2003 Mazda 6 Performance Air Intake Kits

The AEM Performance Cold Air Intake System produces horsepower And torque gains by replacing your vehicle’s restrictive factory air filter And air intake housing. This air intake system was designed, tuned And dyno-tested to fit specific models. Air enters the system through an oversized AEM Dryflow synthetic washable air filter for outstanding air flow, filtration And performance. The air filter is located in the original air box space And is protected by a heat shield which is designed to reduce intake air temperature And increase horsepower. The air intake tube is constructed from mandrel-bent aluminum featuring a durable gunmetal gray powder coated finish. This air intake system was developed to accommodate the engine’s factory emissions control devices including the mass airflow sensor And breather tube. The tapered cylinder shaped AEM Dryflow air filter is made from an oil-free, synthetic filter media that can be used for up to 100,000 miles before cleaning is needed (depending on driving conditions). The air intake system is easy to install with commonly available tools And it is backed by AEM’s Lifetime Limited Warranty. Some AEM air intakes are not legal for sale or use in California And other states adopting California emission standards, while others are 50 state legal. View the vehicle applications to determine the legal status for each vehicle.

The K&N 69-6025TS Typhoon cold-air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit some Mazda 6 models. The restrictive factory air filter and air intake housing are replaced by the K&N Typhoon cold-air intake which is designed to pull in outside air and dramatically reduce air flow restriction by smoothing and straightening air flow. This allows your engine to inhale a larger amount of air than the factory air intake. More air means more usable power and acceleration throughout the engine’s RPM range. The 69-6025TS cold-air intake consists of a black rubber topped K&N high-flow air filter that mounts near the driver side wheel well directing outside air through free-flowing aluminum tubing into a short ram induction tube that delivers high volumes of clean air into the engine’s throttle body for a guaranteed power gain. The oversized cone shaped air filter comes with a water repellent DryCharger filter wrap to protect the filter from moisture. The air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This cold air intake is relatively easy to install usually in 90 minutes or less. Some Typhoon air intakes are not legal for sale or use in California and other states adopting California emission standards while others are CARB exempt and 50 state legal. Check the K&N catalog or website for vehicle applications and specific CARB status for each vehicle and air intake.