item(s) totaling $
See if this part fits a specific vehicle.
|This product doesnt fit any of your saved vehicles||Check Fit for another vehicle|
|Rust Resistant Coating:||Yes|
REVIEW SNAPSHOT®by PowerReviews
Reviewed by 1 customer
Displaying review 1
Comments about Beck/Arnley Premium Brake Rotor:
Needed National front wheel bearing install so I did rotor (and Moog lower ball joint) at same time. Rotor needed to be grinded. Need to use "small" 3 inch diameter or so air power hand grinder tool to fit. It grinds off pretty easy. I also tried putting this same rotor on original honda wheel bearing and it did not fit. grinding added 25 mins to install time. I cannot explain high cost for inferior tolerances. Used silverstar brake pads. I use two 10mm by 1.5mm by 60mm long bolts from [@] to pound out wheel bearing (175k mile) out. It came out really easy this way.Note: all part mention are made in china. Also get new studs. I used the dorman, they work fine. Get the lug nuts at this time, my store only has 3.