item(s) totaling $
See if this part fits a specific vehicle.
|This product doesnt fit any of your saved vehicles||Check Fit for another vehicle|
|Gasket Or Seal Included:||N|
|GPH (Free Flow) Rating:||12 gph|
|Maximum Flow Rating:||12 @ 1800 RPM gph|
|Maximum Pressure:||6.5 PSI|
|Minimum Pressure Reading:||5|
|Pressure Rating:||5 - 6.5 PSI|
Do you have questions about this product?
Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.
Q:I've never seen that straight stud on 80's GM, just the lever type off the back of the pump. Do you grease that joint? Secondly if you please, is that outer shell of the piston threaded into the block, or does it slip right out? It's a 1984 Buick Skylark Thank You!
A:Glad to assist, Jaymz! I checked the application and this is correct for a 1984 Buick Skylark 2.8l. You will grease the joint at the end of the rod. The body of the pump is held on by two bolts and then should just remove from the block.