item(s) totaling $
See if this part fits a specific vehicle.
|This product doesnt fit any of your saved vehicles||Check Fit for another vehicle|
|Connector / Terminal Configuration:||Blade|
|Mounting Bolt Hole Quantity:||4|
|New Or Remanufactured:||Remanufactured|
|Washer Pump Included:||No|
Do you have questions about this product?
Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.
Q:How do you position the linkage to motor
A:With reference to your inquiry on the Cardone Wiper Motor - Remanufactured - part# 43-2026, ensure that the wipers are set to the ‘PARK’ position. Open hood. Remove wiper arm nut finish cap. Remove the wiper arm nut. To remove the wiper arm requires a special tool. Removing the wiper arm without a removal tool. Fold wiper arm to the service position (facing upward) gentle rock the arm on pivot shaft to remove. Remove the air inlet grille panel and hood seal. Fasteners are most often push-pin style. But, some models do use small trim bolts. Remove the bolts attaching the wiper module to the plenum. Carefully lift the wiper module out of the plenum. Disconnect the electrical connector from the wiper motor and the clip retaining the electrical harness to the wiper motor. Remove the wiper module assembly from the vehicle. Reverse removal procedure for installation. When installing the wiper arms, align the wiper arm onto the wiper module pivot shaft with wiper blade to the wiper dots/stops on the windshield. When job is complete inspect for proper operation. For any further assistance, please feel free to call us at: 1-877-238-2623 or visit the nearest Advance Auto Parts store and one of our Parts Pros will gladly assist you with any questions or concerns you may have.