item(s) totaling $
See if this part fits a specific vehicle.
|This product doesnt fit any of your saved vehicles||Check Fit for another vehicle|
|Ballast Resistor Included:||No|
|Coil Wire Attachment Type:||OE|
|Coil Wire Included:||No|
|Input Voltage:||12 v|
|Peak Current:||10 A|
|Primary Voltage:||12 v|
|Secondary Output Voltage:||8.3K v|
REVIEW SNAPSHOT®by PowerReviews
Reviewed by 1 customer
Displaying review 1
Comments about PerTronix D3001 Flame-Thrower HEI Coil GM 50,000 Volt Red/White Wire:
Purchased because my Accel coil was too large to clear my new air cleaner and this coil is stock sized. Nice looking and appeared well made. Easy to install. Car started right up and ran well for the first day. Went to start the car the next day with no luck. Plugged in a spark tester and only observed a single spark when cranking for 10 seconds. Tried two other plug wires with the same results. Popped in my old Accel and car started right up. Tested the Pertronix and found the primary side failed.