2002 Lexus GS430 Drivetrains

Essential 2002 Lexus GS430 Drivetrains

SKF – Differential Seal (Part No.J7040183450SKF)

Differential Seal

from

$27.29
Differential Seal

Valvoline – Import Multi-Vehicle Automatic Transmission Fluid, 1 Gallon (Part No.820681)

Import Multi-Vehicle Automatic Transmission Fluid, 1 Gallon

from

$36.99
Valvoline Import Multi-Vehicle Automatic Transmission Fluid is specifically formulated for use in most Toyota, Nissan, Honda and other imported vehicles. It is formulated with all synthetic base stocks and a proprietary additive system to ensure optimal transmission performance in a wide variety of vehicles. Valvoline Import Multi-Vehicle ATF can also be used in many domestic vehicles. It meets requirements of General Motors and Ford vehicles. Recommended for use in the following applications: Ford MERCON®, GM DEXRON®-II and DEXRON®-III, BMW LT 71141 and ETL-7045E, Nissan/Infiniti Nissan ATF, Matic-D, Matic-K and Matic-J, Mitsubishi Diamond SP-II and SP-III, Subaru ATF-HP, Hyundai/ KIA SP-II and SP-III , Toyota/Lexus Type T, T-III and T-IV , Honda/Acura ATF-Z1 (except in CVTs) , Mercedes Benz NAG1 , Volvo passenger car (except AW-1), and Volkswagen/Audi TL52162. For CVT applications Valvoline recommends Valvoline Full Synthetic CVT Fluid.

Product Features:
  • Formulated with full-synthetic base stocks and advanced additive technology to meet the challenging demands of automatic transmissions.
  • Enhanced anti-shudder protection for smooth shifting and maximum power transfer
  • Developed with anti-wear technology to help improve transmission durability
  • Engineered with a proprietary blend of base oils and advanced additives to provide better oil flow at low temperatures and greater film protection at higher temperatures
See More

Valvoline – VAL EP ATF 6/1 QT (Part No.899179)

VAL EP ATF 6/1 QT

from

$14.99
VAL EP ATF 6/1 QT

NOK – Drive Axle Seal (Part No.J7043183444NOK)

Drive Axle Seal

from

$9.45
Drive Axle Seal

Driveworks – Taper Bearing Cup (Part No.S-HM-88610)

Taper Bearing Cup

from

$6.49
Value-priced bearing meets all cataloged application requirements.

Product Features:
  • Brand may vary by location
See More

Dorman – Rear Drive Shaft: Adjustable (Part No.976-755)

Rear Drive Shaft: Adjustable

from

$787.99
Replacing a drive shaft doesn’t have to be complicated. This complete drive shaft assembly is pre-balanced and ready to install with 100% new yokes, tubes, constant velocity (CV) joints and universal joints.

Product Features:
  • Direct replacement – this drive shaft is made to the original equipment dimensions for dependable fit and performance
  • 100% new – this drive shaft is made from all new components so there’s no core charge or return hassle
  • Ready to install – this drive shaft arrives pre-balanced to make installation quick and simple
  • Serviceable construction – non-staked universal joints are designed for future serviceability
See More

Dorman – Rear Drive Shaft: Adjustable (Part No.976-760)

Rear Drive Shaft: Adjustable

from

$862.99
Replacing a drive shaft doesn’t have to be complicated. This complete drive shaft assembly is pre-balanced and ready to install with 100% new yokes, tubes, constant velocity (CV) joints and universal joints.

Product Features:
  • Direct replacement – this drive shaft is made to the original equipment dimensions for dependable fit and performance
  • 100% new – this drive shaft is made from all new components so there’s no core charge or return hassle
  • Ready to install – this drive shaft arrives pre-balanced to make installation quick and simple
  • Serviceable construction – non-staked universal joints are designed for future serviceability
See More

Driveworks – Taper Bearing Cone (Part No.S-HM-88649)

Taper Bearing Cone

from

$19.29
Value-priced bearing meets all cataloged application requirements.

Product Features:
  • Brand may vary by location
See More

National – Bearings (Part No.30025)

Bearings

from

$89.99
National Oil Seals & Bearings offer a full line of premium oil seals and bearings.

Product Features:
  • Premium bearing design matches OEM specifications
  • Precision manufactured using premium-grade steel for outstanding durability and performance
  • Matched cup and cone components ensures consistent quality and outstanding performance
  • Industry leading coverage
  • Professional technicians know they can depend on National
See More

Anchor – Center Support Bearing Motor Mount: Center, 1 Piece (Part No.6099)

Center Support Bearing Motor Mount: Center, 1 Piece

from

$54.99
Center support bearings or Carrier Support Bearings are used when the driveshaft is split into two sections. It serves as a junction on the drive shaft between the transmission and the differential allowing the driveshaft to flex, relieving stress on other drive line components. Each part is engineered and designed to OE Standards. Applicable to LEXUS 06-20;. Please verify your application.

Product Features:
  • MAXIMUM VIBRATION DAMPENING: Rubber cushion is made of high grade rubber that ensures maximum dampening of vibration and the ability to absorb over loads.
  • HEAVY GAUGE STEEL FRAME: The housing frame is made from heavy gauge steel with durability that extends the service life.
  • READY TO INSTALL: Most center supports include a sealed bearing and dust shield and are ready to install.
  • For Years: 2006-2020
  • Weight approx: 2 Lbs
  • BEARING ID / BORE: 1.1811 INCH / 30 MM
  • CENTERLINE: 0.50 INCH / 13 MM
  • MOUNT WIDTH: 5.75 INCH / 146 MM
See More

Anchor – Center Support Bearing Motor Mount: Center, 1 Piece (Part No.6085)

Center Support Bearing Motor Mount: Center, 1 Piece

from

$104.99
Center support bearings or Carrier Support Bearings are used when the driveshaft is split into two sections. It serves as a junction on the drive shaft between the transmission and the differential allowing the driveshaft to flex, relieving stress on other drive line components. Each part is engineered and designed to OE Standards. Applicable to LEXUS 98-10;. Please verify your application.

Product Features:
  • MAXIMUM VIBRATION DAMPENING: Rubber cushion is made of high grade rubber that ensures maximum dampening of vibration and the ability to absorb over loads.
  • HEAVY GAUGE STEEL FRAME: The housing frame is made from heavy gauge steel with durability that extends the service life.
  • READY TO INSTALL: Most center supports include a sealed bearing and dust shield and are ready to install.
  • For Years: 1998-2010
  • Weight approx: 6 Lbs
  • BEARING ID / BORE: 1.1811 INCH / 30 MM
  • CENTERLINE: 0.10 INCH / 3 MM
  • MOUNT WIDTH: 6.15 INCH / 156 MM
  • STYLE: ROUND FRAME
  • WITH WINGS
See More

Anchor – Center Support Bearing Motor Mount: Center, 1 Piece (Part No.6098)

Center Support Bearing Motor Mount: Center, 1 Piece

from

$137.99
Center support bearings or Carrier Support Bearings are used when the driveshaft is split into two sections. It serves as a junction on the drive shaft between the transmission and the differential allowing the driveshaft to flex, relieving stress on other drive line components. Each part is engineered and designed to OE Standards. Applicable to LEXUS 05-20;. Please verify your application.

Product Features:
  • MAXIMUM VIBRATION DAMPENING: Rubber cushion is made of high grade rubber that ensures maximum dampening of vibration and the ability to absorb over loads.
  • HEAVY GAUGE STEEL FRAME: The housing frame is made from heavy gauge steel with durability that extends the service life.
  • READY TO INSTALL: Most center supports include a sealed bearing and dust shield and are ready to install.
  • For Years: 2005-2020
  • Weight approx: 2 Lbs
  • BEARING ID / BORE: 1.1811 INCH / 30 MM
  • CENTERLINE: 0.10 INCH / 3 MM
  • MOUNT WIDTH: 5.75 INCH / 146 MM
See More

Dorman – Driveshaft Center Support Bearing (Part No.934-406)

Driveshaft Center Support Bearing

from

$94.99
This drive shaft center bearing is designed to match the fit and function of the original bearing on specified vehicles, and is engineered for durability and reliable performance.

Product Features:
  • Direct replacement – this drive shaft center bearing is designed to match the fit and function of the original bearing on specified vehicles
  • Restores functionality – this bearing is made to fit and fully restore part functionality after the original bearing fails
  • Durable construction – this part is made from quality materials to ensure reliable performance and long service life
  • Trustworthy quality – backed by team of product experts in the United States and more than a century of automotive experience
See More

National – Multi Purpose Seal (Part No.710784)

Multi Purpose Seal

from

$21.79
National has built a reputation as one of the most respected names in the industry. We have offered premium sealing solutions for more than 75 years. Our design team keeps pace with the industry and provides advanced solutions for today’s vehicles.

Product Features:
  • Low swell in hydrocarbon fluids
  • Design type: spring loaded; multi-lip
  • Provides good low temperature capability
  • Temperature range: -40°F to 225°F; -40°C to 107°C
  • Delivers quality and reliable performance for every type of repair
See More

2002 Lexus GS430 Drivetrains

You count on your 2002 Lexus GS430 to run right. That means taking care of it with regular maintenance, necessary repairs, and the right parts. Advance Auto Parts can help with all of that thanks to our extensive inventory of trusted Drivetrains. With 12 Drivetrains ranging in price from $6.49 to $787.99, you’re sure to find everything you need for your 2002 Lexus GS430.

Brands matter. If you want to shop a specific Drivetrains brand, we stock 8 different brands like Valvoline, DriveWorks, and National. 2002 Lexus GS430 Drivetrains start as low as $6.49!

One of the best ways to find top quality OEM or aftermarket Drivetrains is by asking professionals. Short of that, you can shop with confidence thanks to our 10 extensive product reviews on 2002 Lexus GS430 Drivetrains.

Did we mention you can order your Drivetrains from our online catalog and have them shipped right to your garage? Or, if you feel like seeing the parts first-hand, search for your nearest Advance Auto Parts location above and pick up in-store when you’re ready. Browse our full Drivetrains inventory for your 2002 Lexus GS430 below to get started!

Top-Rated Drivetrains Brands For Your 2002 Lexus GS430

Trusted Drivetrains OEM and aftermarket product brands are what Advance Auto Parts specializes in. The brands we work with are sure to keep that 2002 Lexus GS430 running right for years to come. In our inventory you’ll find brands like Valvoline, DriveWorks, National, and even more.

Popular National Drivetrains

You’ll find popular National brand products across Differentials. All are waiting to get your 2002 Lexus GS430 back on the road. Some of the top-rated National products in these categories are:
Bearings
from $89.99
(2)
Bearings
Front Differential Pinion Bearings

FAQs for 2002 Lexus GS430 Drivetrains

What are the most purchased Drivetrains for the 2002 Lexus GS430?

Out of 12 Drivetrains for the 2002 Lexus GS430, the most popular in our inventory are:
Taper Bearing Cup
from $6.49
This product is not rated
Taper Bearing Cup
Input Shaft Bearings
Taper Bearing Cone
from $19.29
This product is not rated
Taper Bearing Cone
Front Differential Pinion Bearings
Differential Seal
from $27.29
This product is not rated
Differential Seal
Differential Pinion Seals