TECHnovation Clutch Master Cylinder
Hover over the image to zoom in
Share this:

CARQUEST Clutch TECHnovation Clutch Master Cylinder

Part No. 350101 Warranty Details  
Quantity  Add to Cart

See if this part fits a specific vehicle.

Check Vehicle Fit

Designed and engineered for faster installation than original equipment using existing lines and no special tools. OEM plastic cylinders can be prone to cracking/breakage. TECHnovation Clutch Hydraulics aluminum castings are made from solid blocks that are bored and honed for accurate tolerances and maximum durability.
Back To Top
Bleeder Included:No
Bore Size:0.63 in
Port Size:10 mm


by PowerReviews
CARQUEST ClutchTECHnovation Clutch Master Cylinder

(based on 1 review)

Ratings Distribution

  • 5 Stars



  • 4 Stars



  • 3 Stars



  • 2 Stars



  • 1 Stars



Reviewed by 1 customer

Displaying review 1

Back to top


Toyota 4Runner Clutch Master Cylinder


from Sharpsburg, GA

Verified Buyer


  • Easy To Install
  • Identical to original


  • Poor Instruction Sheet

Best Uses

  • Everyday Driving

Comments about CARQUEST Clutch TECHnovation Clutch Master Cylinder:

I found the instruction sheet confusing, and so just used my Haynes manual which was much clearer.

A list of required tools would have been nice.

I didn't ask at the store about returning the core for a partial refund, and it wasn't mentioned to me. Is there a core credit available for this part?

  • Car & Truck:
  • Casual Driver

Displaying review 1

Back to top

Do you have questions about this product?


Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.

1 Question | 1 Answer
Displaying question 1
  • Q:

    I replaced both my master and slave cylinders apprx 4months ago. The bracket (brass-looking fork that screws onto bolt that comes thru firewall) that attaches the master cylinder 'piston' to the clutch pedal has worn out already! It has a plastic bushing on the inside (that are wrapped by the metal exterior) that have bent apprx 20-30degrees over time and now I cannot depress the clutch pedal far enough to disengage the clutch. I have already tried adjust the lenght of the master bolt by screwing it in further/shorter to see if that will go.
    From the original install, it seemed like the bolt wasn't really long enough--I was only able to screw the bolt into the bracket apprx 0.25-.50" and then bring the locking-nut up all the way.
    Where/how can I buy just the bracket and not the whole master cylider kit?
    Asked on 8/4/2010 by NJ from West San Antonio, TX

    1 answer



      it would be easier to answer your question if i knew the exact year, make, model, and engine size of your car. Its just too general a question with too maqny possible answers/

      Answered on 8/16/2010 by luz from aap
Displaying question 1

Do you have a question about this product? 

Check out the specials in our monthly flyer.
Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.