from

$31.99

New Goodmark Door Sill Plate Without Emblem

Product Features:

Without Emblem
Meets All Federal Motor Safety Standards
No Drilling Needed For Installation
No Modifications Needed For Installation
Direct Fit Replacement For Your Vehicle
Same Form Fit And Function As OE
Check Out The Large Selection Of Parts Available For Your Vehicle

from

$12.99

New Goodmark 10 Piece Floor Drain Plug Set, Consists Of 2 Oval Plates, 4 Rubber Plugs And 4 Screws, 2 Sets Required Per Car

Product Features:

Consists Of 2 Oval Plates 4 Rubber Plugs And 4 Screws 2 Sets Required Per Car
Meets All Federal Motor Safety Standards
No Drilling Needed For Installation
No Modifications Needed For Installation
Direct Fit Replacement For Your Vehicle
Same Form Fit And Function As OE
Check Out The Large Selection Of Parts Available For Your Vehicle

from

$83.99

New Goodmark Driver And Passenger Side Pair Of Door Weatherstrips

Product Features:

Made Of Rubber
Meets All Federal Motor Safety Standards
No Drilling Needed For Installation
No Modifications Needed For Installation
Direct Fit Replacement For Your Vehicle
Same Form Fit And Function As OE
Check Out The Large Selection Of Parts Available For Your Vehicle

from

$27.99

Atlas Lift Supports are engineered to meet or exceed OE specifications to ensure your replacement will perform the same or better than your original lift supports. Atlas Lift supports are designed to prevent premature failures, with premium features such as a corrosion resistant exterior, OE grade end connectors, and Dynamic Dampening Technology. Dynamic Dampening Technology (DDT) is a precision groove engineered into the tube of the lift support, which allows the hatch to open at the optimum speed to prevent “bouncing” or “Jumping” at the end of the stroke. Lift Supports’ performance and longevity are affected by consistent usage, temperature changes, contact with weather elements, pulling or hanging on the part, and can cause unsafe conditions if not changed when signs of failure are present. Atlas Lift Supports are easy to replace and can be changed in minutes No Special Tools Required. Atlas Lift Supports also provide easy to read install for a quick and easy installation. Make sure to Always Replace in Pairs!

Product Features:

Engineered to meet or exceed OE specifications. Always replace in Pairs, where applicable.
Easy Install – Less than 15 Minutes! based on average install time across all parts
No Special Tools Required
Certified Quality – IATF 16949 Certified- exceeds quality control standards and testing performance.
OE-Grade end connectors manufactured from high-strength materials to ensure proper fit and function.
OE-Performance Proprietary DYNAMIC DAMPENING TECHNOLOGY (DDT) provides a smooth open and close, where applicable.
World-class polished nitride-coated steel shafts provide corrosion resistance, smooth operation, and long life for the gas-seal.
Trilingual Install Instructions provided inside each package

from

$58.99

Original Equipment Manufacturer Style Replacement Side View Mirror. K Source is a unique manufacturer in that we specialize in making only automotive and motorcycle mirrors. Our experience in this category for over 71 years is exactly what our customers have come to trust and rely upon, as our manufacturing and marketing expertise has consistently led the market in replacement products.

Product Features:

Passenger side Mirror, tested to fit and function like the original, Meets or exceeds Original Equipment Manufacturer standards
Mirror glass is power adjustable
OE-comparable wiring harness/ connection (no “pigtail” connector) for hassle-free installation
This Mirror does not fold
Black

from

$16.99

Modern vehicles may have 100 or more electrical harness connectors in every operating system of the vehicle. Terminal tension may weaken with time or corrosion may occur within the connector housing making replacement necessary. When replacing any harness-connector assembly approved wire termination methods must be followed to ensure a successful and long-term solution to the original problem is made. A failed terminal connection, terminal corrosion or damaged wire will result in an electrical system fault.

Product Features:

Carquest electrical connectors meet or exceed OE wire gauge, insulation, and terminal material requirements.
Sealed connections (where applicable) to prevent environmental corrosion and performance issues
Global coverage for import and/or domestic applications
OE specified wire gauge to ensure a reliable electrical connection
Designed to meet or exceed OE specifications in form, fit and function

from

$195.99

This door lock actuator has undergone extensive quality and safety testing to ensure reliable performance. It is engineered to provide a direct replacement for the stock actuator on specific vehicle years, makes and models.

Product Features:

Reliable replacement – this door lock actuator has undergone extensive quality and safety performance testing
Perfect fit – engineered to provide the same fit and function of the original actuator on specific vehicle years, makes and models
Safety compliant – part has undergone simulated crash testing under government guidelines
Long-lasting repair – cycle testing in an actual vehicle door verifies effective usage for years

from

$61.99

The Deck Lid / Liftgate Ajar Switch will be mounted on the decklid/liftgate or the body near the lid. The switch allows the interior lights to illuminate and to provide a signal to the instrument cluster in order to notify the vehicle operator should the lid be open.

Product Features:

Product constructed to meet all design and operating characteristics as intended by the vehicle manufacturer.
100% thermo-shock and vibration tested to ensure superior performance in extreme conditions.
100% end-of-line tested to ensure accurate signal output providing product reliability, every time.
Tin plated lead frame prevents corrosion and ensures a reliable terminal connection under adverse ambient conditions.
Lead frame terminal size and location determined using image dimension measuring system or 3D laser scanner.
Where applicable electrical connectors meet or exceed OE wire gauge, insulation, and terminal material requirements.

from

$4.99

Constructed of quality materials, this multi-purpose retainer provides the same function and versatility as the original equipment retainer ensuring long service life.

Product Features:

Ideal replacement – this retainer matches the fit and function of the original equipment retainer for this vehicle application
Quality material – this retainer is made of durable material for long-lasting service
Versatile design – this retainer is suitable for a variety of automotive uses
Excellent value – this part offers original equipment quality at a competitive cost

from

$58.99

Original Equipment Manufacturer Style Replacement Side View Mirror. K Source is a unique manufacturer in that we specialize in making only automotive and motorcycle mirrors. Our experience in this category for over 71 years is exactly what our customers have come to trust and rely upon, as our manufacturing and marketing expertise has consistently led the market in replacement products.

Product Features:

Driver side Mirror, tested to fit and function like the original, Meets or exceeds Original Equipment Manufacturer standards
Mirror glass is power adjustable
OE-comparable wiring harness/ connection (no “pigtail” connector) for hassle-free installation
This Mirror does not fold
Black

from

$44.99

Want a new interior door handle that matches the original, for far less than going back to the dealership- This replacement door handle was engineered to match the fit and appearance of the stock handle on specific vehicle years, makes and models.

Product Features:

Matching appearance – this replacement door handle was specifically designed to look and function the same as the original interior handle on particular vehicles
Seamless replacement – designed to match the dimensions and specifications of the handle that came stock on the vehicle
Trustworthy construction – engineered in North America and backed by 100 years of automotive aftermarket experience
Ensure fit – this handle is vehicle position specific, so double check you have the correct handle for the same position and side of the vehicle you want to replace

from

$26.99

Modern vehicles may have 100 or more electrical harness connectors in every operating system of the vehicle. Terminal tension may weaken with time or corrosion may occur within the connector housing making replacement necessary. When replacing any harness-connector assembly approved wire termination methods must be followed to ensure a successful and long-term solution to the original problem is made. A failed terminal connection, terminal corrosion or damaged wire will result in an electrical system fault.

Product Features:

Carquest electrical connectors meet or exceed OE wire gauge, insulation, and terminal material requirements.
WVE electrical connectors meet or exceed OE wire gauge, insulation, and terminal material requirements.
Product constructed to meet all design and operating characteristics as intended by the manufacturer.
OE specified wire gauge to ensure a reliable electrical connection
Designed to meet or exceed OE specifications in form, fit and function

from

$5.99

This door lock rod clip is designed to match the fit and function of the original part on specified vehicles. Made of quality materials, it is engineered for reliable performance.

Product Features:

Direct replacement – this door lock rod clip matches the fit and function of the factory part on specified years, makes and models
Ideal solution – this clip is a reliable replacement for an original part that is missing or has failed due to fatigue
Durable construction – this part is made from quality materials to ensure reliable performance and long service life
Trustworthy quality – backed by team of product experts in the United States and more than a century of automotive experience

from

$5.79

Carquest Premium Vehicle Solutions provides high-quality solutions for a wide range of applications. The Door Jam Switch detects whether a vehicle door is open or closed, enhancing safety by triggering interior lights and warning systems to prevent accidents or potential damage while driving. Engineered for maximum performance and durability, our products are built to excel in even the most demanding conditions, ensuring reliable operation and long-lasting value.

Product Features:

Durable Construction: Designed with high-quality materials to withstand harsh environmental conditions, ensuring long-lasting performance in extreme temperatures, vibrations, and moisture exposure.
Precision Engineering: Accurate sensing and switching capabilities provide reliable performance, reducing the risk of malfunctions and improving vehicle safety and efficiency.
Easy Installation & Maintenance: Designed for quick installation and minimal upkeep, reducing downtime and repair costs for both manufacturers and consumers.
Fit/Form/Function: Each vehicle electronic component is engineered to meet or surpass OEM standards, ensuring precise fit, optimal functionality, and reliable performance.

from

$1.79

Constructed of quality materials, this multi-purpose retainer provides the same function and versatility as the original equipment retainer ensuring Length service life.

Product Features:

Ideal replacement – this retainer matches the fit and function of the original equipment retainer for this vehicle application
Quality material – this retainer is made of durable material for Length-lasting service
Versatile design – this retainer is suitable for a variety of automotive uses
Excellent value – this part offers original equipment quality at a competitive cost

from

$14.99

New Goodmark Window Crank Handle For Models Built After 3/8/65, Requires Screw [Not Included]

Product Features:

Requires Screw (Not Included)
Meets All Federal Motor Safety Standards
No Drilling Needed For Installation
No Modifications Needed For Installation
Direct Fit Replacement For Your Vehicle
Same Form Fit And Function As OE
Check Out The Large Selection Of Parts Available For Your Vehicle

from

$10.99

Dorman’s Power Window Motor Gear Plug is manufactured for cost-saving convenience. Save time, money and labor by replacing only the plug-instead of the entire gear assembly.

Product Features:

Restores motor gear to proper operation
Direct replacement for a proper fit every time
Includes all plugs needed for complete repair
Quality-tested for a trouble-free performance

from

$80.99

This door hinge is designed to match the function of an original equipment hinge on specified vehicles. It is engineered to securely connect a door and door frame to help restore proper door operation and replace a rusted, failed, or damaged hinge.

Product Features:

Direct replacement – this door hinge is designed to match the fit, function and performance of an original equipment hinge on specified vehicles
Ideal solution – engineered to securely connect a door and door frame to help restore proper door operation, and seamlessly replace a rusted, failed, or damaged hinge
Durable construction – designed and manufactured to strict specifications for reliable performance
Trustworthy quality – backed by a team of product experts in the United States and more than a century of automotive experience

from

$68.99

New Goodmark Driver Side Fender Apron

Product Features:

Made Of Steel
Meets All Federal Motor Safety Standards
No Drilling Needed For Installation
No Modifications Needed For Installation
Direct Fit Replacement For Your Vehicle
Same Form Fit And Function As OE
Check Out The Large Selection Of Parts Available For Your Vehicle

from

$93.99

This door lock actuator has undergone extensive quality and safety testing to ensure reliable performance. It is engineered to provide a direct replacement for the stock actuator on specific vehicle years, makes and models.

Product Features:

Reliable replacement – this door lock actuator has undergone extensive quality and safety performance testing
Perfect fit – engineered to provide the same fit and function of the original actuator on specific vehicle years, makes and models
Safety compliant – part has undergone simulated crash testing under government guidelines
Long-lasting repair – cycle testing in an actual vehicle door verifies effective usage for years

from

$66.99

New Goodmark Driver Side Rear Fender Apron

Product Features:

Made Of Plastic
Meets All Federal Motor Safety Standards
No Drilling Needed For Installation
No Modifications Needed For Installation
Direct Fit Replacement For Your Vehicle
Same Form Fit And Function As OE
Check Out The Large Selection Of Parts Available For Your Vehicle

from

$26.99

Relays are electrical switches used to convert a small electrical load into a circuit capable of handling a high amperage load. Computers and small switches are not designed to carry the higher amperage requirement of a circuit that may have an electric motor, solenoid, or high amperage lighting fixture. Within a relay are contacts that are controlled with electromagnetism, when the circuit switch commands the device on or off, magnetism will pull or release the contact arm closing or opening the contacts within the relay that carry the voltage.

Product Features:

Product constructed to meet all design and operating characteristics as intended by the vehicle manufacturer.
Computer-Aided Design (CAD), laser scanning and 3D printing – utilizing Fused Deposition Modeling (FDM) and Stereolithography (SLA) – in the part design process ensures speed-to-market and a precise fit guaranteed.
Where applicable, robust circuit board design increases durability due to heat, shock, and random electro-magnetic pulses (EMP) and power spikes.
Tin plated lead frame prevents corrosion and ensures a reliable terminal connection under adverse ambient conditions.
100% thermo-shock and vibration tested to ensure superior performance in extreme conditions.
100% end-of-line tested to ensure accurate signal output providing product reliability, every time.