Dodge D300 Drivetrains
Top Dodge D300 Drivetrains Categories
We carry over 363 Drivetrains in inventory for the Dodge D300. If you’re looking for aftermarket Drivetrains for your Dodge D300, check out all these categories:
Essential Dodge D300 Drivetrains
Yukon Gear – Dana 60 & Dana 70 Power Lok Case Bolt (Part No.33236)
from
$7.99
Dana 60 & Dana 70 Power Lok case bolt.
Product Features:
See More
Product Features:
- Power Lok case bolt for Dana Spicer 60 and 70
- 7/16 x 14 thread
- 3.5″ long
- 9/16″ hex head
Yukon Gear – Pinion Install Kit For Chrysler 9.25" Differential (Part No.13011)
from
$269.99
Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings & races can be reused. This kit uses Timken bearings and races along with a high quality pinion seal and small parts. Included in this kit are the pinion bearings and races, pilot bearing (if applicable), crush sleeve (if applicable), complete pinion shim kit, and marking compound with brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your pinion gear.
Product Features:
See More
Product Features:
- Fits Chrysler 9.25″ rear
- Included are pinion bearings and races, pinion seal, crush sleeve , complete pinion shim kit, and marking compound with brush.
Yukon Gear – 3 Qt – Penzoil 80W90 Conventional Gear Oil (Part No.15002)
from
$44.99
3 Qt. Penzoil 80W90 conventional gear Oil.
Product Features:
See More
Product Features:
- Includes three quarts of conventional oil
Motive Gear – Differential Master Bearing Kit – Timken (Part No.R70HRMKT)
Yukon Gear – Steel Spool For Dana 60 With 35 Spline Axles, 4.10 & Down (Part No.32042)
from
$506.99
Yukon Performance steel spool for Dana 60 with 35 spline axles. fits 4.10 and down. Yukon performance spools are made from the highest quality materials to ensure high strength and long life in performance applications. Spools provide 100% power to both tires at all times and are a lower cost alternative to lockers. Spools are not recommended for street driven vehicles. Yukon Performance spools come with a one year warranty against manufacturing defects.
Product Features:
See More
Product Features:
- Fits Chrysler Dana Spicer 60 with 35 spline axles
- 4.10 and down ratio only
- Provides 100% traction to both wheels at all times
- Not recommended for street driven vehicles
USA Standard Gear – Spartan Locker Replacement Cross Pin For Dana 60 (Part No.17019)
from
$52.99
Product Features:
See More
- USA Standard Gear heavy-duty cross pin shaft
- Fits Dana Spicer 60
- Works with Spartan Locker or standard open spider gears
Yukon Gear – Cross Pin Bolt (Part No.33067)
from
$6.99
Cross pin bolt for Chrysler 8.25″, 9.25″ rear, Ford 7.5″, 8.8″, GM 12 bolt car & truck, 7.2″ IFs, 7.5″, 7.6″, 8.0″, 8.25″ IFS & 8.5″.
Product Features:
See More
Product Features:
- Cross pin bolt for Chrysler 8.25″ and 9.25″ rear, Ford 7.5″ and 8.8″, GM 12 botl car and truck, 8.5″, 8.25″ IFS, 8.0″, 7.625″, 7.5″ and 7.2″ IFS
Yukon Gear – Replacement Cover Gasket For Dana 50, Dana 60 & Dana 70 (Part No.23007)
Dorman – Oil Drain Plug Differential Plug Chrysler 2008-2000, Head Size (Part No.090-062CD)
from
$8.99
This differential cover plug is designed to match the fit and function of the original part on specified vehicles. Made of quality materials, it is engineered for reliable performance.
Product Features:
See More
Product Features:
- Direct replacement – this differential cover plug matches the fit and function of the factory part on specified years, makes and models
- Ideal solution – this plug is a reliable replacement for an original part that is missing or has failed due to fatigue
- Durable construction – this part is made from quality materials to ensure reliable performance and long service life
- Trustworthy quality – backed by team of product experts in the United States and more than a century of automotive experience
Motive Gear – Differential Gear Install Kit (Part No.D70IK)
Yukon Gear – Replacement Ring Gear Bolt For Dana 60, 70, 70U & 70HD, 1/2" X 18 (Part No.33037)
from
$4.99
Replacement ring gear bolt for Dana 60, 70, 70U & 70HD, 1/2″ x 18.
Product Features:
See More
Product Features:
- Ring gear bolt for Dana Spicer 60, 70, 70U and 70HD
- 1/2″ x 18 thread
Yukon Gear – Chrysler 9.25" And Dana 44 / 60 Tracloc Clutch Guide Replacement (Part No.33249)
from
$8.99
Product Features:
See More
- Clutch guide for Chrysler 9.25″, Dana Spicer 44 and Dana Spicer 60
- For Trac Loc positraction applications only
Dorman – Help – Axle Nut Locking Wedge Key (Part No.81036)
from
$4.49
This spindle nut retainer is designed to match the fit and function of the original part on specified vehicles. Made of quality materials, it is engineered for reliable performance.
Product Features:
See More
Product Features:
- Direct replacement – this spindle nut retainer matches the fit and function of the factory part on specified years, makes and models
- Ideal solution – this retainer is a reliable replacement for an original part that is missing or has failed due to fatigue
- Durable construction – this part is made from quality materials to ensure reliable performance and long service life
- Trustworthy quality – backed by team of product experts in the United States and more than a century of automotive experience
Yukon Gear – Replacement Carrier Shim Kit For Dana 60, 70, 70HD, 70U & 80 (Part No.55011)
Spicer – Differential Ring and Pinion (Part No.25127-5X)
from
$549.99
All Spicer ring and pinion gears are designed and tested to meet original equipment specifications. When you purchase genuine Spicer ring and pinion gear sets, you can be confident the ring and pinion set will meet or exceed the exact Dana standards that original equipment manufacturers have relied upon for more than a hundred years.
See More
Yukon Gear – Replacement Positraction Internals For Dana 60 (Full- And Semi-Floating) With 35 Spline Axles (Part No.16088)
from
$659.99
Yukon replacement positraction internals for Dana 60 (full- and semi-floating) with 35 spline axles. Yukon uses higher quality materials and better techniques than OEM to ensure a longer lasting spider gear set. This kit includes clutches. All components come with a one year warranty against manufacturing defects.
Product Features:
See More
Product Features:
- Spider gear kit
- Fits Dana Spicer 60 with Trac Loc positraction with 35 spline axles
- Includes two side gears, two pinion gears, cross pin shaft, roll pin and spider gear thrust washers.
Yukon Gear – Zip Locker Bulkhead Quick-Disconnect Fitting (Part No.34038)
Yukon Gear – Six Piece Side Gear And Thrust Washer Kit For Chrysler 8" And 9.25" (Part No.33278)
from
$88.99
Six piece side gear thrust washer kit for Chrysler 8″ and 9.25″.
Product Features:
See More
Product Features:
- Side gear thrust washer kit
- Fits Chrysler 8″ and 9.25″
Driveworks – Oil Seal (Part No.S-9316)
from
$3.99
Value-priced seal meets all cataloged application requirements.
Product Features:
See More
Product Features:
- Brand may vary by location
Yukon Gear – Carrier Installation Kit For Dana 60 Differential (Part No.57005)
from
$182.99
Yukon Carrier installation kits are great, low cost kit for carrier changes such as Positraction or locker upgrades. Carrier installation kit for Dana 60 differential. This kit contains carrier bearings, races and shims.
Product Features:
See More
Product Features:
- Fits Dana Spicer 60
- Includes carrier bearings and races and carrier shim kit
Motive Gear – Differential Pinion Shim Kit (Part No.1102)
Yukon Gear – Flange Yoke For Chrysler 9.25" (Part No.41012)
from
$267.99
Yukon flange yoke for Chrysler 9.25″. All Yukon yokes come with a one year warranty against manufacturing defects.
Product Features:
See More
Product Features:
- Fits Chrysler 9.25″ rear
- 29 spline
- Round companion flange
Yukon Gear – Round Replacement Yoke Companion Flange For Dana 60 And 70 (Part No.41033)
from
$287.99
Yukon round replacement yoke companion flange for Dana 60 and 70. All Yukon yokes come with a one year warranty against manufacturing defects.
Product Features:
See More
Product Features:
- Fits Dana Spicer 60 and 70
- 29 spline
- 5.00″ O.D.
- 8 x 4.25″ bolt pattern
- Round companion flange
Yukon Gear – 1350 Lifetime Series U/Joint (Part No.42021)
from
$56.99
Yukon 1350 Lifetime Series U/Joint. 3.625″ snap ring span, 1.188″ cap diameter. Outside snap ring.
See More
Victor Reinz – Differential Cover Gasket (Part No.71-14868-00)
from
$8.79
With Victor Reinz gaskets, you can be sure you are getting sealing solutions that deliver OE quality gasket technology and engineering. That is because Victor Reinz is an original equipment supplier and the trusted choice of manufacturers the world over, offering broad coverage for foreign and domestic cars and trucks. In Victor Reinz gasket sets, you get the right combination of components needed for fast, long-lasting repairs.
Product Features:
See More
Product Features:
- Choosing Victor Reinz assures getting OE quality parts in gaskets sets that have the coverage, contents, packaging and electronic cataloging to best meet the needs of the aftermarket.
Dodge D300 Drivetrains Categories
Helping You Find the Right Drivetrains for Your Dodge D300
You love your D300. So we’ve made it easier than ever to help you find Dodge D300 Drivetrains in our online catalog. Our inventory holds 363 aftermarket and OEM Drivetrains for your Dodge D300, ranging from $2.29 to $1,487.99.
We offer parts from 16 brands trusted to make quality Drivetrains for your Dodge D300. Before you buy, take some time to read through customer reviews. We currently have 3,978 reviews of Dodge D300 Drivetrains from previous customers. Some of the top rated parts include Differential Plug, Rubber, Chrysler 2008-2000 with 4.8 stars and Bearings with 4.5 stars.
Find your D300 Drivetrains here, order online, and have your order shipped directly to your home. Prefer to have an in-person look at your Dodge D300 part to confirm it’s just right? You can find your nearest Advance Auto Parts store and confirm they have the part in stock before heading over.
Top Drivetrains Brands for Your Dodge D300
Our inventory holds Drivetrains for your Dodge D300 from 16 trusted brands. You’ll find OEM and aftermarket parts from brands like National, Yukon Gear, and Dorman, all of which can keep that Dodge happy.
We have Dorman parts available for your Dodge D300 in categories like Spindles. Some of the top-rated Dorman parts in these categories are:
from
$4.99
(3)
Spindle Nut 3/4 In.-16 and M20 In.-1.0 Hex Size 1-1/16 In. and 27mm
Spindle Retainers
Top-Rated National Drivetrains
Leading National Drivetrains
We carry National brand parts for your Dodge D300 across several catalog categories, including Drive Shafts and Axles. Some of our most reviewed National parts include:
FAQs for Dodge D300 Drivetrains
What are the most purchased Drivetrains for the Dodge D300?
Out of 363 Drivetrains for the Dodge D300, the most popular in our inventory are:
What are the top-rated Dodge D300 Drivetrains?
Top-rated Drivetrains for your Dodge D300 based on customer reviews/ratings are:
from
$5.99
(11)
Differential Plug, Rubber, Chrysler 2008-2000
“I used this Rubber plug to fill a pre-drilled hole in a air intake tube that I customized for a particular application in my car, and it works beautif”
