-
Your Store:
-
Hover over the image to zoom in
BWD Ignition Switch
See if this part fits a specific vehicle.
BWD switches are manufactured to meet or exceed OE performance.
Back To Top
| Connector Gender: | Female |
REVIEW SNAPSHOT®
by PowerReviewsBWDIgnition Starter Switch
(based on 5 reviews)
Ratings Distribution
100%
of respondents would recommend this to a friend.
Pros
Cons
Best Uses
- Was this a gift?:
- No (5)
REVIEWS
Reviewed by 5 customers
Sort by
Displaying reviews 1-5
Pros
- Easy To Use
Cons
Best Uses
Comments about BWD Ignition Starter Switch:
Customer came to me with a complaint of the ignition key would not turn. After a few minutes of diagnosis it was decided that the key cylinder was bad.
I removed the trim bezel, radio, heater control panel and center console to gain access to the shift interlock cable.
I removed the key cylinder, ignition switch and cable. due to the key cylinder not being able to turn I needed to replace both the cylinder and switch. After exchanging the neccesary parts the assembly was reinstalled in reverse of the removale procedure and a key relearn was performed per the included instructions.
- Was this a gift?:
- No
Pros
Cons
Best Uses
Comments about BWD Ignition Starter Switch:
Fit perfectly in 2001 Olds Alero. The old switch quit working, and I lost my blower motor, power windows, cruise, and rear defogger. After troubleshooting the problem I came across the ignition switch. Very easy to replace, took less than an hour. (I do have a mechanical background however) The only problem was the lock tab for the shifter cable would not lock into the new switch without having to shave a little plastic off the new switch so the lock tab would catch. Otherwise it fit perfectly. And the price was right especially with online discount coupons with in-store pick up. Beat the competition by $50-$60.
- Was this a gift?:
- No
Pros
- Identical to original
- Second part still working
Cons
- 1st switch falied
Best Uses
- Ignition switch
Comments about BWD Ignition Starter Switch:
The people at the store were very helpful and friendly. That was nice after the first switch failed in just a week or so. The 2nd is over 3 mos old now.
- Was this a gift?:
- No
Pros
- Exact Replacement
- No problems after install
Cons
- Hard to install cable
Best Uses
- 2001 Malibu
Comments about BWD Ignition Starter Switch:
There was a small burr on the edge of the hole for the park cable tab. Had to scrape it off to install, which was hard to do after connecting all the wire bundles.
- Was this a gift?:
- No
Pros
- Durable
- Easy To Use
Cons
Best Uses
Comments about BWD Ignition Starter Switch:
It was extremely hard to put in, but it did the trick.
- Car & Truck:
- Mechanic
- Was this a gift?:
- No
Displaying reviews 1-5
Do you have questions about this product?(earn points for answers!)
Ask a question, get answers from real customers and in-house experts. Or contact Customer Care by email or call 1-877-238-2623.
15 Questions | 16 Answers
Displaying questions 1-10Previous | Next »
Q:
my 2000 Pontiac grand am will shut down when driving if the ignition key is jiggled. also, all of the warning lights are showing on the dash when driving and the tail lights are out. Is the problem in the ignition switch?Asked on 5/19/2013 by cliff from belhaven n.c, 278101 answer
CUSTOMER CARE
A:
With reference to your inquiry on the BWD Ignition Switch - part# CS600, the ignition switch may be the possible cause of the problem on your Pontiac Grand Am. However, I would suggest taking your vehicle to a certified mechanic for a proper diagnosis before buying and having parts installed that may not (solve/be) the problem. For any further assistance, you may also call us at: 1-877-238-2623 or visit the nearest Advance Auto Parts store and one of our Parts Pros will gladly assist you with any questions or concerns you may have.Answered on 5/19/2013 by Vincent from AAP
Q:
Is the a remanufactured starter or a new one?Asked on 3/11/2013 by cj1 answer
CUSTOMER CARE
A:
This BWD Ignition Starter Switch - part# CS600 is a new one. For any further assistance please feel free to call us at: 1-877-238-2623 or visit the nearest Advance Auto Parts store and one of our Parts Pros will gladly assist you with any questions or concerns you may have.Answered on 3/11/2013 by Vincent from AAP
Q:
I had the dealer put a computer anaylist on my car 2000 Pontiac Grand AM and it said this could be the reason for the car just completely shutting down when going down the highway. Have you heard about such a thing before. Thanks RonAsked on 10/23/2012 by Ron from Garrettsville, Ohio1 answer
CUSTOMER CARE
A:
Symptoms of a Bad Ignition Switch: Vehicle Doesn't Start: Since the ignition switch is what prompts the engine to start, the surest symptom of a problematic ignition switch is when the vehicle is unable to start. If the car either does not start at all, or takes several tries to start, it may be the symptom of a faulty or bad ignition switch. However, this could also be a symptom of other problems, such as a fading battery. If the vehicle sputters and tries to come on but fails, or comes on only partially, it is most likely the battery. If the vehicle simply doesn't start at all, it is most likely the ignition switch. Headlights and Dashboard Lights Go On: If the headlights and dashboard lights go on but the vehicle doesn’t start, this is another clear sign of a bad ignition switch. Since it is the battery and not the ignition switch that turns on the headlights, if the engine won't turn on but the headlights and dashboard lights will, your problem is most likely caused by an ignition switch. Heating Up: Another symptom of a bad ignition switch occurs when the switch gets short circuited and heats up. If the switch is impossible to touch with the hands, it is a sign that the ignition switch is facing a problem rooted in the vehicle’s electrical and wiring system. The ignition switch is connected to a series of high-resistance wires. Any of the terminals connecting these can heat up. This results in arcing of the terminal(s), which further heats up to the extent that it melts the bakelite insulating base. From there, the wiring directly next to the ignition switch can heat up. When this happens, the vehicle jerks and doesn’t start despite repeated turning of the switch. For further assistance, please feel free to call us at 1-877-238-2623 or visit your nearest Advance Auto Parts store and one of our representatives would be more than happy to assist you.Answered on 10/24/2012 by Steve from AAP
Q:
Can this switch sometimes cause a itermediat blower problem?Asked on 12/11/2011 by Anonymous1 answer
CUSTOMER CARE
A:
I would suggest taking your vehicle to a certified mechanic for a proper diagnosis before buying and having parts installed that may not (solve/be) the problem.Answered on 12/12/2011 by Dennis from AAP
Q:
do this product come with the keyAsked on 9/9/2011 by Anonymous1 answer
CUSTOMER CARE
A:
No, it does not include the key.Answered on 9/10/2011 by DIY Daniel from AAP
Q:
Would the ignition switch cause me to lose power to power windows and power to climate control system? Fan and air conditioning does not work. Someone told me it was in my ignition switch.Asked on 7/11/2011 by Anonymous1 answer
CUSTOMER CARE
A:
Without the presence of your vehicle, we could not provide the exact solution. It is advisable to contact a certified mechanic to identify the exact problem and then we request you to contact us at 1-877-ADVANCE (238-2623) for replacing the exact defective part.Answered on 7/13/2011 by Start with Shane! from AAP
Q:
my key fit but when i turn it on none of the dash lights work it turns over dose not start 2003 malibu chevyAsked on 5/1/2011 by cats from bare oh1 answer
CUSTOMER CARE
A:
I would suggest taking your vehicle to a certified mechanic for a proper diagnosis before buying and having parts installed that may not (solve/be) the problem.Answered on 6/25/2011 by Steve from AAP
Q:
hi i bought a cylinder lock set with keys from advance auto and i put it in and worked fine. then the other day went to start the car and the ignition wont turn. could u tell me why and how i get the ignition switch out to put a new one in. i just bought last weekAsked on 2/21/2011 by shane from watsontown, PA1 answer
CUSTOMER CARE
A:
I would suggest taking your vehicle to a certified mechanic for a proper diagnosis before buying and having parts installed that may not (solve/be) the problem.Answered on 2/22/2011 by David the Dynamite Parts Guy from AAP
Q:
is this the ignition switch i need because the car wont start sometimes and the security light comes on when your going down the road wonder if the switch is not recognizing my key anymore.Asked on 2/11/2011 by shane from watsontown, PA1 answer
CUSTOMER CARE
A:
This could possibly be the problem. However, with out the presence of your vehicle we would not be able to properly diagnose it nor provide you with a 100% answer.Answered on 2/11/2011 by Parts Guru Geo from AAP
Q:
I went out to start my car this morn it turn over quite a few times and then it diied out i thought i needed a jump off so i got one when i did the car wouldnt turn over lights work radio works car just wont start wat could' tthat beAsked on 2/8/2011 by Tone1 answer
CUSTOMER CARE
A:
I would suggest taking your vehicle to a certified mechanic for a proper diagnosis before buying and having parts installed that may not (solve/be) the problem.Answered on 2/8/2011 by David the Dynamite Parts Guy from AAP
Displaying questions 1-10Previous | Next »
Disclaimer
We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact
Customer Care
if you have any questions or corrections.
