item(s) totaling $
See if this part fits a specific vehicle.
|This product doesnt fit any of your saved vehicles||Check Fit for another vehicle|
|Dist/Coil End Boot Degree:||90 deg|
|Dist/Coil End Terminal Type:||Female|
|Insulation Outside Diameter:||7 mm|
|Length(s):||18, 20, 20, 24, 26, 29, 31, 31, 35 in|
|Mini Stripper Crimper Included:||No|
|Radio Noise Suppression:||Yes|
|Spark Plug End Boot Degree:||180 deg|
|Spark Plug End Boot Material:||Silicone Boot|
|Spark Plug End Terminal Type:||Female|
|Wire Separators Included:||No|
REVIEW SNAPSHOT®by PowerReviews
Reviewed by 1 customer
Displaying review 1
Comments about CARQUEST Premium Spark Plug Wire Set:
This was called an exact fit for a 1994 B250 Dodge Van. The coil wire was 4" to short to fit around behind the passenger side valve cover, as the older one did that I had removed. So I ended up running it over the valve cover back end to make the contact to distributor cap. I hope the corrugated plastic cover on the coil wire is enough to protect this wire.
The passenger side bank (right) side were a tight fit in length to where they could of been a minimum 1/2" to 1" longer.
I had no problems with the drivers side bank (left) side with the plug wires length cause the distributor is off set to this side some.
All plug wires have the corrugated plastic cover on them but do not run the wires total length. This corrugated plastic cover requires you to cut it at the plug wire keepers to connect them up and secure from the exhaust manifolds.
Lube was only inside of the wires boots at the spark plug wire ends.