Studebaker 2R5 Belts and Hoses
Top Studebaker 2R5 Belts and Hoses Categories
We carry over 8 Belts and Hoses in inventory for the Studebaker 2R5. If you’re looking for aftermarket Belts and Hoses for your Studebaker 2R5, check out all these categories:
Essential Studebaker 2R5 Belts and Hoses
Gates – Vulco-Flex II Flexible Coolant Hose (Part No.25480)
from
$25.49
Gates Vulco-Flex(R) II hose will bend in almost any direction. It easily replicates the angles and planes of a wide variety of expensive original equipment coolant hose, for quick, easy replacement.
Product Features:
See More
Product Features:
- Improved sealing surface for improved leak resistance
- High flexibility for easy installation
- Maximum vehicle coverage with minimum inventory
- Heat, oil and ozone resistant
- Rated for SAE 20R5 Class D-2 performance
- Temperature Range: up to +257 Deg. F (+125 Deg. C)
- Note: Gates recommends replacing clamps each time a new coolant hose is installed
- Caution: Do not use for fuel or oil transportation applications.
Dayco – Flex Radiator Hoses; EPDM Rubber, 19.88 Inch Long, 1.5 Inch Inner Dia. (Part No.81181)
from
$21.99
The Dayco flex radiator hose replaces straight or molded radiator hoses on a wide range of engine applications. Precision molded in standard lengths, it features a knitted reinforcement and synthetic EPDM construction. This hose is designed to prevent splitting, ballooning and elongation as well as resist ozone and other detrimental environmental elements, coolants and temperature variations of -40øF (-40øC) to +257øF (+125øC). With corrugations that provide excellent hose flexibility without flattening or collapsing, the Dayco flex radiator hose also features a helical steel coil spring for increased flexibility.
Product Features:
See More
Product Features:
- Designed to meet OE specifications
- Not suitable for oil or heat transfer
- Meets SAE J20R4, Class D-2 requirements for improved service hoses
- This hose is designed to prevent splitting, ballooning, and elongation
Gates – Green Stripe 2-Ply Straight Coolant Hose (Sold by foot) (Part No.24220)
from
$1.99
Stick hose designed for demanding heavy-duty coolant/air applications. Approved for marine applications.
Product Features:
See More
Product Features:
- Cover marked in 1-inch increments to facilitate approximate cutting lengths, allows for “bespoke” installations.
- Designed with compounds that resist electrochemical degradation
- Approved for marine applications.
- Exceeds SAE 20R1 Type EC (Class D-1 Tube, and Cover, Standard Wall)
- Temperature Range: -40 Deg. F to +257 Deg. F (-40 Deg. C to +125 Deg. C)
- Note: For a maintenance-free connection, use PowerGrip SB clamps
- Caution: Do not use for fuel or oil transportation applications.
- PLEASE NOTE: Item is priced and sold by the inch. See store for details.
Gates – Green Stripe Truck & Bus Series V-Belt (Part No.TR24379)
from
$36.99
Specifically designed for heavy-duty truck, bus and off-road equipment applications. Absorbs normal shock loads without damage to the belt.
Product Features:
See More
Product Features:
- Molded notches reduce bending stress, especially on small diameter pulleys, while dissipating heat
- High-modulus, high-strength pull cord
- Oil and heat resistant construction
- Meets SAE J636b and SAE J637 specifications
- Meets RMA standards for oil and heat resistance and static conductivity requirements
- NOTE: Some sizes are available as Gates PowerBand V-Belts
Dayco – V-Belt, Top Cog, Dayco (Part No.15465)
from
$24.49
Dayco has combined raw-edge construction and a smooth top to ensure high performance on vehicles and drives that utilize V-belts. The Dayco high performance V-belt delivers more flexibility and increases airflow around the belt so it runs cooler and lasts longer. Three plies of neoprene impregnated fabric resist heat, oil and grease while a specially-formulated treatment of the polyester cord provides the strength, stability and reliability that are required for one of the most innovative, top-performing V-belts.
Product Features:
See More
Product Features:
- Provides greater durability and flexibility – 35% stronger than all previous versions
- Prevents electromechanical interference issues on modern vehicles
- Resists heat, oil and grease
Gates – Green Stripe Truck & Bus Series V-Belt (Part No.TR22380)
from
$27.99
Specifically designed for heavy-duty truck, bus and off-road equipment applications. Absorbs normal shock loads without damage to the belt.
Product Features:
See More
Product Features:
- Molded notches reduce bending stress, especially on small diameter pulleys, while dissipating heat
- High modulus, high strength tensile cord
- Oil and heat resistant construction
- Meets SAE J636b and SAE J637 specifications
- Meets RMA standards for oil and heat resistance and static conductivity requirements
- NOTE: Some sizes available as Gates PowerBand attached V-belts
Driveworks – Automotive V-Belt: 47.07 Outer Circumference, 46.5 Effective Length, 0.44 Top Width (Part No.46513)
from
$5.29
Engineered to conform to high mileage, worn or misaligned drives without a sacrifice in quiet, long-lasting performance. Constructed with Aramid reinforced EPDM compounds, it delivers more than OE required quality… it delivers the solution to troublesome drive problems. Driveworks Poly-Rib Belts meet or exceed SAE J1459 and SAE J2432 specifications.
Product Features:
See More
Product Features:
- Aramid noise resistant fibers embedded in the rubber make this belt run quieter in worn or misaligned pulleys.
- No-Noise Advanced Design EPDM rubber compound for quiet extended life
Gates – Vulco Straight Coolant Hose (Sold by foot) (Part No.24020)
from
$0.99
Specially engineered stick hose is ideal for straight coolant/air connections in automotive, stationary engine, industrial and home applications.
Product Features:
See More
Product Features:
- Heat-resistant cover
- Cover marked in 1-inch increments to facilitate approximate cutting lengths, allows for “bespoke” installations.
- Meets SAE 20R1 Standard Wall Class D-2 requirements
- Temperature range: -40 Deg. F to +257 Deg. F (-40 Deg. C to +125 Deg. C)
- Note: For a maintenance free connection, use PowerGrip SB clamps
- Caution: Do not use for fuel or oil transfer applications
Studebaker 2R5 Belts and Hoses Categories
Helping You Find the Right Belts and Hoses for Your Studebaker 2R5
You love your 2R5. So we’ve made it easier than ever to help you find Studebaker 2R5 Belts and Hoses in our online catalog. Our inventory holds 8 aftermarket and OEM Belts and Hoses for your Studebaker 2R5, ranging from $0.99 to $36.99.
We offer parts from 3 brands trusted to make quality Belts and Hoses for your Studebaker 2R5. Before you buy, take some time to read through customer reviews. We currently have 5 reviews of Studebaker 2R5 Belts and Hoses from previous customers. Some of the top rated parts include Automotive V-Belt: 47.07 Outer Circumference, 46.5 Effective Length, 0.44 Top Width with 3.0 stars.
Find your 2R5 Belts and Hoses here, order online, and have your order shipped directly to your home. Prefer to have an in-person look at your Studebaker 2R5 part to confirm it’s just right? You can find your nearest Advance Auto Parts store and confirm they have the part in stock before heading over.
Top Belts and Hoses Brands for Your Studebaker 2R5
Our inventory holds Belts and Hoses for your Studebaker 2R5 from 3 trusted brands. You’ll find OEM and aftermarket parts from brands like Dayco, Gates, and DriveWorks, all of which can keep that Studebaker happy.
We have Dayco parts available for your Studebaker 2R5 in categories like Serpentine and V Belts and Radiator Hoses. Some of the top-rated Dayco parts in these categories are:
from
$21.99
(2)
Flex Radiator Hoses; EPDM Rubber, 19.88 Inch Long, 1.5 Inch Inner Dia.
Coolant Hoses
FAQs for Studebaker 2R5 Belts and Hoses
What are the most purchased Belts and Hoses for the Studebaker 2R5?
Out of 8 Belts and Hoses for the Studebaker 2R5, the most popular in our inventory are:
from
$1.99
This product is not rated
Green Stripe 2-Ply Straight Coolant Hose (Sold by foot)
Upper Radiator Hoses
What are the top-rated Studebaker 2R5 Belts and Hoses?
Top-rated Belts and Hoses for your Studebaker 2R5 based on customer reviews/ratings are:
from
$5.29
(1)
Automotive V-Belt: 47.07 Outer Circumference, 46.5 Effective Length, 0.44 Top Width
“fits”
