item(s) totaling $
See if this part fits a specific vehicle.
|This product doesnt fit any of your saved vehicles||Check Fit for another vehicle|
|Insulation Outside Diameter:||8 mm|
|Mini Stripper Crimper Included:||No|
|Radio Noise Suppression:||Yes|
|Spark Plug Boot Material:||Silicone Boot|
|Spark Plug End Boot Degree:||115 deg|
|Spark Plug End Terminal Type:||Female|
|Wire Separators Included:||No|
REVIEW SNAPSHOT®by PowerReviews
Reviewed by 1 customer
Displaying review 1
Comments about CARQUEST Premium Spark Plug Wire Set:
Installed these wires on my wife's 94 Mercury Sable. The original wires finallybegan to break down after 190,000 miles. The new AutoLite wires fit like the original and were the right length. Her car now starts much easier than before. She only drives about 25 miles a week, but when she needs the car, it needs to be ready. Now it is.
Do you have questions about this product?
Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.
Q:Your specs list 10 wires in this set. My engine is a 3.0L V6, what are the 3 extra wires for?
A:Kindly follow the instructions to replacing the Autolite Professional Series Ignition Wire Set - Part No. 96172 : Spread the new wires out flat and arrange them from the longest to the shortest length. On GM car models using retainer wire retainer rings, lift off the distributor wire with boot retainer. Wires will come off distributor with retainer. Remove wires one at a time from retainer ring and put them back in the exact distributor tower from which each was removed. Remove the longest spark plug wire from the vehicle first. Grasp boot, NOT wire. Twist slightly to break seal, then lift straight up with a steady even pull. Select the longest spark plug wire from the new Autolite® wire set. Be careful to distinguish the spark plug boot from the distributor nipple. Route the new spark plug wire through the same path as the old wire. All original equipment looms, retainers and heat shields should be re-used unless new components are included in the wire set. Grasp the spark plug boot. Firmly push terminal and boot over spark plug until securely engaged. Push other end of new spark plug wire onto distributor cap until firmly seated. If complete connection is not obtained, lift side wall of boot or nipple to release trapped air pressure and allow proper connection. For any further assistance please feel free to call us at: 1-877-238-2623 or visit the nearest Advance Auto Parts store and one of our Parts Pros will gladly assist you with any questions or concerns you may have.