Remanufactured Fuel Injector
Hover over the image to zoom in
Share this:

AUS Injection Remanufactured Fuel Injector

Part No. MP-10174 Warranty Details  
Core Charge: $10.00
Quantity  Add to Cart

See if this part fits a specific vehicle.

Check Vehicle Fit

Quality remanufactured O.E. replacement fuel injectors.

Product Features:
  • All injectors are 100% tested and are guaranteed to be within O.E. specifications
  • 12 month 12,000 mile warranty
  • Pre-lubricated and ready to install
  • Remanufactured in the USA
Back To Top
Clips or Screws Included:No
Fuel Pressure Rating:43.5 PSI
Gasket Or Seal Included:Yes
Line Repair Kit:No
Mounting Hardware Included:No
New Or Remanufactured:Remanufactured
Terminal Quantity:2

Do you have questions about this product?


Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.

1 Question | 1 Answer
Displaying question 1
  • Q:

    installation instruction for for fuel injecto r part #mp 10174 for a 2004 nissan sentra 1.8 s 4 cyl
    Asked on 7/25/2012 by jb 123

    1 answer



      For fuel injector replacement on your Nissan Sentra, you will require a socket wrench set, a torque wrench and a fuel injector kit to avoid damaging other parts while replacing. First of all, remove the negative cable from the battery. Before removing the fuel injector, it is also required to relieve the pressure from the fuel supply system. This can be done by removing the fuel pump fuse or relay, while the engine is in running condition. The engine will die out soon, consuming all the pressure inside the system. Remove also the vacuum hose from the fuel pressure regulator. The fuel injector is connected using fuel rail and fuel hoses attached to it. Using a socket wrench, remove the fuel hoses from the rail, and also disconnect the electrical connectors of the fuel injector. Now, remove the mounting bolts that keep the fuel rail in its place, so that the rail can be detached easily with injectors still on. After disconnecting the fuel rail from the intake manifold, force the injector tail slightly, so that they can be removed easily. Make sure that, you discard the O-rings that came out along with the injector. Replace these injectors with new one, which would have also been included with new O-rings. Lubricate these rings with small portion of motor oil and re-insert the injector on the fuel rail. Connect the fuel rail with the intake manifold, and tighten the mounting bolts using torque wrench. Connect the fuel hoses and the electrical connectors too. When you’re done with these steps, connect the battery cable back to the negative terminal and start the engine. As the vehicle starts, it suggests that the pressure inside the system has been regained. For any further assistance, please visit your nearest Advance Auto store or call us directly at 1-877-ADVANCE (238-2623) and one of our representative there would be more than happy to assist you.

      Answered on 7/25/2012 by Vincent from AAP
Displaying question 1

Do you have a question about this product? 

Check out the specials in our monthly flyer.
Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.