CV Joint Boot Kit
Hover over the image to zoom in
Share this:

Beck/Arnley CV Joint Boot Kit

Part No. 103-2659 Warranty Details  
Quantity  Add to Cart

See if this part fits a specific vehicle.

Check Vehicle Fit

One-piece neoprene boot. Not a split boot. Installation requires 1 end of the shaft to be detached. Promotes maximum service life and protection.
Back To Top
Solid Or Split Boot:Solid


by PowerReviews
Beck/ArnleyCV Joint Boot Kit

(based on 1 review)

Ratings Distribution

  • 5 Stars



  • 4 Stars



  • 3 Stars



  • 2 Stars



  • 1 Stars



Reviewed by 1 customer

Displaying review 1

Back to top

(1 of 1 customers found this review helpful)


B/A OEM Replacement Axle Boot


from Jacksonville

See all my reviews

Ask me a question

3 or more reviews submitted


  • Durable
  • Fit
  • OEM replacement
  • Quality


  • Need specialty tool

Best Uses

  • Replace Cv Axle Boots

Comments about Beck/Arnley CV Joint Boot Kit:

The Beck-Arnley brand is the OEM second-source for all submodels of Acura Integras. This CV boot is the SAME one (with a different distributor's name) as the one you would pay twice as much for at the dealership.

It installed cleanly once the original was cut off and all of the 17-year old grease was removed & replaced (moly axle grease is included in package). To properly install the OEM-type CV boot bands, you NEED the KD3191 boot band clamp tool. It is available from a local Advance Auto store's commercial desk or online. The band is tricky so hopefully this will help you...

1.) Double wrap the band with the leg pointing towards the FRONT of the car. VERIFY before continuing. (When you bend it back it will then be facing the back of the car so it doesn't snag things--notice how your current boot bands look before removing the old boot).
2.) Once the band is snug-tight, use a sharpie to mark a line 1/2" (10-14mm) back from the loop.
3.) Use the GearWrench / KD3191 tool to cinch down the band until your line reaches the loop.
4.) Fold the band over the loop while very slightly relaxing the tension in the tightening lever.
5.) Use the cutting lever to shear off the excess metal band.
6.) Carefully fold the band over the loop and use a hammer to hammer down the holding tabs.
7.) Install axle back into vehicle taking care not to damage the new boot.

If you drive an Integra, please invest in the right tools and buy quality parts, not cheap parts.

  • Was this a gift?:
  • No

Displaying review 1

Back to top

Check out the specials in our monthly flyer.
Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.