Receive free standard shipping on orders over $25 to addresses in the continental United States.
Your 1989 Buick Electra might be the best vehicle you’ve ever owned. Or you may just be struggling to keep it highway-approved. No matter the situation, Advance Auto Parts has the Throttle Position Sensor product you desperately need.
We currently carry 4 Throttle Position Sensor products to choose from for your 1989 Buick Electra, and our inventory prices range from as little as $17.79 up to $99.07.
On top of low prices, Advance Auto Parts offers 2 different trusted brands of Throttle Position Sensor products for the 1989 Buick Electra. We only sell parts from trusted brands like BWD so that you can find quality parts you can count on.
Don’t take our word for it - check out customer ratings and reviews to buy with confidence. We have 7 reviews on our Throttle Position Sensor products for the 1989 Buick Electra from previous customers.
Have parts delivered straight to your home, or find the nearest Advance Auto Parts store to check out our Throttle Position Sensor stock in-person!
Search through our amazing selection of Throttle Position Sensor products for your 1989 Buick Electra to find exactly what you’re looking for. Compare prices and reviews to choose the best part for you.
It worked but it was the wrong item...
from $60.99View Product
I purchased the TPS because of trouble shooting the part on vehicle was bad? I needed a Mixture control solenoid too. I could not find part online. I asked the sales persons to help me to find it when I went to pick up parts I had ordered. They were limited in our search due to Advanced Auto Parts limiting there access to parts break down of Carburetor. The competitor parts store found the part. It was obsolete. I have not had weather nice enough to install new TPS. I did find the Mixture Control Solenoid on Rock Auto Parts site. They had a illustrated parts break down with part.
from $51.99View Product
By care bear
From Chicago, IL
This throttle position sensor worked fine on my 85 Impala with an e4me quadrajet. I couldn't get the sensor to read the (.48) volts that's needed at idle until I started the car. To test this tps you need a voltmeter, connect the red lead from voltmeter to the (A) terminal on the tps then the black lead to ground. The tps input should be receiving 5.00 volts at all times except when the car is off. Then test the tps output voltage, red lead from voltmeter goes to the (B) terminal on tps, black lead from voltmeter goes to either (C) terminal on tps or ground on body, it comes with a voltage sheet that specifies what voltage for your make and model. Adjustment screw is behind accelerator pump arm and is a 2.5 mm socket. All of these tests should be done with the car off but the key turned to run.
Bottom Line recommended
from $17.79View Product
from $99.07View Product