Steering Rack Boot Kit
Hover over the image to zoom in
Share this:

Beck/Arnley Steering Rack Boot Kit

Part No. 103-2732 Warranty Details  
Quantity  Add to Cart

See if this part fits a specific vehicle.

Check Vehicle Fit

One-piece neoprene boot. Not a split boot. This complete kit includes everything needed for easy installation. Prevents dirt, moisture and debris from entering the steering rack to provide excellent protection and a long service life.
Back To Top
Hardware Included:Yes
Mounting Hardware Included:Yes
O.E.M. Replacement:Yes
Tools Required:Yes

Do you have questions about this product?


Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.

2 Questions | 3 Answers
Displaying questions 1-2
  • Q:

    Does this boot kit require any special tools for installation?
    Asked on 10/22/2012 by stan

    1 answer



      With reference to this Beck/Arnley Steering Rack Boot Kit -part# 103-2732 for installing, don't take the suspension out to replace a steering rack boot. Support the front of the car so that you can work under it SAFELY, and so that the front wheels are hanging free. Have paper and pencil available. Look at the tie rod end, near the wheel. Mark the exact bottom of the tie rod. At that point, carefully count the number of threads showing outside the locking nut, and write it down. Loosen the clamp on the outer (Small) end of the rubber boot, and push it in enough to expose the retaining ridge on the tie rod. Accurately and carefully measure from the face of the locking nut to the ridge on the tie rod that locates the end of the rubber boot. Write this measurement down - it must be very precise. Loosen the lock nut at the tie rod end. Unscrew the tie rod from the tie rod end, and remove the lock nut. Remove the old rubber boot. Clean the rack and rack housing very carefully. More than a tiny bit of transmission fluid in the boot means that you need a new rack, or will very soon. Install the new rubber boot, but don't tighten any clamps. Install the lock nut. Screw the tie rod into the tie rod end. Using the measurements obtained, firmly tighten the lock nut at EXACTLY the same location as it was originally, with the mark on the bottom in the same place that it was originally. Remeasure to be sure that the measurements are the same. Install the clamps on the rubber boot. For any further assistance, please visit your nearest Advance Auto store or call us directly at 1-877-ADVANCE (238-2623) and one of our representatives there would be more than happy to assist you.

      Answered on 10/23/2012 by Vincent from AAP
  • Q:

    Does this product come with this two clamps or are they zipties??
    Asked on 2/3/2012 by solo from blackstone

    2 answers



      Yes, this Beck/Arnley Steering Rack Boot Kit with part# 103-2732 includes boot clamps.This is a high quality, direct fit Original Equipment replacement steering rack boot.

      Answered on 2/4/2012 by Vincent from AAP
    • A:

      Zip ties

      Answered on 2/6/2014 by not a mechanic from 32726
Displaying questions 1-2

Do you have a question about this product? 

Check out the specials in our monthly flyer.
Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.