from

$436.99

Yukon Bearing installation kits are perfect for shops & builders who have shims on the shelf and are looking to save cost over a Master Overhaul kit. This kit uses Timken bearings and races along with all high quality small parts. kit includes carrier bearings and races, pinion bearings and races, pinion seal, crush sleeve (if applicable), oil baffles and slingers (if applicable), marking compound and brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your ring & pinion set.

Product Features:

Fits 1991 and up Toyota Landcruiser
Included are carrier bearings and races, pinion bearings and races, pinion seal, crush sleeve, marking compound and brush.

from

$192.99

Ring gear bolt kit for Toyota Landcruiser.

Product Features:

Fits standard rotation Toyota Landcruiser
Included are ring gear bolts and nuts

from

$103.99

Yukon Minimum installation kits are a low cost solution for gear changes in newer vehicles where the bearings can be reused. This kit uses all high quality components to ensure a smooth set up. kit includes a pinion seal, crush sleeve (if applicable), complete shim kit, marking compound and brush. No side shims.

Product Features:

Fits standard rotation Toyota Landcruiser
Included are a pinion seal, crush sleeve, complete shim kit, marking compound and brush.

from

$289.99

Product Features:

TOY 10BL 9.5″ LNDCRSR R/P MG 4:88 RATIO

from

$126.99

Bearing race driver front Toyota 7.5″, 8″, Landcruiser, and the Suzuki Samurai. No return. (TOY30306).

Product Features:

Bearing race driver
Fits 30306 race
All steel construction

from

$10.99

Outer oil slinger for Toyota 7.5″, 8″, V6 & Landcruiser.

Product Features:

Outer oil slinger for Toyota 7.5″, 8″, V6 and Landcruiser

from

$26.99

Spartan spring & pin kit, fits smaller designs.

Product Features:

Replacement spring and pin kit for Spartan Locker
Fits Dana 30, Dana 44, AMC Model 20, AMC Model 35, and Toyota designs
Includes 4 springs and 4 alignment pins

from

$4.99

Value-priced bearing meets all cataloged application requirements.

Product Features:

Brand may vary by location

from

$32.99

Product Features:

Cross pin shaft
Fits Toyota Landcruiser

from

$8.51

Axle Seal

from

$5.99

Pinion nut for Suzuki Samurai, Toyota 8″, V6, Landrcuiser (fine spline pinion) & T100/Tacoma with factory locker. 30mm socket, M20 x 1.5 thread.

Product Features:

Pinion nut for Suzuki Samurai, Toyota 8″, V6, Landcruiser with 30 spline pinion and Tacoma/T100 with factory locker
20mm x 1.5 thread
30mm socket

from

$55.99

Yukon small hole yoke for ’82 and older Toyota 8″ and Landcruiser with 27 spline. All Yukon yokes come with a one year warranty against manufacturing defects.

Product Features:

Fits 1982 and down Toyota Landcruiser
27 spline

from

$9.49

Value-priced seal meets all cataloged application requirements.

Product Features:

Brand may vary by location

from

$274.99

Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings & races can be reused. This kit uses high quality bearings and races along with a high quality pinion seal and small parts. Included in this kit are the pinion bearings and races, pilot bearing (if applicable), crush sleeve (if applicable), complete pinion shim kit, pinion nut, thread locker, and marking compound with brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your pinion gear.

Product Features:

Fits standard rotation Toyota Landcruiser
Included are pinion bearings and races, pinion seal, crush sleeve, complete pinion shim kit, and marking compound with brush.

from

$5.49

Product Features:

CRUSH SLEEVE 12 BLT CAR

from

$17.99

Product Features:

Pinion depth shims for Dana Spicer 60 and 70U

from

$8.99

Toyota Landcruiser ring gear nut for ring gear bolt.

Product Features:

Ring gear nut
Fits Toyota Landcruiser

from

$31.99

Product Features:

Pinion gear thrust washer
Fits Toyota Landcrusier

from

$689.99

The Yukon carrier bearing Puller works with an impact gun to quickly and safely remove carrier bearings without damaging them. This unit comes with a handy bench top stand and works with up to most standard one ton applications. This unit is works with differentials up to one-ton applcations. It is not compatible with Dana 70HD, Dana 80, 10.25″ & 10.5″ Ford, or GM & Chrysler 11.5″ differentials.

Product Features:

Carrier bearing puller
Works with an impact gun to safely and easliy remove carrrier bearings
Not compatible with Dana 70HD, Dana 80, Ford 10.25″ and 10.5″ or Gm and Chrysler 11.5″ applications

from

$603.99

The Spartan Locker, by USA Standard Gear, provides reliable traction at a low cost. Give your vehicle great traction and save some cash. Choose a Spartan Locker for better traction. The Spartan locker by USA standard gear is a mechanical locker that replaces the spiders in a standard case. The Spartan locker’s design does not use the thrust washers and has a revolutionary spring and pin design that makes installation a snap! The couplers and drivers are made from 9310 steel, for added strength. Each Spartan locker carries a one year warranty against defect.

Product Features:

Fits Toyota 9.5″ Landcruiser with 30 spline axles
Made from 9310 steel for added strength
Replaces the spiders in a standard carrier case

from

$12.79

Product Features:

High-performance seal conditioners maintain and preserve the elasticity of seals to help prevent leaks
Long-life friction modifiers and premium base oils help improve smooth shifting, eliminate slippage and shudder, prevent clutch wear and improve drivability longer than conventional fluids
Enhanced cleaning additives help reduce varnish formation and keep the transmission running properly longer
Engineered with a unique blend of viscosity modifiers and base oils to provide better oil flow at low temperatures and greater film protection at higher temperatures

from

$14.49

Formulated to meet the specific requirements of Toyota, Lexus, and Scion vehicles equipped with conventional (non-CVT) transmissions that require the use of Toyota ATF WS. Recommended for service-fill in all Toyota, Lexus, and Scion automatic transmissions where ATF WS is specified. Fuel economy demands and more sophisticated electronic controls have made automatic transmissions not only more complex, but also unique to each vehicle manufacturer. Long gone are the days of having just a couple choices of automatic transmission fluid type. IDEMITSU is the factory fill Automatic Transmission Fluid (ATF) supplier to most Asian imports. IDEMITSU application-specific ATF products match the exact friction materials and performance requirements of each different vehicle model for which they are made.

Product Features:

Precisely engineered frictional characteristics guarantee smooth shifting and outstanding anti-shudder performance
Optimized viscosity and advanced friction reducing additive technology provide exceptional fuel economy performance
Excellent resistance to oxidation and thermal breakdown provide long fluid life and extended protection
Exceptional wear protection of gears and bearings
Provides superior deposit control and protects metal surfaces from rust and corrosion
Excellent seal compatibility and conditioning reduces risk of fluid leaks due to seal shrinkage, hardening and cracking

from

$22.99

Product Features:

Ring gear bolt and nut kit
Fits Toyota Landcruiser
Includes one bolt and one nut

from

$1099.99

The Yukon Grizzly Locker is the ultimate in locking differentials for street, off-road, & drag racing. Grizzly Lockers provide 100% power to both tires, while still allowing for disengagement while negotiating turns. The Yukon Grizzly locker is a mechanical locking differential. It features a forged case and 8620 internals for maximum strength. It’s patented design reduces common locker failures. All units assembled in the USA! All Grizzly Lockers are backed by the best warranty in the business! Yukon covers the replacement unit and covers any collaterally damaged parts.

Product Features:

Fits Toyota 9.5″ Landcruiser with 30 spline axles
Patented internal design reduces common locker failures
8620 internals for added strength
Assembled in the USA

1974 Toyota Land Cruiser Differentials

More 1974 Toyota Land Cruiser Differentials

Essential 1974 Toyota Land Cruiser Differentials

Yukon Gear – Bearing Install Kit For ’91 And Newer Toyota Landcruiser Differential (Part No.11091)

Yukon Gear – Ring Gear Bolt Kit For Toyota Landcruiser (Part No.12075)

Yukon Gear – Minor Install Kit For Toyota Landcruiser Differential (Part No.12074)

Motive Gear – Differential Ring and Pinion (Part No.T488L)

Yukon Gear – Bearing Race Driver (Part No.56005)

Yukon Gear – Outer Oil Slinger (Part No.33025)

USA Standard Gear – Spartan Spring & Pin Kit, Fits Smaller Designs (Part No.17011)

Driveworks – Taper Bearing Cup (Part No.S-JLM-104910)

Yukon Gear – Landcruiser Standard Open Cross Pin Shaft (Part No.33419)

Corteco – Axle Seal (Part No.K4021473844CFW)

Yukon Gear – Pinion Nut (Part No.33156)

Yukon Gear – Small Hole Yoke For ’82 And Older Toyota 8" And Landcruiser With 27 Spline (Part No.41102)

Driveworks – Oil Seal (Part No.S-1177)

Yukon Gear – Pinion Install Kit For Toyota Landcruiser Differential (Part No.13091)

Motive Gear – Differential Crush Sleeve (Part No.3954480)

Yukon Gear – Replacement Pinion Depth Shims For Dana 60, 61 & D70-U (Part No.55012)

Yukon Gear – Toyota Landcruiser Ring Gear Nut For Ring Gear Bolt (Part No.33062)

Yukon Gear – Landcruiser Standard Open Pinion Gear Thrust Washer (Part No.33394)

Yukon Gear – The Carrier Bearing Puller (Part No.56034)

USA Standard Gear – Spartan Locker For Toyota 95" Landcruiser With 30 Spline Axles, Includes Heavy-Duty Cross Pin Shaft (Part No.17033)

Valvoline – MaxLife Multi-Vehicle (ATF) Full Synthetic Automatic Transmission Fluid, 1 Quart (Part No.VV324)

Idemitsu – Type TLS-LV Automatic Transmission Fluid – 1 qt (Part No.30040096-75000C)

Yukon Gear – Toyota Landcruiser Ring Gear Bolt & Nut Kit (Part No.33200)

Yukon Gear – Grizzly Locker For Toyota Landcruiser, 30 Spline (Part No.28032)

Popular 1974 Toyota Land Cruiser Differentials Categories

1974 Toyota Land Cruiser Differentials

Differentials Brands To Make Your 1974 Toyota Land Cruiser Last

Popular Valvoline Differentials

FAQs for 1974 Toyota Land Cruiser Differentials

What are the most purchased Differentials for the 1974 Toyota Land Cruiser?

More Popular Parts for All Makes