Suspension Ball Joint
Hover over the image to zoom in
Suspension Ball Joint Suspension Ball Joint Suspension Ball Joint
Share this:

Driveworks Suspension Ball Joint

Part No. DW-K8647 Warranty Details  

See if this part fits a specific vehicle.

Check Vehicle Fit

Driveworks chassis parts help to eliminate front-end vibration, shimmy and unsafe handling. Driveworks chassis parts meet OE specifications, help ensure improved steering response and reduce tire wear.

Product Features:
  • Forged housing provides exceptional strength and durability
  • Oxidation film on the surface of the metal protects against corrosion
  • Phosphated ball stud provides a smooth, durable and wear-resistant surface to extend service life
  • Premium Polychloroprene rubber boots are fitted with grease relief valves to prevent contamination
Back To Top
Arm and Joint:No
Ball Joint Only:Yes
Bolt Quantity:3
Dust Seal:Yes
Greasable:Yes
Material:45#Steel:49=H 40Cr:37=H Others:14=H
Stem Thread Diameter:M14*1.5
Stem With Cotter Pin Hole:Yes

REVIEW SNAPSHOT®

by PowerReviews
DriveworksSuspension Ball Joint
 
3.5

(based on 2 reviews)

Ratings Distribution

  • 5 Stars

     

    (1)

  • 4 Stars

     

    (0)

  • 3 Stars

     

    (0)

  • 2 Stars

     

    (1)

  • 1 Stars

     

    (0)

Reviewed by 2 customers

Displaying reviews 1-2

Back to top

 
2.0

Stud too long for ABS CV axle

By 

from Rochester, NY

About Me Auto Enthusiast, Mechanic

Pros

  • Inexpensive
  • In Stock

Cons

  • Difficult To Install
  • Had To Grind Shorter
  • Hits Abs Ring
  • No Grease Fitting
  • Not Direct Replacement
  • Stud Too Long

Best Uses

  • Everyday Driving
  • Replacement

Comments about Driveworks Suspension Ball Joint:

This is NOT a direct replacement for a lower ball joint on a 1998-2002 Nissan Quest or Mercury Villager with ABS brakes. The stud with the castellated nut is too long by 3/8 inch and hits the ABS sensor ring on the CV axle. Had to grind the stud shorter for it to fit correctly on both sides of car. Probably would have fit non-ABS car just fine. And no grease fitting??? Really??? This is a good example of a Chinese sourced part that is close, but not correct. This was the only part stocked in my area, so I had no choice other than modifying the part so I could use the car the same day.

 
5.0

Not top quality perhaps, but works fine.

Comments about Driveworks Suspension Ball Joint:

Installed one two years ago, and no problems yet.

Displaying reviews 1-2

Back to top

Check out the specials in our monthly flyer.
 
 
Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.