U Joint
Hover over the image to zoom in
Share this:

MOOG Driveline Products U Joint

Part No. 354 Warranty Details  
$17.59
Quantity  Add to Cart

See if this part fits a specific vehicle.

Check Vehicle Fit

Greasable:Yes

REVIEW SNAPSHOT®

by PowerReviews
MOOG Driveline ProductsU Joint
 
4.1

(based on 27 reviews)

Ratings Distribution

  • 5 Stars

     

    (17)

  • 4 Stars

     

    (5)

  • 3 Stars

     

    (0)

  • 2 Stars

     

    (2)

  • 1 Stars

     

    (3)

94%

of respondents would recommend this to a friend.

Pros

  • Durable (8)
  • Easy to use (5)
  • Easy to install (4)

Cons

No Cons

Best Uses

  • Trucks (7)
  • Replacement (4)
  • Everyday driving (3)
    • Reviewer Profile:
    • Mechanic (6), Casual driver (4), Truck enthusiast (4), Auto enthusiast (3)
    • Was this a gift?:
    • No (15)

Most Liked Positive Review

 

Great product - Iwould buy again

Helpful Hint: When installing U-joints, you must index the slip yoke to its original position with the drive shaft. i.e. make sure and mark the position of the slip yoke with the...Read complete review

Helpful Hint: When installing U-joints, you must index the slip yoke to its original position with the drive shaft. i.e. make sure and mark the position of the slip yoke with the shaft. The drive shaft is balanced from the factory after the u-joints are installed. If you install the new u-joints and do not put the slip yoke in the position it came off in, you will have an out of balance drive shaft which will cause a nasty vibration and noise the faster you drive. If you have a slip yoke on both ends of the drive shaft as some cars do, you will have to remove the drive shaft and have it re-balanced. If you only have 1 slip yoke and experience an imbalance, just remove the driveshaft and reverse the slip yoke 180 degrees which wil be back in tis original position and maintain the feactory balancing job.

VS

Most Liked Negative Review

 

Wrong Part for Liberty

I picked this u-joint up for a jeep liberty. As always, good service. I got the U-joint home, installed it, no prob. I took it for a spin, there was a...Read complete review

I picked this u-joint up for a jeep liberty. As always, good service. I got the U-joint home, installed it, no prob. I took it for a spin, there was a loud vibration from the rear. Crawled under to discover the shaft was loose, I could move it in the caps close to a .120" on the yoke. So i took it back apart, went back, got another one figuring that it was a factory mistake. Well the second one was the same way. Long to short, Advance has there books incorrect. Make sure to measure twice, cut once.... Good luck!!

Reviewed by 27 customers

Displaying reviews 1-10

Back to top

Previous | Next »

 
1.0

These are junk

By 

from undisclosed

Verified Buyer

Comments about MOOG Driveline Products U Joint:

These are junk. Unless you are EXTREMELY careful, the bearing fall out of position when you remove the bearing caps to install the joint in the driveshaft. Also, they will need to be greased every 10,000 miles or so. Get the maintenance free ones instead

 
5.0

Great product

By 

from undisclosed

Verified Buyer

Comments about MOOG Driveline Products U Joint:

Great product

 
5.0

been a mnth so far so good

By 

from undisclosed

Verified Buyer

Comments about MOOG Driveline Products U Joint:

so far so good

 
5.0

Perfect fit

By 

from undisclosed

Verified Buyer

Comments about MOOG Driveline Products U Joint:

perfect fit, running good on the restoration.

 
5.0

Quality Part

By 

from undisclosed

Verified Buyer

Comments about MOOG Driveline Products U Joint:

Great Price Top Quality

 
5.0

I would buy this again for other cars I repair

By 

from Florida

Verified Buyer

Comments about MOOG Driveline Products U Joint:

Easy removal and install. Sprayed old sealed u-joints with p b blaster let set 1 day and using the loan a tool ball joint kit it very easy

  • Was this a gift?:
  • No

(1 of 1 customers found this review helpful)

 
1.0

Wrong item sold.

By 

from Ohio

Verified Buyer

Comments about MOOG Driveline Products U Joint:

Website suggested wrong parts

  • Was this a gift?:
  • No

(1 of 2 customers found this review helpful)

 
1.0

Wrong Part for Liberty

By 

from Western PA

Pros

  • Great U-joint

Cons

  • Just The Wrong Part

Best Uses

    Comments about MOOG Driveline Products U Joint:

    I picked this u-joint up for a jeep liberty. As always, good service. I got the U-joint home, installed it, no prob. I took it for a spin, there was a loud vibration from the rear. Crawled under to discover the shaft was loose, I could move it in the caps close to a .120" on the yoke. So i took it back apart, went back, got another one figuring that it was a factory mistake. Well the second one was the same way. Long to short, Advance has there books incorrect. Make sure to measure twice, cut once.... Good luck!!

    • Was this a gift?:
    • No
     
    5.0

    Nice part, great price

    By 

    from York. Pa.

    Verified Buyer

    Comments about MOOG Driveline Products U Joint:

    Every day driver, able to grease for long life.

    • Was this a gift?:
    • No
     
    5.0

    Good Fit

    By 

    from Kalkaska Mi

    See all my reviews

    Verified Buyer
    3 or more reviews submitted

    Comments about MOOG Driveline Products U Joint:

    Parts went together good, no issues, Good Qualityl

    • Was this a gift?:
    • No

    Displaying reviews 1-10

    Back to top

    Previous | Next »

    Do you have questions about this product?

     

    Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.

    14 Questions | 15 Answers
    Displaying questions 1-10Previous | Next »
    • Q:

      Vehicle: 2007 F-150 FX4 4X4
      Will these replace the U-Joints in the front Axles that go from the front differential to the wheels hub on both sides and how many would I need total for both axels? Thank You
      Asked on 4/2/2017 by J-Rod from Central PA

      1 answer

      • CUSTOMER CARE

        A:

        Glad to assist, J-Rod! This MOOG U-Joint - Part No. 354 fits the front driveshaft. You'll need two of this U-Joint - Part No. 354 for the front axle and transfer case. The rear drive shaft of the 2007 Ford F-150 requires the U-Joint - Part No. 331.

        Answered on 4/5/2017 by Solomon from AAP
    • Q:

      86 ford bronco 351 4x4...began working on replacing u joint on front drive shaft. I know 434 goes to front axle but comparing 354 at transfer case 2 of the for bearing are bigger on the original (like to axle 434) but on new one (354 all bearing caps are same size, smaller)
      Asked on 3/8/2017 by Danny from Kentucky

      1 answer

      • CUSTOMER CARE

        A:

        Hi Danny, glad to assist you! This MOOG Driveline Products U Joint (Part No. 354) is an exact fit for your 1986 Ford Bronco with 351 engine. However, I am not sure about the size difference that you are referring to. I would suggest that you contact the Moog directly at 888-406-2330 and they would be in a better position to help you.

        Answered on 4/12/2017 by Steve from AAP
    • Q:

      Do these come pre greased?
      Asked on 2/22/2017 by j from 12866

      1 answer

      • CUSTOMER CARE

        A:

        Yes, J! This MOOG Driveline Products U Joint - Part No. 354 comes pre-greased. However, I'd recommend you to grease it before installation.

        Answered on 2/23/2017 by Solomon from AAP
    • Q:

      I bought 4 of these and they are smaller that the ones already on my 1975 Corvette stingray, but yet your site says they are a exact fit. I am putting them on the rear half shafts. Did I get the wrong one's?
      Asked on 10/15/2016 by william from United States

      1 answer

      • CUSTOMER CARE

        A:

        Hi William, happy to help you! I have checked with the manufacturer's fitment chart, this MOOG Driveline Products U Joint (Part No. 354) is an exact fit for your 1975 Chevrolet Corvette stingray.

        Answered on 10/17/2016 by Steve from AAP
    • Q:

      I have a 02 Jeep Liberty Liminted 3.7 what is the u-joint I would need.
      Asked on 2/22/2016 by Johanna from Des Moines, IA

      1 answer

    • Q:

      2001 dodge dakota Quad slt 4Door 4x4 4.7 engine My Rear drive shaft has two u-joints will these fit my truck ????
      Asked on 4/4/2015 by Bill from 3009

      1 answer

      • CUSTOMER CARE

        A:

        Happy to help you with your question Bill! Looking at the details of these U-Joints it tells me it fits 01 dodge Dakota 4.7 in these positions; Rear Drive shaft at Rear Axle 4WD with 1-1/16" O.D. Bearings, Rear Drive shaft at Transmission 4WD with 1-1/16" O.D. Bearings, Rear Drive shaft at Transmission 4WD with 1-1/16" O.D. Bearings. The biggest piece of information you will need to find out is about your OD (over drive) bearings, that will be the deciding factor if these will fit your truck.

        Answered on 4/6/2015 by Panda from AAP
    • Q:

      I have a 03 f150 4.2 v6 manual RWD. does it matter if they all show for AT transmission, none for manual 4x2? I need the one that connects to the yoke on the rear axle.
      Asked on 10/13/2014 by matt

      1 answer

      • CUSTOMER CARE

        A:

        No Matt, you could not be able to use these U joints on your 2003 Ford F150 4.2L V6 Manual RWD as all of these U joints is for automatic transmissions.

        Answered on 10/14/2014 by Steve from AAP
    • Q:

      What is the measurement of axis a and axis b in inches?
      Asked on 9/7/2014 by Usmcjoe from United States

      1 answer

      • CUSTOMER CARE

        A:

        Hi Usmcjoe, glad to assist you! The length of the axis A and B is 3.62 inches. The diameter of the axis A and B is 1.063 inches.

        Answered on 9/9/2014 by Vincent from AAP
    • Q:

      Are the joints on the rear the same for the front on a 4x4
      Asked on 9/3/2014 by Jon

      1 answer

      • CUSTOMER CARE

        A:

        Hi Jon, to further assist with the U joint, please provide us the year, make, model and engine size of your vehicle.

        Answered on 9/4/2014 by Steve from AAP
    • Q:

      where is the u joint located the vehicle
      Asked on 3/5/2014 by Tom from lowell

      1 answer

      • CUSTOMER CARE

        A:

        Hi Tom, glad to assist you! This is a drive shaft U-joint. At the beginning and end of the drive shaft sits a universal joint.

        Answered on 3/5/2014 by Vincent from AAP
    Displaying questions 1-10Previous | Next »

    Do you have a question about this product? 

    Check out the specials in our monthly flyer.
     
     
    Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.