Transmission Filter Kit
Hover over the image to zoom in
Share this:

Beck/Arnley Transmission Filter Kit

Part No. 044-0310 Warranty Details  
Quantity  Add to Cart

Fit of this part varies by vehicle & equipment specs Type of Fit

A direct OE replacement with enhancements. A premium engineered rubber pan gasket is included with smaller bolt holes to aid installation where applicable. All components required for filter installation are included.
Back To Top
Gasket Material:Rubber


by PowerReviews
Beck/ArnleyTransmission Filter Kit

(based on 1 review)

Ratings Distribution

  • 5 Stars



  • 4 Stars



  • 3 Stars



  • 2 Stars



  • 1 Stars



Reviewed by 1 customer

Displaying review 1

Back to top

(0 of 1 customers found this review helpful)


Good product


from NC

About Me Auto Enthusiast

See all my reviews

Ask me a question

Verified Buyer
3 or more reviews submitted


  • Easy To Use


    Best Uses

    • Small Cars

    Comments about Beck/Arnley Transmission Filter Kit:

    Fast delivery friendly service

    • Was this a gift?:
    • No

    Displaying review 1

    Back to top

    Do you have questions about this product?


    Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.

    2 Questions | 2 Answers
    Displaying questions 1-2
    • Q:

      I have a 2005 2.5 VW Jetta. Once I remove the pan and replace the filter, how do I refill the pan with the transmission fluid? And how much fluid do I need to add.
      Asked on 1/30/2012 by Ivan Eisenhower from Columbia, SC

      1 answer



        After installing the new filter take the pan and apply a layer of wheel bearing grease on the top of the pan gasket. The grease will seal the gasket and yet allow it to come off easily at the next filter change. Tighten every other pan bolt until they are properly torqued, usually 15 to 20 inch pounds. If they are over tightened the gasket will squash out and leak. When It's tight, clean the area and lower the car. Put in two quarts of transmission fluid. Start the engine and let it reach normal operating temperature. Check the fluid level and add ATF until it is just below the FULL mark. With your foot on the brake shift it from reverse to drive 3 or 4 times. Recheck the fluid level and top off as needed. Drive the car for 3 or 4 miles and recheck the ATF level again and adjust as necessary. Finally check for leaks and the job is done.

        Answered on 1/31/2012 by John the Car-Doc from AAP
    • Q:

      where do i check the transmission fluid at? i cant"t find the dipstick? seriously please help my engine revs up then changes gears. it is a trip tronic.
      Asked on 7/4/2010 by Anonymous from greenevile, tn

      1 answer



        For further assistance, please provide the year, make, model and engine size of your vehicle.

        Answered on 7/6/2010 by Mike from AAP
    Displaying questions 1-2

    Do you have a question about this product? 

    Check out the specials in our monthly flyer.
    Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.