from

$42.99

Product Features:

TOYOTA 8″ V6&4CLY TURBO

from

$107.99

When the thin-gauge steel corrodes on Sequoia, Tacoma, Tundra truck rear differential covers, the typical solution has been to replace the entire axle. This Dorman OE FIX weld-on solution allows direct replacement of only the failed cover.

Product Features:

Rear Differential Cover
Rear Differential Cover
When the thin-gauge steel corrodes on Sequoia, Tacoma, Tundra truck rear differential covers, the typical solution has been to replace the entire axle. This Dorman OE FIX weld-on solution allows direct replacement of only the failed cover.
Direct replacement – this weld-on differential cover directly replaces a corroded original cover on certain Sequoia, Tacoma and Tundra trucks
Cost-effective repair – rather than buy a new axle, cut off the old cover and weld on this new one

from

$689.99

The Yukon carrier bearing Puller works with an impact gun to quickly and safely remove carrier bearings without damaging them. This unit comes with a handy bench top stand and works with up to most standard one ton applications. This unit is works with differentials up to one-ton applcations. It is not compatible with Dana 70HD, Dana 80, 10.25″ & 10.5″ Ford, or GM & Chrysler 11.5″ differentials.

Product Features:

Carrier bearing puller
Works with an impact gun to safely and easliy remove carrrier bearings
Not compatible with Dana 70HD, Dana 80, Ford 10.25″ and 10.5″ or Gm and Chrysler 11.5″ applications

from

$461.99

Yukon standard open spider gear kit for Toyota T100 & Tacoma with 30 spline axles. Yukon uses higher quality materials and better techniques than OEM to ensure a longer lasting spider gear set. All components come with a one year warranty against manufacturing defects.

Product Features:

Spider gear kit
Fits Toytoa Tacoma and T100 open differential
Includes two side gears, two pinion gears, cross pin shaft, roll pin spider gear thrust washers.

from

$30.99

Product Features:

Pinion gear thrust washer
Fits Toyota Tacoma and T100

from

$434.99

DiffrlPartsKit

from

$246.99

Yukon yoke for ’04 and newer Toyota T100 and Tacoma (without locker) with 30 spline. All Yukon yokes come with a one year warranty against manufacturing defects.

Product Features:

Fits 2005 and up Toyota Tacoma and T100
30 spline
66mm x 66mm bolt pattern

from

$399.99

Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings & races can be reused. This kit uses high quality bearings and races along with a high quality pinion seal and small parts. Included in this kit are the pinion bearings and races, pilot bearing (if applicable), crush sleeve (if applicable), complete pinion shim kit, pinion nut, thread locker, and marking compound with brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your pinion gear.

Product Features:

Fits Toyota Tacoma and T100 without factory locking differential
Included are pinion bearings and races, pinion seal, crush sleeve, complete pinion shim kit, and marking compound with brush.

from

$364.99

USA Standard Master Overhaul kits let you finish your install with confidence. This kit uses Koyo bearings and races. Included are carrier bearings and races, pinion bearings and races, pinion seal, pinion shim kit, ring gear bolts, pinion nut, crush sleeve (if applicable), oil baffles and slingers (if applicable), threading locking compound, marking compound with brush and gasket. .

Product Features:

Fits reverse rotation Toyota 7.5″
Uses Koyo bearings and races
Included in this kit are carrier bearings and races, pinion bearings and races, pinion seal, axle seals, pinion shim kit, ring gear bolts, pinion nut, crush sleeve , oil baffles and slingers , thread locker, marking compound with brush, and silicone.

from

$8.99

Product Features:

Roll pin
Fits Toyota Tacoma and T100

from

$73.99

Product Features:

Cross pin shaft
Fits Toyota Tacoma and T100

from

$15.99

Toyota T100 & Tacoma pinion nut.

Product Features:

Pinion nut
Fits Toyota Tacoma and T100 without factory locking differential

from

$8.51

Axle Seal

from

$669.99

The Spartan Locker, by USA Standard Gear, provides reliable traction at a low cost. Give your vehicle great traction and save some cash. Choose a Spartan Locker for better traction. The Spartan locker by USA standard gear is a mechanical locker that replaces the spiders in a standard case. The Spartan locker’s design does not use the thrust washers and has a revolutionary spring and pin design that makes installation a snap! The couplers and drivers are made from 9310 steel, for added strength. Each Spartan locker carries a one year warranty against defect.

Product Features:

Fits Toyota 7.5″
Made from 9310 steel for added strength
Replaces the spiders in a standard carrier case

from

$13.49

Product Features:

KIT SHIM TOYO TRK 79-92 REAR/89-92 FRONT

from

$36.99

2007-CURRENT Toyota Tundra front crush sleeve. Approx 1.200″ long.

Product Features:

Crush sleeve
Fits 2007 and up Toyota Tundra front
1.200″ tall

from

$126.99

Bearing race driver front Toyota 7.5″, 8″, Landcruiser, and the Suzuki Samurai. No return. (TOY30306).

Product Features:

Bearing race driver
Fits 30306 race
All steel construction

from

$1044.99

Replacing a worn wheel bearing usually requires a time-consuming procedure with a shop press. This Dorman OE FIX loaded axle includes all critical components already assembled for a fast, simple, safe install.

Product Features:

Pre-Pressed Rear Axle
Pre-Pressed Rear Axle
Replacing a worn wheel bearing usually requires a time-consuming procedure with a shop press. This Dorman OE FIX loaded axle includes all critical components already assembled for a fast, simple, safe install.
Easier installation – this loaded axle assembly includes a pre-assembled new axle shaft, wheel bearing, hub and backing plate
Time saver – eliminates frustrating, unpredictable work required to replace bearings without damaging other components

from

$18.99

Product Features:

Side gear thrust washer
Fits Toyota Tacoma and T100

from

$269.99

USA Standard ring & pinion sets are the right choice to add confidence to your install. USA Standard Gear offers a full line of ring & pinion sets for a variety of common & hard to find applications. USA standard gear offers a standard one year warranty against defects on their ring & pinion sets.

Product Features: