Lift Support
Hover over the image to zoom in
Share this:

Strong Arm Lift Support

Part No. D4193 Warranty Details  
Quantity  Add to Cart

See if this part fits a specific vehicle.

Check Vehicle Fit

Body Connection Type:Ball Socket (Nylon)
Body Diameter:15
Collapsed Length:10.45
Compressed Length:10.45 in
Extended Length:17.05
Gas Charged:Yes
Hardware Kit Included:No
Heavy Duty:N
Installation Instructions Included:Yes
Internal Spring:No
Mounting Bracket Included:No
Shaft Connection Type:Ball Socket (Nylon)
Shaft Diameter:6 in
Stroke:6.6 in
Quantity Per Vehicle:2

Do you have questions about this product?


Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.

2 Questions | 2 Answers
Displaying questions 1-2
  • Q:

    How do I put this on? How do I install this and do I need special tools?
    Asked on 7/20/2015 by Ted from West Palm Beach, FL

    1 answer



      Hi Ted, glad to help you! Here is the instructions to install a lift support. Open the lift gate and have your helper hold it open. Inspect the ends of the struts to determine what type of fasteners hold them at the top and bottom. You may need a socket and ratchet, Torx or Allen drivers, a flat-tip screwdriver or a combination of these tools to remove the struts. Remove the struts one side at a time by removing the top and bottom fasteners. If the type of fastener isn't apparent, look for a slot at the end of the strut that you can stick the tip of a screwdriver in and pry off a clip. Inspect the mounting posts. Though not normally replaced with the struts, you should inspect the mounting posts for abnormal wear and replace them as needed. Have the helper hold the lift gate at its full-open position and align each new strut in the same orientation as the original. Use the fasteners to affix the strut to the vehicle. If the old strut had clips you had to remove to get it off, you might need to align the new strut and then give it a whack with your hand to pop it onto its mounting posts. For fasteners you had to unscrew, tighten them to the torque specification for your vehicle. Install both struts and then test the lift gate to make sure it closes and latches, and that it opens and stays up when you let go of it.

      Answered on 7/20/2015 by Steve from AAP
  • Q:

    is this one of the two cylinders that support the upper glass part of the rear hatche?
    Asked on 10/31/2011 by cairored from tennessee

    1 answer



      In order to check the exact fit application, please provide the year, make, model and engine size of the vehicle.

      Answered on 10/31/2011 by Vincent from AAP
Displaying questions 1-2

Do you have a question about this product? 

Check out the specials in our monthly flyer.
Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.