item(s) totaling $
See if this part fits a specific vehicle.
|This product doesnt fit any of your saved vehicles||Check Fit for another vehicle|
REVIEW SNAPSHOT®by PowerReviews
Reviewed by 1 customer
Displaying review 1
Comments about Dorman - OE Solutions Repair Solution:
This product saved me a lot time and money That would have been associated with pulling the dash to replace the product. This product made it a whole lot easier and less time consuming.
Do you have questions about this product?
Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.
Q:1997 f-150 blend door, I under stand dorman make's a blend door that the metal drive gromit comes out to place the door into it position, than the gromit is put in place by pushing it into the drive hole at the bottom of the heater box assembly.
A:I will be happy to help Steve. Yes, Doorman has made it possible to change out the blend door without having to remove the whole dash. Here is a link for step by step instructions from the manufacturer http://www.dormanproducts.com/digitalassets/document/902-220_IS.PDF
A:Happy to answer your question Steve! This repair door would be installed how you described it a corner pin would be slid into a hole in the evaporator unit with a grommet then the other corner would be slid into a hole in the evaporator as well. Be sure to install with the foam insulator facing inward. You can put the key in the on position and check the function of it using the AC controls. Exercise extreme causation when dealing with the electrical connectors and watch your fingers near the door so you don't get them pinched.
Q:Am I reading this right? With this item, you DON'T have to pull the whole dash? How is that possible?
A:Hi William, good question! Yes, you don't have to pull the whole dash. Here are the instructions for this repair.