood Free Op. 40 deg. Climb/30 deg. Side Hill
- Limited Lifetime Warranty Defects In Material/Workmanship
Holley – Street Carburetor: 670 CFM, Electric Choke, 4 Barrel, Square Bore, Dual Inlet, Shiny (Part No.0-80670)
from
$699.99
Square flange bolt pattern. Performance calibrated. The ultimate vacuum secondary street performance upgrade.
Product Features:
See More
Product Features:
- Vibratory Polished For Good Looks
- Optimized Street Calibration That Works Out Of The Box
- Factory Preset Electric Choke For Easy Startups
- Quick Change Vacuum Housing Cap To Tune For Performance/Fuel Econ
- No Unnecessary Trips Back To The Parts Store
- Limited Lifetime Warranty
- 100% Wet Flow Tested By Holley Technicians
- Arrives Ready To Run
Holley – Prem Street Carbs (Avengers) (Part No.0-80770)
from
$716.99
Square flange bolt pattern. Performance calibrated. The ultimate vacuum secondary street performance upgrade.
Product Features:
See More
Product Features:
- Vibratory Polished For Good Looks
- Optimized Street Calibration That Works Out Of The Box
- Factory Preset Electric Choke For Easy Startups
- Quick Change Vacuum Housing Cap To Tune For Performance/Fuel Econ
- No Unnecessary Trips Back To The Parts Store
- Limited Lifetime Warranty
- 100% Wet Flow Tested By Holley Technicians
- Arrives Ready To Run
Edelbrock – Torker-Plus Camshaft Kit for 1957-95 Small-Block Ford 289-302 V8 (Part No.5022)
from
$440.99
Edelbrock camshafts are matched to Edelbrock Total Power Package components for proven performance, taking the guesswork out of camshaft selection. They are compatible with OEM or Edelbrock hydraulic roller tappets which reduce friction, virtually eliminate break-in problems, and permit higher valve velocities for increased performance. Designed to work with Torker II manifolds for performance from 2500 to 6500 RPM, these camshafts are ideal for high-performance street, drag or marine applications. Torker-Plus cams have a slightly rough idle and are not suitable for trucks or towing applications. Hydraulic flat tappet lifters are included with each camshaft.
Product Features:
See More
Product Features:
- Designed for 2500 to 6500 Performance
- Designed for Hi-Perf Street; Drag or Marine Use
- Matched to Edelbrock Torker II Intakes
- Includes Hydraulic Lifters and Assembly Lube
- Dyno Matched/Street Proven Performance
- Take The Guesswork Out Of Camshaft Selection
Competition Cams – VALVE SEALS, 11/32" TEFLON 1 ST (Part No.503-16)
from
$223.99
COMP Cams offers a complete line of valve stem seals, from the umbrella seals to the positive-stop Teflon seal. These seals are a must to keep unwanted oil from entering the combustion chamber through the clearance in the valve guides. The umbrella seal is normally used when a larger-than-stock diameter spring is used, in the case of a double spring, the positive-stop Teflon seal is used. The umbrella seals require no machining, but with the Teflon seal it is necessary to disassemble the heads and machine the top of the guide with a special .530 diameter cutter. Whenever you are planning an engine overhaul or a cam change, don’t forget the valve seals.
Product Features:
See More
Product Features:
- Work with .530″ guides and 11/32″ valve stem diameter
- Valve stem oil seals keep unwanted oil from entering the combustion chamber
- Several different types of valve seals are offered
Edelbrock – Performer-Plus Camshaft Kit for Small-Block Ford 289-302 V8 (Part No.2122)
from
$338.99Product Features:
- Designed for Optimum Torque and Acceleration
- Maximum Performance From Idle through Mid-Range
- Matched to Edelbrock Performer Intakes
- Includes Hydraulic Lifters and Assembly Lube
- Major Improvement in Throttle Response and Torque
- Use For Daily Drivers/Trucks/Vans/RVs/4x4s
- Take The Guesswork Out Of Camshaft Selection
TVR Griffith Performance and Racing Products Categories
Helping You Find the Right Performance and Racing Products for Your TVR Griffith
You love your Griffith. So we’ve made it easier than ever to help you find TVR Griffith Performance and Racing Products in our online catalog. Our inventory holds 26 aftermarket and OEM Performance and Racing Products for your TVR Griffith, ranging from $16.99 to $819.99.
We offer parts from 5 brands trusted to make quality Performance and Racing Products for your TVR Griffith. Before you buy, take some time to read through customer reviews. We currently have 180 reviews of TVR Griffith Performance and Racing Products from previous customers.
Find your Griffith Performance and Racing Products here, order online, and have your order shipped directly to your home. Prefer to have an in-person look at your TVR Griffith part to confirm it’s just right? You can find your nearest Advance Auto Parts store and confirm they have the part in stock before heading over.
Top Performance and Racing Products Brands for Your TVR Griffith
Our inventory holds Performance and Racing Products for your TVR Griffith from 5 trusted brands. You’ll find OEM and aftermarket parts from brands like FEL-PRO Performance, Holley, and Edelbrock, all of which can keep that TVR happy.
We have FEL-PRO Performance parts available for your TVR Griffith in categories like Performance Engines. Some of the top-rated FEL-PRO Performance parts in these categories are:
from
$35.99
(4)
Lower Intake Manifold Gasket Set: 11 Piece Set
Performance Engine Intake Manifold Gaskets
from
$52.99
(2)
Cylinder Head Gasket: Steel Core Composite, Without Head Bolts
Performance Engine Cylinder Head Gaskets
Top-Rated Holley Performance and Racing Products
Leading Holley Performance and Racing Products
We carry Holley brand parts for your TVR Griffith across several catalog categories, including Performance Fuel Systems. Some of our most reviewed Holley parts include:
from
$509.99
(45)
Street Carburetor: 600 CFM, Electric Choke, 4 Barrel, Square Bore, Single Inlet, Shiny
Performance Carburetors
from
$699.99
(6)
Street Carburetor: 670 CFM, Electric Choke, 4 Barrel, Square Bore, Dual Inlet, Shiny
Performance Carburetors
FAQs for TVR Griffith Performance and Racing Products
What are the most purchased Performance and Racing Products for the TVR Griffith?
Out of 26 Performance and Racing Products for the TVR Griffith, the most popular in our inventory are:
from
$359.99
This product is not rated
Performer RPM Ford Small Block 302 Intake Manifold
Performance Intake Manifolds
from
$24.99
This product is not rated
Engine Valve Cover Gasket Set
Performance Engine Valve Cover Gasket Sets
from
$223.99
This product is not rated
VALVE SEALS, 11/32" TEFLON 1 ST
Performance Engine Valve Stem Seal Sets
