Jeep Scrambler Drivetrains
Top Jeep Scrambler Drivetrains Categories
We carry over 233 Drivetrains in inventory for the Jeep Scrambler. If you’re looking for aftermarket Drivetrains for your Jeep Scrambler, check out all these categories:
Essential Jeep Scrambler Drivetrains
Yukon Gear – Carrier Installation Kit For Dana 30 Differential (Part No.57002)
from
$99.99
Yukon Carrier installation kits are great, low cost kit for carrier changes such as Positraction or locker upgrades. Carrier installation kit for Dana 30 differential. This kit contains carrier bearings, races and shims.
Product Features:
See More
Product Features:
- Fits Dana Spicer 30
- Includes carrier bearings and races and carrier shim kit
Yukon Gear – Pinion Install Kit For Model 20 Differential (Part No.13082)
from
$175.99
Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings & races can be reused. This kit uses Timken bearings and races along with a high quality pinion seal and small parts. Included in this kit are the pinion bearings and races, pilot bearing (if applicable), crush sleeve (if applicable), complete pinion shim kit, thread locker, and marking compound with brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your pinion gear.
Product Features:
See More
Product Features:
- Fits AMC Model 20
- Included are pinion bearings and races, pinion seal, crush sleeve, complete pinion shim kit, and marking compound with brush.
Yukon Gear – Power Lok Positraction Internals For Dana 44 And Chysler 8.75" With 30 Spline Axles (Part No.16005)
from
$503.99
Yukon Power Lok positraction replacement internals for Dana 44 and Chysler 8.75″ with 30 spline axles. Yukon uses higher quality materials and better techniques than OEM to ensure a longer lasting spider gear set. This kit does not include clutches. All components come with a one year warranty against manufacturing defects.
Product Features:
See More
Product Features:
- Spider gear kit
- Fit Dana Spicer 44 and Chrysler 8.75″ Powr Lok positraction
- Includes two side gears, four pinion gears, cross pin shafts and side gear thrust washers.
Yukon Gear – Model 20 & Model 35 Axle Stud 1/2"-20 X 1.625" Length, 0.620" Dia – Knurl (Part No.33181)
from
$5.99
Model 20 & Model 35 axle stud 0.620″ Dia. Shank.
Product Features:
See More
Product Features:
- Axle stud for AMC Model 20 and Model 35
- 1/2″ x 20 thread
- 0.620″ knurl diameter
- 1.625″ long
Yukon Gear – Replacement Carrier Shim Kit For Dana Spicer 44, 30 Spline Axles (Part No.55010)
Yukon Gear – 1310 & 1330 U/Joint Strap, Dana 30, Dana 44, Model 35, & 9.25" With Bolts (Part No.41195)
from
$18.99
1310 & 1330 U/joint strap, Dana 30, Dana 44, Model 35, & 9.25″ w/bolts.
Product Features:
See More
Product Features:
- u-joint strap kit
- Fits Dana Spicer 30 and 44, AMC Model 35 and Chrysler 9.25″
- 1310 and 1330 u-joint size
- Includes two straps and four bolts
Yukon Gear – Replacement Complete Shim Kit For Dana 30 Front (Part No.55022)
Yukon Gear – Dana 30 Side Gear Thrust Washer (Part No.33284)
from
$10.99
Dana 25, Dana 27, & Dana 30 side gear Thrust washer.
Product Features:
See More
Product Features:
- Side gear thrust washer for Dana Spicer 25, 27, 30 and AMC Model 35
- 1.560″ I.D.
- Fits standard open differentials only
Yukon Gear – Replacement Pinion Nut For Dana 25, 27, 30, 36, 44, 53 & GM 7.75" (Part No.33143)
from
$6.99
Yukon Ring & Pinion sets give you the confidence of knowing you’re running gears designed for the harshest of conditions. Whether it’s on the street, off-road, or at the track; Yukon ring & pinion sets deliver unrivaled performance & quality. Yukon uses t
Product Features:
See More
Product Features:
- Pinion nut for Dana Spicer 25, 27, 30, 44, 50 and GM 7.75″
- 3/4″ x 16 thread
Yukon Gear – Model 20 Gasket (Part No.23025)
Yukon Gear – Dana 44 Steel Spool Replacement (Part No.32168)
from
$314.99
Yukon Performance steel spool for Dana 44 with 30 spline axles. fits 3.73 and down. Yukon performance spools are made from the highest quality materials to ensure high strength and long life in performance applications. Spools provide 100% power to both tires at all times and are a lower cost alternative to lockers. Spools are not recommended for street driven vehicles. Yukon Performance spools come with a one year warranty against manufacturing defects.
Product Features:
See More
Product Features:
- Fits Chrysler Dana Spicer 44 with 30 spline axles
- 3.73 and down ratio only
- Provides 100% traction to both wheels at all times
- Not recommended for street driven vehicles
Yukon Gear – O-Ring For Toyota & Dana 44 Zip Locker Seal Housing (Part No.34004)
from
$11.29
Product Features:
See More
- O-ring for seal housing
- Fits Dana Spicer 44 and Toyota 8″ and V6
Yukon Gear – Replacement Standard Open Carrier Case For Dana 44, 3.92 & Up (Part No.20028)
from
$149.99
Yukon replacement standard open carrier case for Dana 44, 3.92 & up, 2-3/8″ tall.
Product Features:
See More
Product Features:
- Standard open carrier case
- Fits Dana Spicer 44 with 30 spline axles
- 3.92 and up ratio only
- Does not include spider gears
Yukon Gear – Dana 30 & Dana 44 Power Lok Bolt, Left Hand, & 8.75" Chrysler & 55P (Part No.33234)
from
$26.99
Dana 30 & Dana 44 Power Lok bolt, left hand, & 8.75″ Chrysler & 55P.
Product Features:
See More
Product Features:
- Power Lok case bolt for Dana Spicer 30, Dana Spicer 44, Chrysler 8.75″ and 1955-1964 GM passenger car
- Left hand thread
Yukon Gear – Replacement Cross Pin Shaft For Dana 44, Standard Open (Part No.33318)
from
$16.99
Product Features:
See More
- Cross pin shaft for Dana Spicer 44
- Fits standard open differentials only
Yukon Gear – Pinion Depth Shims For GM 8.25" IFS, 8.5", 12 Bolt Car, Ford 8.8" & Chrysler 8.25" (Part No.55009)
from
$27.99
8.25″ IFS, 8.5″, 12P, 7.5″ F, 8.8″ F, 8.25″ Chrysler pinion shim kit.
Product Features:
See More
Product Features:
- Pinion depth shims for GM 8.25″ IFS, 8.5″, 8.6″, 12 bolt passenger car, Ford 7.5″ and 8.8″, Chrysler 8.25″
Yukon Gear – The Carrier Bearing Puller (Part No.56072)
from
$883.99
The Yukon carrier bearing Puller works with an impact gun to quickly and safely remove carrier bearings without damaging them. This unit comes with a handy bench top stand and works with up to one ton applications including Dana 70HD, Dana 80, 10.25″ & 10.5″ Ford, or GM & Chrysler 11.5″ differentials.
Product Features:
See More
Product Features:
- Carrier bearing puller
- Works with an impact gun to safely and easliy remove carrrier bearings
Yukon Gear – Dana 30 / 44 Roll Pin Replacement (Part No.33312)
from
$12.99
Dana 30 & Dana 44 roll PIN, 0.235″ DIA, for cross pin shaft.
Product Features:
See More
Product Features:
- Roll pin for Dana Spicer 30 and Dana Spicer 44
- 0.235″ diameter
Yukon Gear – Dana 25, 27, 30, 44, Model 20 And Model 35, GM 7.5", 8.2", 8.5", 12P, 12T, C9.25 Rear Cover Bolt (Part No.33286)
from
$9.99
5/16″-18 cover bolt, Dana Spicer 25, 27, 30 and 44, AMC Model 20 and Model 35, Chrysler 9.25 rear, GM 7.5″, 7.625″, 8.2″, 8.5″, 12 bolt passenger car and truck.
Product Features:
See More
Product Features:
- Cover bolt for Dana Spicer 25, 27, 30 and 44, AMC Model 20 and Model 35, GM 7.5″, 7.625″, 8.2″, 8.5″ and 12 bolt passenger car and truck.
- 1/2″ head
Yukon Gear – Powr Lok Flat Driven Plate For Dana 44 (Part No.16173)
Yukon Gear – Replacement Ring Gear Bolt For Model 20, Grand Cherokee 35, "Super" Dana 30 & Dana 50 – 7/16" X 20 (Part No.33040)
from
$3.99
Replacement ring gear bolt for Model 20, Grand Cherokee 35, “Super” Dana 30 & Dana 50. 7/16″ x 20.
Product Features:
See More
Product Features:
- Ring gear bolt for AMC Model 20, “Super” 35, Dana Spicer “Super” 30 and Dana Spicer 50
- 7/16″ 20 thread
Yukon Gear – Replacement Cover Gasket For Dana 30 (Part No.23003)
Yukon Gear – 1541H Alloy 2 Piece Right Hand Short Axle For Model 20 (’82-’86 CJ7) (Part No.21650)
from
$194.99
Yukon 1541H alloy 2 piece right hand short axle for Model 20 (’82-’86 CJ7) with a length of 31-5/8″ inches long and 29 splines. Yukon 1541H alloy axles offer a strength increase over stock while retaining a low cost. Yukon 1541H alloy axles come with a five year warranty against manufacturing defects.
Product Features:
See More
Product Features:
- 29 spline
- 31 5/8″ long
- Fits AMC Model 20 in 1982-1986 CJ7
- Two piece axle
- Right hand side
- Does not include hub
USA Standard Gear – Spartan Spring & Pin Kit, Fits Smaller Designs (Part No.17011)
from
$26.99
Spartan spring & pin kit, fits smaller designs.
Product Features:
See More
Product Features:
- Replacement spring and pin kit for Spartan Locker
- Fits Dana 30, Dana 44, AMC Model 20, AMC Model 35, and Toyota designs
- Includes 4 springs and 4 alignment pins
Yukon Gear – Replacement Redi-Sleeve Yoke Saver For Dana 25, Dana 27, Dana 30, Dana 44, Dana 50 (Part No.30222)
from
$182.99
Replacement redi-sleeve yoke saver for Dana 25, Dana 27, Dana 30, Dana 44, Dana 50 .Yukon Mighty seal.
Product Features:
See More
Product Features:
- Pinion Redi-sleeve
- Fits Dana Spicer 25, 27, 30, 4 and 50
Jeep Scrambler Drivetrains Categories
Helping You Find the Right Drivetrains for Your Jeep Scrambler
You love your Scrambler. So we’ve made it easier than ever to help you find Jeep Scrambler Drivetrains in our online catalog. Our inventory holds 233 aftermarket and OEM Drivetrains for your Jeep Scrambler, ranging from $3.99 to $1,303.99.
We offer parts from 4 brands trusted to make quality Drivetrains for your Jeep Scrambler. Before you buy, take some time to read through customer reviews. We currently have 2 reviews of Jeep Scrambler Drivetrains from previous customers.
Find your Scrambler Drivetrains here, order online, and have your order shipped directly to your home. Prefer to have an in-person look at your Jeep Scrambler part to confirm it’s just right? You can find your nearest Advance Auto Parts store and confirm they have the part in stock before heading over.
Top Drivetrains Brands for Your Jeep Scrambler
Our inventory holds Drivetrains for your Jeep Scrambler from 4 trusted brands. You’ll find OEM and aftermarket parts from brands like Yukon Gear, USA Standard Gear, and Autopart International Inc, all of which can keep that Jeep happy.
We have Yukon Gear parts available for your Jeep Scrambler in categories like Drive Shafts and Axles. Some of the top-rated Yukon Gear parts in these categories are:
FAQs for Jeep Scrambler Drivetrains
What are the most purchased Drivetrains for the Jeep Scrambler?
Out of 233 Drivetrains for the Jeep Scrambler, the most popular in our inventory are:
from
$11.99
This product is not rated
Replacement Ring Gear Bolt For Model 35, Dana 25, 27, 30 & 44 – 3/8" X 24
Differential Ring Gear Bolts
from
$9.99
This product is not rated
Dana 25, 27, 30, 44, Model 20 And Model 35, GM 7.5", 8.2", 8.5", 12P, 12T, C9.25 Rear Cover Bolt
Differential Cover Bolts
