Suspension Ball Joint
Hover over the image to zoom in
Suspension Ball Joint Suspension Ball Joint Suspension Ball Joint
Share this:

Driveworks Suspension Ball Joint

Part No. DW-K8194T Warranty Details  

See if this part fits a specific vehicle.

Check Vehicle Fit

Driveworks chassis parts help to eliminate front-end vibration, shimmy and unsafe handling. Driveworks chassis parts meet OE specifications, help ensure improved steering response and reduce tire wear.

Product Features:
  • Forged housing provides exceptional strength and durability
  • Oxidation film on the surface of the metal protects against corrosion
  • Phosphated ball stud provides a smooth, durable and wear-resistant surface to extend service life
  • Premium Polychloroprene rubber boots are fitted with grease relief valves to prevent contamination
Back To Top
Arm & Joint:No
Ball Joint Only:Yes
Castle Nut:Yes
Dust Seal:Yes
Location:Front Upper Ball Joint
Material:45#Steel:50=H 40Cr:40=H Others:10=H
Outside Diameter:44.55 mm
Replaceable Grease:Yes
Stem Thread Size:M18*1.5
Stem With Cotter Pin Hole:Yes


by PowerReviews
DriveworksSuspension Ball Joint

(based on 1 review)

Ratings Distribution

  • 5 Stars



  • 4 Stars



  • 3 Stars



  • 2 Stars



  • 1 Stars



Reviewed by 1 customer

Displaying review 1

Back to top

(2 of 4 customers found this review helpful)


WARNING: Does not fit Chevy truck!!


from Washington, PA

About Me Truck Enthusiast

See all my reviews

Helpful Reviewer



    • Incompatible

    Best Uses

      Comments about Driveworks Suspension Ball Joint:

      Please be advised before you purchase - this upper balljoint (K8194T) WILL NOT FIT a GM 10-bolt truck front axle. The grease fitting will conflict with the universal joint knuckle. You can use it only if you lose the grease fitting and plug the hole, which is obviously a bad idea...

      Also, this upper balljoint DOES NOT come with the threaded adjusters. A good replacement job should include replacing the adjusters.

      And one more thought, the corresponding lower balljoint for this part (K8195T) WILL NOT FIT either. The nut for the balljoint is too think and will conflict with the u-joint knuckle. There's no way to use this part on a GM 10-bolt front axle.

      Beware. Or keep your receipt handy.

      Comment on this reviewHelp Icon

      Check out the specials in our monthly flyer.
      Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.