item(s) totaling $
See if this part fits a specific vehicle.
|This product doesnt fit any of your saved vehicles||Check Fit for another vehicle|
Do you have questions about this product?
Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.
Q:how do you bleed the slsve cyl
A:With reference to this Wagner Clutch Slave Cylinder - part# SC103471 for bleeding it, place the box end wrench over the bleeder valve on the clutch slave cylinder. The exact location of the cylinder will vary depending on the make and model of your vehicle. The cylinder will usually be a long cylindrical component with hard steel lines from the clutch master cylinder running through it. The valve itself looks like a small screw with a hole in the center of it sticking out of the side of the cylinder. Orient the wrench so that it fits snug over the nut at the base of the screw. Slide the clear plastic tubing over the end of the bleeder valve. Place the other end of the tubing into a catch pan or jar. Have an assistant press on the clutch and hold in down to the floor. The clutch pedal should remain pressed to the floor. Open the bleeder valve to release the pressure in the clutch fluid lines. Make sure that your assistant does not release the pedal pressure on the clutch. It needs to stay pressed onto the floor; otherwise, air will be drawn into the line. You will see fluid and air bubbles rushing out of the valve through the plastic tubing. Close the valve by turning it clockwise until it is tight. Repeat the steps until the lines have no more air in them. Check the clutch master cylinder reservoir levels periodically to ensure the clutch fluid does not drop below the lower or "min" line on the reservoir tank. For any further assistance, you may also visit your nearest Advance Auto store or call us directly at 1-877-ADVANCE (238-2623) and one of our representatives there would be more than happy to assist you.