Constant Velocity Axle Assembly
Hover over the image to zoom in
Constant Velocity Axle Assembly Constant Velocity Axle Assembly
Share this:
This product is on sale and is not eligible for any further promotional discounts, coupons or special offers.

USA Industries Constant Velocity Axle Assembly

Part No. AX-3260 Warranty Details  
was $60.99
you save $21.00
Core Charge: $5.00
Quantity  Add to Cart

See if this part fits a specific vehicle.

Check Vehicle Fit

Precision-machined components reduce noise and provide maximum torque to the wheels.
Back To Top
ABS Brakes:No
Axle Material:Steel
New Or Remanufactured:Remanufactured
Spline Quantity:Yes
Wheel Drive Type:Front

Do you have questions about this product?


Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.

1 Question | 1 Answer
Displaying question 1
  • Q:

    1993Mazda mpv, replacing left front axle, How to & what tools needed
    Asked on 5/6/2013 by Alvin A Alvin from Yoncalla Oregon

    1 answer



      Instructions to replace CV axle: 1. Lift up the car using the jack, then put it down on jack stands. Unbolt the wheels from the car with the tire iron. Place the drain pan underneath the transmission and drain the transmission fluid from the system by unbolting the drain bolt using the 3/8-inch ratchet and socket. Unbolt the speed sensor from the wheel using the 3/8-inch ratchet and socket, then move the sensor out of the way. 2. Locate the dimple in the hub lock nut in the middle of the rotor. Pound out the dimple in the lock nut using the chisel and the hammer. Have your assistant hold down the brake pedal. Unbolt the lock nut from the axle using an open-end wrench. 3. Remove the cotter pin from the end of the tie rod using the needle-nose pliers and cotter pin puller. Unbolt the tie rod end from the steering knuckle and pull it out of the knuckle. Unbolt the sway bar end link from the lower control arm using an open-end wrench and the 3/8-inch ratchet and socket. 4. Unbolt the lower control arm from the steering knuckle using the 3/8-inch ratchet and socket. Lift the steering knuckle off the lower ball joint. Hammer the backside of the steering knuckle off the CV axle, then pry the half shaft off the transmission using the pry bar. Remove the CV axle from the vehicle. Things you would need: Jack, Jack stands, Tire iron, Drain pan, Chisel, Hammer, Assistant, Needle-nose pliers, Cotter pin puller, Open-end wrench set, 3/8-inch ratchet and socket set, 24-inch pry bar. For any further assistance, please feel free to call us at: 1-877-238-2623 or visit the nearest Advance Auto Parts store and one of our Parts Pros will gladly assist you with any questions or concerns you may have.

      Answered on 5/7/2013 by Steve from AAP
Displaying question 1

Do you have a question about this product? 

Check out the specials in our monthly flyer.
Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.