item(s) totaling $
See if this part fits a specific vehicle.
|This product doesnt fit any of your saved vehicles||Check Fit for another vehicle|
|Bore Size:||0.625 in|
Do you have questions about this product?
Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.
Q:On a 2009 chevy HHR LS how do you install and bleed the Clutch Master Cylinder
A:Hello Bob, Good question. For complete step by step instructions for the installation and bleeding of your brake system, I would recommend PN: 38070, here is the link to the Haynes repair manual. http://shop.advanceautoparts.com/p/haynes-gm-chevrolet-hhr-06-11-38070/10595367-P?searchTerm=38070.
Q:how do you bleed this once put in and how do you get to it
A:Hi Bob, glad to assist you! Instructions to bleed: Refer to the vehicle owner's manual to locate the clutch slave cylinder, which will have a screw (usually 8 mm) that releases pressure from the system. Known as the bleeder screw or bleeder valve, it is key to bleeding the system and helps maintain the hydraulic pressure with everyday use. Have your project partner sit in the car and push the clutch pedal all the way down. Loosen the bleeder screw with an end wrench or socket, and use a thick rag or container such as a coffee can to catch excess fluid. A bunch of air will probably come out first, mixed with a tiny bit of fluid. Make sure the master cylinder has fluid in it at all times--if air enters the lines, you will have to bleed the system again. Re-tighten the bleeder screw, then tell your project partner to slowly let up on the clutch pedal until it is free-standing. Have your project partner push the clutch to the floor. Loosen the bleeder screw. Repeat these steps until only fluid--not air--comes out of the slave cylinder bleeder valve. Tighten the bleeder screw a final time and fill the master cylinder with hydraulic fluid.