item(s) totaling $
|This product doesnt fit any of your saved vehicles||Check Fit for another vehicle|
REVIEW SNAPSHOT®by PowerReviews
Reviewed by 1 customer
Displaying review 1
Comments about Holley Carburetor Throttle Cable Bracket:
I'm using this with a Holley 390 Carb (8007) and the bracket was able to move quite a bit until I bent the little tab farther in. I'm still going to keep my eye on it as I suspect it will bend back out without much force so hopefully stepping on the gas isn't too much for it.
The one I got DID NOT come with any throttle return springs despite the description.
I was also surprised with how far away from the carb this holds the throttle cable, both back and out; I guess you could bend it to help with the alignment if needed.
The throttle cable I ordered was canceled so I ordered a slightly different style that uses a threaded shaft and nuts rather than the plastic clip this was designed for, because of this and the alignment mentioned earlier I drilled a hole to the side of the square opening and it is a good fit about half an inch closer.